Er3+掺杂Li2O-SrO-ZnO-Bi2O3玻璃中Er3+离子在1.53 μm处的荧光发射特性

采用传统的熔融法制备了Er~(3+)掺杂的新型铋酸盐玻璃(Li_2O-SrO-ZnO-Bi_2O_3,LSZB),并对其光谱性质进行了表征,分析了玻璃的拉曼光谱、吸收光谱、荧光光谱,利用Judd-Ofelt理论研究了其荧光特性。LSZB玻璃样品中Er~(3+)的~4I_(13/2)→~4I_(15/2)跃迁发射峰位于1.53 μm处,半高宽约为78 nm。样品中Er~(3+)的~4I_(13/2)能级寿命为2.848 ms,量子效率为99.93%,受激发射截面达到9.76×10~(-21)cm~2。以上结果显示,Er~(3+)掺杂LSZB玻璃有良好的光谱特性。     

Electrorheological Moment Amplifier

An electrorheological moment amplifier is developed and its work principle and structure characteristics are explained. Then, we research the effects of structural parameters on performance of mechanism and present optimization design methods and control methods. With a view of enhancing the amplification coefficient or increasing the speed of dynamic response, the expectation values of objectives and the weight are obtained and the amplifier with good performance could be designed. In this paper, the parabolic relation between moment amplified and electric field is decided by experimental fit method. And step and pulse electric field signals are used to study the dynamical properties of the device. As the result of experiments, it is confirmed that the electrorheological moment amplifier has good dynamic performance through optimization design methods.     

分布式拉曼光纤放大器动态增益控制研究

介绍了动态增益控制的必要性，对动态拉曼传输方程进行了简化，并将其以矩阵形式表示，从而减少了方程的数量，提高了计算速度。由拉曼传输耦合方程推出一种适用于分布式拉曼放大器实时控制的自动控制算法。考虑工程需要，该算法忽略了噪声功率、泵浦间的受激拉曼效应，以及信号和泵浦间受激拉曼效应对泵浦功率的损耗。结果表明该算法能够达到快速抑制输入信号功率突变引起的输出功率／增益波动的目的。     

Er3+-doped phosphor-tellurite glass for broadband short-length Er3+-doped fiber amplifier

ErS+-doped phosphor-tellurite glass for broadband short-length Er3+-doped fiber amplifier (EDFA) is fabricated and characterized. The differential value (△T) of onset crystalline temperature (Tx) and glass transition temperature (Ts) is 206°C.     

8 mm二次谐波回旋速调管放大器双阳极磁控注入电子枪的设计

 计算了8 mm二次谐波回旋速调管双阳极电子枪的设计参数，根据这些参数，采用EGUN软件进行模拟和优化，设计出了一只双阳极磁控注入电子枪，该枪的电子束纵横速度比为1.45，速度零散为5.4%，并讨论了电极形状、磁场分布、电流、控制极电压和第二阳极电压对电子注性能的影响，结果发现电子注对这些影响因子非常敏感，设计中应对它们进行充分优化。     

二极管泵浦Nd:YAG棒双通放大器技术

二极管泵浦NdYAG棒双通放大器采用两个峰值功率6.5 kW激光泵浦模块作为泵浦源.每个激光泵浦模块由81个二极管激光器组成,NdYAG棒直径为6 mm,Nd掺杂质量分数1%.在两个封装方式和结构一致的激光泵浦模块之间采用光学像传递和插入90°石英旋转片进行退偏补偿.在重复频率400 Hz,谐振腔输出单脉冲能量6 mJ时,双通输出400 mJ,激光器光-光转换效率为12.3%,光束质量4.6,脉宽15 ns.     

Noise performance analysis of bi-directionally pumped distributed fiber Raman amplifiers with consideration of fiber nonlinearity and its impact on EDFA output OSNR

Under small-signal assumption, equivalent noise figure normalized by fiber nonlinearities (NENF) of bi-directionally pumped distributed fiber Raman amplifiers (BiDFRA) is derived. Amplified spontaneous Raman scattering noise and double Rayleigh scattering noise are both included. The relation between NENF and Raman gain, forward Raman gain percentage is investigated under different polarization factor and Rayleigh scattering coefficient. It agrees well with numerical simulation results. Based on the analytical expression, the optical signal-to-nose ratio (OSNR) improvement of hybrid pre-BiDFRA/erbium-doped fiber amplifier (EDFA) compared with sole EDFA is studied. It is shown that there is an optimum Raman gain and forward Raman gain percentage to maximize the OSNR improvement. Finally, some guidelines on BiDFRA design are proposed.     

Calculation of the Electron Efficiency for a Two-Cavity Gyroklystron Amplifier by Using a Self-Consistent Code

The beam-wave interaction in a Ka-band, two-cavity fundamental gyroklystron amplifier is studied by using a self-consistent nonlinear simulation code. The electron efficiency for this gyroklystron amplifier is calculated, and the effect of various parameters, such as beam voltage, beam current, electron guiding center radius, velocity pitch ratio and drift tube length on the electron efficiency is discussed in detail.     

直接扣除法测量半导体光放大器频率响应

在光电子器件散射参量定义的基础上建立了基于直接扣除法的半导体光放大器频率响应测量系统,测量中通过扣除激光器和探测器系统的频率响应,得到放大器固有的频率响应。对InGaAsP体材料行波腔半导体光放大器样品进行了测量,得到了放大器在不同注入光功率和不同偏置电流下的频率响应曲线。这些曲线很好地反应了半导体光放大器的增益饱和和噪声特性,进一步分析发现半导体光放大器对低频调制信号的放大能力弱于对高频信号的放大能力,分析认为其原因在于半导体光放大器的载流子寿命有限导致低频信号长时间消耗载流子时,载流子数量无法及时恢复,从而使得增益降低。     

Parameters to Define the Electron Beam Trajectory of a Double-Tapered Disc-Loaded Wideband Gyro-TWT in Profiled Magnetic Field

In the method of tapering the cross section of the interaction structure for broadbanding a gyro-TWT, the different portions of the interaction length of the tapered-cross-section waveguide become effective for different frequency ranges if the magnetic field and beam parameters are profiled to maintain the condition of electron cyclotron resonance throughout the interaction length. In the present paper, the study of profiling the magnetic field and beam parameters in steps of the stepped analytical model of a double-tapered disc-loaded circular waveguide was made throughout the steps of the model. In the observed profile, the magnetic flux density in a typical step relative to its value in first-step decreases from first-step (gun-end) to end-step (collector-end) of the model considering the up-tapering schemes, in which structure parameters increase from gun-end to collector-end. Also, the transverse beam velocity in a typical step relative to its value in first-step decreases from gun-end to collector-end. However, the Larmor radius in a typical step relative to its value in first-step as well as the hollow-beam radius in a typical step relative to its value in first-step, both increase from gun-end to collector-end in the model considering the up-tapering schemes.