基于定向纳米碳管气体放电的气敏传感器研究

介绍了一种基于定向纳米碳管的气敏传感器,以生长定向纳米碳管的氧化铝模板作为阳极,铝板作为阴极,利用纳米碳管的尖端发射效应,在较低的电压下使气体产生放电现象。通过对纳米碳管在气体中击穿电压和放电电流的测量,实现对气体的定性定量检测。同时纳米碳管气敏传感器还具有体积小、灵敏度高、稳定性好、响应速度快、在常温常压下即可进行检测等优点,具有较好的应用前景。     

Model of the Negative DC Corona Plasma: Comparison to the Positive DC Corona Plasma

A numerical model of the negative DC corona plasma along a thin wire in dry air is presented. The electron number density and electric field are determined from solution of the one-dimensional coupled continuity equations of charge carriers and Maxwell's equation. The electron kinetic energy distribution is determined from the spatially homogeneous Boltzmann equation. A parametric study is conducted to examine the effects of linear current density (0.1–100 A per cm of wire length), wire radius (10–1000 m), and air temperature (293–800 K) on the distribution of electrons and the Townsend second ionization coefficient. The results are compared to those previously determined for the positive corona discharge. In the negative corona, energetic electrons are present beyond the ionization boundary and the number of electrons is an order of magnitude greater than in the positive corona. The number of electrons increases with increasing gas temperature. The electron energy distribution does not depend on discharge polarity.     

Decomposition of Gaseous Sulfide Compounds in Air by Pulsed Corona Discharge

The effectiveness of applying a pulsed corona discharge to the destruction of olfactory pollution in air was investigated. This paper presents a comparative study of the decomposition of three representative sulfide compounds in diluted concentrations: hydrogen sulfide (H₂S), dimethyl sulfide (DMS), and ethanethiol (C₂H₅SH), which could be completely removed when a sufficient but reasonable energy density was deposited in the gas. DMS showed the lowest energy cost (around 30 eV/molecules); C₂H₅SH and H₂S had an EC of respectively 45 eV and 115 eV. The efficiency of the non-thermal plasma process increased with decreasing the initial concentration of sulfide compounds, while the energy yield remained almost unchanged. SO₂ was the only identified byproduct of H₂S decomposition, but the sulfur balance suggests the formation of undetected SO₃. The byproducts analyzed during the degradation of DMS and C₂H₅SH enabled to propose a reaction mechanism, starting with radical attack and breaking of C–S bonds.     

Plasma-Chemical Conversion of Lower Alkanes with Stimulated Condensation of Incomplete Oxidation Products

Oxidative conversion of a mixture of natural gas and oxygen in a barrier-discharge plasma-chemical reaction was investigated experimentally. The process was conducted at atmospheric pressure and room temperature. The discharge was initiated by high-voltage pulses of 50–100 s duration at a repetition frequency of up to 2 kHz. The principal feature of the process was that in the plasma-chemical reactor conditions were created which stimulated the condensation of the products of incomplete oxidation of methane that resulted in the formation of aerosol even from nonsaturated vapor. The removal of intermediate reagents from the gaseous phases into the aerosol prevented them from further oxidation. Depending on the experimental conditions, the mass percentage of the components of the condensate formed varied within the following limits: formic acid from 20 to 40%, methanol from 8 to 15%, methylformate from 4 to 8%, and water from 40 to 60%. The conversion process has been realized on a laboratory setup of average power up to 1 kW. In the single-pass mode, a 57% degree of conversion of the mixture has been achieved. The energy value of the condensate is 15–20 kWh/kg.     

Novel Catalytic Dielectric Barrier Discharge Reactor for Gas-Phase Abatement of Isopropanol

Catalytic gas-phase abatement of air containing 250 ppm of isopropanol (IPA) was carried out with a novel dielectric barrier discharge (DBD) reactor with the inner catalytic electrode made of sintered metal fibers (SMF). The optimization of the reactor performance was carried out by varying the voltage from 12.5 to 22.5 kV and the frequency in the range 200–275 Hz. The performance was significantly improved by modifying SMF with Mn and Co oxide. Under the experimental conditions used, the MnO _x /SMF showed a higher activity towards total oxidation of IPA as compared to CoO _x /SMF and SMF electrodes. The complete destruction of 250 ppm of IPA was attained with a specific input energy of ∼235 J/L using the MnO _x /SMF catalytic electrode, whereas, the total oxidation was achieved at 760 J/L. The better performance of the MnO _x /SMF compared to other catalytic electrodes suggests the formation of short-lived active species on its surface by the in-situ decomposition of ozone.     

Experimental and Theoretical Studies of a Pulsed Microwave Excited Ar/CF4 Plasma

The present work deals with a pulsed microwave discharge in an Ar/CF ₄ gas mixture under a low pressure (1–10 mbar). The discharge chamber developed has a cylindrical geometry with a coupling window alternatively made of quartz or alumina. The setup allows one to investigate the plasma–wall interactions (here etching of the quartz window) and the ignition process of the pulsed microwave plasma. Microwave pulses with a duration of 50–200 s and repetition rate between 1 and 10 kHz are typical for the experiments. The space-time behavior of the fluorine number density in the discharge has been investigated experimentally by optical actinometry. The discharge kinetics is modeled using electron-transport parameters and rate coefficients derived from solutions of the Boltzmann equation. Together with the solution of the continuity and electron balance equations and the rate equations describing the production of CF _x (x=2, 3, 4) radicals and F atoms, a good agreement between experimental and theoretical data can be achieved.     

Dynamic release process of pollutants during suspended sediment transport in aquatic system

Pollutants release is highly consistent with suspended sediment concentration （SSC） in water column, especially during re-suspension and transport events. The present research focuses on pollutant dynamic release from re-suspended sediment, especially the vertical distribution relationship between them. The sediment erosion experiments on a series of uniform flow are conducted in a circulate flume. Reactive tracer （phosphorus） is used as the contaminant in fine-grained sediments to identify the release characteristic length and time. Experimental results show that the flow condition near-bed depends on the sediment surface roughness. The region with high turbulent intensities corresponds to a high concentration sediment layer. In addition, the SSC decreases with the distance, water depth, and particle grain size. The sediment in a smaller grain size takes much more time to reach equilibrium concentration. Total phosphorus （TP） concentration changes along the water depth as SSC in the initial re-suspension stage, appearing in two obvious concentration regimes： the upper low-concentration layer and the high-concentration near-bottom layer. This layered phenomenon remains for about 3 hours until SSC distri- bution tends to be uniform. Longitudinal desorption plays an important role in long-way transport to reduce the amount of suspended sediment in water column.     

Erosion of Thin Foils by Sputtering in Hollow Cathodes

A thin copper foil placed diagonally in a cylindrical copper hollow cathode undergoes fast erosion caused by cathode sputtering. Changes in the foil shape are related to current distribution along the hollow cathode axis. The experimental results aid in understanding the increase in spectral lines intensities emitted from conical bottom hollow cathode lamps.     

Ranking Oxidant Sensitiveness: A Guide for Synthetic Utility

Common oxidants used in chemical synthesis, including newly developed perruthenates, were evaluated in the context of understanding (and better appreciating) the sensitiveness and associated potential hazards of these reagents. Analysis using sealed cell differential scanning calorimetry (scDSC) facilitated Yoshida correlations, which were compared to impact sensitiveness and electrostatic discharge experiments (ESD), that enabled sensitiveness ranking. Methyltriphenylphoshonium perruthenate (MTP3, 8 ), isoamyltriphenylphosphonium perruthenate (ATP3, 7 ) and tetraphenylphosphonium perruthenate (TP3, 9 ) were found to be the most sensitive followed by 2-iodoxybenzoic acid (IBX, 2 ) and benzoyl peroxide (BPO, 10 ), whereas the most benign were observed to be Oxone ( 12 ), manganese dioxide (MnO₂, 13 ), and N-bromosuccinimide (NBS, 17 ).     

Effect of corona discharge on cadmium sulphide and lead sulphide films

This paper describes the effect of corona discharge on cadmium sulphide (CdS) and lead sulphide (PbS) films prepared using the chemical route. The property of films before and after exposure to corona has been described in detail. The electronic properties of the CdS and PbS films have been studied by current-voltage (I-V), capacitance-voltage (C-V) measurements. The structural properties and surface morphology were studied by using X-ray diffraction and scanning electron microscopy before and after exposing to Corona discharge. The films displayed the change in surface morphology after exposure to the corona discharge. It has been found that the films showed an increase in resistivity after exposure. This change in property has been attributed to modification in surface states. Time-dependent recovery indicated that room temperature annealing is sufficient to regain the normal resistivity of the films. The experiment was carried with the aim of studying the effect of the interaction of corona discharge on the semiconductor films and its subsequent effects.