Laser-Induced Fluorescence (LIF) Probe for <Emphasis Type="Italic">In-situ</Emphasis> Nitric Oxide Concentration Measurement in a Non-thermal Pulsed Corona Discharge Plasma Reactor

Laser-induced fluorescence (LIF) is an effective in-situ probe for NO concentrations below 300 ppm in a non-thermal plasma reactor. A new method has been developed to measure in-situ NO concentration in the reactor discharge region using a long-time—on the order of seconds—averaged fluorescence detection. This method, for quantifying NO concentration in a nonthermal plasma reactor, is simpler than a short-time—on the order of nanoseconds—fluorescence detection. For accurate measurement based on the new method, the LIF intensity must be close to the corona-induced fluorescence (CIF) intensity; the CIF intensity serves as a guide in selecting the LIF intensity. We find that a kinetic model proposed earlier works for two-tube reactors and represents the NO concentration in the middle of the reactor, which verifies the assumption of gas plug flow.     

Effects of Oxygen and Water Vapor on Volatile Organic Compounds Decomposition Using Gliding Arc Gas Discharge

The combined effects of oxygen and water vapor on three typical volatile organic compounds, i.e. tetrachloromethane, n-butane and toluene, decomposition efficiency under gliding arc gas discharge conditions are studied. The electron density and the density of the reactive radicals such as O and OH are modified by addition of oxygen and water vapor. Consequently, the decomposition process can be enhanced or suppressed, depending on the involved chemical structures and reaction channels. The addition of oxygen and water vapor suppresses the tetrachloromethane decomposition which indicates that this process is mainly controlled by the electron dissociation reactions. By contrast, the n-butane and toluene decompositions are enhanced, which shows that they can be mainly ascribed to the radical induced reactions. Especially, in a moist atmosphere the OH radicals are supposed to play the most important role in the n-butane decomposition process.     

晶态氮化碳薄膜的低温合成

The synthesis of carbon nitride films at low temperature has been investigated using pulsed arc discharge from methanol solution with nitrogen atmosphere. Raman spectra and X-ray diffraction (XRD) analysis suggest that crystalline carbon nitride films may be prepared at low substrate temperature (220 ℃). At same time, the substrate temperature has a significantly effect on the nitrogen content and structure of the films. Increasing substrate temperature (300 ℃) would decrease the content of nitrogen in the films and result in a formation of carbon films.     

锂离子电池负极合金CoSn和Cu-Sn的制备与表征

CoSn alloy and Cu-Sn samples were synthesized by H₂-reduction following solid-state reaction between Co(Ⅱ)， Cu(Ⅱ)， Sn(Ⅳ) and NaOH at ambient temperature. The samples were characterized by XRD， SEM. The results showed that CoSn alloy (80～200nm) is globe-shaped， ultrafine hexagonal material， and Cu-Sn alloy powder consists of two phases， i.e. Cu₆Sn₅ and Cu₃Sn. Cu-Sn powder has spherical morphology and the particle size is estimated to be 60～70nm. The electrochemical performances of CoSn alloy and Cu-Sn powder were studied using lithium-ions model cell Li/LiPF₆ (EC+DMC)/CoSn (or Cu-Sn). It was demonstrated the reversible discharge capacities for 10 cycles keep above 280mAh·g^-1 for nanophase Cu-Sn， and 60mAh·g^-1 for CoSn alloy. Differ-ential capacity plots showed that the reaction mechanisms of Cu-Sn with lithium were reversible.     

Degradation of 4-Chlorophenol using a Gas–Liquid Gliding Arc Discharge Plasma Reactor

The gas–liquid gliding arc discharge plasma is used directly to study degradation and dechlorination of 4-Chlorophenol (4-CP) in solution. The typical AC waveforms of discharge voltage and current revealed that the discharge behavior was not definitely periodic. The chemical oxygen demand (COD) abatement of 4-CP solution with stainless steel electrode is higher than that with aluminum or brass electrode; When air was used as carrier gas the COD abated from 1,679.2 to 190 mg/L (i.e., 88.68% abatement) after 76 min plasma treatment; Increasing gas–liquid mixing rate could also increase the degradation of 4-CP; adding appropriate amounts of Fe²⁺ or iron chips to the solution were found to be favorable for 4-CP degradation. The main intermediates of 4-CP degradation are p-benzoquinone, hydroquinone, 4-chlorocatechol, p-chloronitrobenzene, and ring cleavage products (acetic acid, glycol, propanone, and others). Furthermore, possible pathways of 4-CP degradation in solution are proposed.     

HGZ－Ⅱ型自动辉光放电光源的研制

在仔细研辉光放电光源工作过程的基础上，在国内首先设计、制成了ＨＧＺ－Ⅱ型自动辉光放电光源。该光源除换样品外，实现了抽空、进气、对光、预燃、曝光、充气、复位等摄谱全过程的自动控制。有水压、真空度、短路保护措施和醒铃线路。设计合理，性能良好，操作简便，工作安全，可靠。程控部分的编排包括顺序控制。时序控制和条件控制。由于使用了通用执行元、器件，降低了成本，提高了耐用性。为满足表层，逐层分析的需要，还专门设计了计数电路。供电源实现了高压直流供电和脉冲供电。该光源可应用于合金中主成分和少量杂质分析及金属、合金表层，逐层成分分析。     

TS和PTS单晶体的热刺激电流

测定了双(对甲基磺酸)2,4-己二炔-1,6-二醇酯(TS)及其不同聚合程度TS-PTS混合体和完全聚合的聚合物PTS在100-300K温度范围内的热刺激电流。在沿分子堆砌方向上(对PTS则是大分子链方向)上观察到了它们的热刺激电流,并在相应于它们相变152K和192K处呈现热刺激电流峰。研究了聚合程度对相变的影响,绘制了TS-PTS体系的相图。对另三个热刺激电流峰的归属作了定性解释。     

Ultra trace analysis of refractory metals by solid state mass spectrometry — A comparison of GDMS,SSMS and SIMS

The analytical performance of a glow discharge quadrupole mass spectrometer is demonstrated using sintered tungsten as an example. The inherent problem of molecular interferences in glow discharge mass Spectrometry has been considerably reduced using neon as a complementing discharge gas. Particular attention has been paid to time dependences. Analytical figures of merit are presented.     

Electrochemical characterization of negative electrodes consisting of surface-modified Zr0.9Ti0.1(Ni1.1Co0.1Mn0.5V0.2Cr0.1)x Laves-phase alloys

Laves-phase hydrogen storage alloy has a high potential for use as negative electrode material as alternative for the misch-metal-based material. In order to improve the energy density and the rate capability of negative electrode, chemical and mechanical modification of Lavesphase alloy with different stoichiometric ratios was carried out. Discharge capacity and high-rate dischargeabilty was evaluated by electrochemical methods and the characterization of Laves-phase alloy was made by X-ray diffraction, SEM observation and PCT measurement. The best result in discharge capacity could be obtained for stoichiometric Laves-phase alloy with a composition of Zr_0.9Ti_0.1Ni_1.1Co_0.1Mn_0.5V_0.2Cr_0.1 by boiling in 10 M KOH solution. On the other hand, the high-rate dischargeability was increased remarkably by introducing mechanical grinding before alkali treatment. The cause for improved performance was discussed on the basis of thermodynamic stability of metal hydride and changes in crystal structure and surface morphology influencing on diffusion coefficient and diffusion path length of hydrogen.     

Electrolytic Co3O4 for thin-layer anodes of lithium-ion batteries

Electrolytic (e) cobalt oxide of a spinel structure, e-Co₃O₄, is obtained from the sulfate and nitrate (aqueous, water-alcohol) solutions containing Co²⁺ with the aim of using it in thin-layer anodes of lithium-ion batteries. The physicochemical and structural properties of the synthesized compounds are examined using thermal and x-ray diffraction analyses, absorption IR spectroscopy, and atomic force microscopy. The electrochemical characteristics of e-Co₃O₄ are determined in breadboards of lithium power sources and in the lithiumion system LiCoO₂/e-Co₃O₄.