镜面偏心测量光学系统设计及其杂光分析

为了解决现有镜面偏心测量设备存在的问题,本文研究了一种采用切换镜头和调焦相结合的方法来设计的镜面偏心测量光学系统,使用这个光学系统,既能使被测镜面的曲率半径扩展到-∞~+∞范围,又能保证测量精度。通过Lighttools软件对这个光学系统进行光线追迹,分析其杂光分布,结果表明:准直镜头内部多次反射产生的杂光强度很低,可以忽略。而当被测镜头中存在相邻球心像距的镜面时,产生的杂光强度比较大,在后续的图像处理过程中,必须增强目标图像的对比度。利用研制的镜面偏心测量设备进行测量实验,结果进一步验证了杂光分析的正确性。     

车用塑料耐刮擦测试方法概述

耐刮擦测试是汽车内外饰塑料零件质量控制的一项重要指标。介绍了耐刮擦测试原理,刮擦头、负载、样品与刮擦头相对运动状态等是决定测试方法的关键技术要素,评价塑料耐刮擦性的方法分为目视法及仪器测量法。综述了五指刮擦法、硬度试验笔刮擦法、网格刮擦法、摩擦色牢度刮擦法及其他刮擦法测试方法,分析和总结了不同测试方法的特点和应用范围。     

对新时期分析测试中心定位的思考

就如何理解和看待新时期分析测试中心的定位和发展,如何解决分析测试中心在结构和管理上存在的固有问题提出了粗略的观点.希望对分析测试中心的发展起到抛砖引玉的作用.     

Characterization of tension set behavior of a silicone rubber at different loads and temperatures via digital image correlation

This work aims to determine the tensile set behavior of a silicone rubber under different stress magnitudes and temperatures through digital image correlation implemented in an improved creep experimental set-up. Creep-recovery strains were measured with time at 20, 40 and 60 °C under tensile strengths of 98.1, 196.2 and 394.3 kPa, respectively. The behavior of creep and recovery strain with time at the different stress magnitudes and temperatures was successfully obtained by the experiments. The corresponding elastic and viscous components of the material for each condition were determined from the results. Overall, all obtained creep behaviors matched with the behavior of a four-element model of creep-recovery. The increase of temperature generated an increase of creep compliance at the three loads, but the increase of tensile load produced a decrease of creep compliance for the three temperatures. The strain was not recovered entirely in any case for the test time stated.     

Comparison of low-velocity impact damage in thermoplastic and thermoset composites by non-destructive three-dimensional X-ray microscope

This paper presents a method for the non-destructive inspection and quantitative comparison of low-velocity impact damage in thermoplastic and thermoset composites. X-ray microscope (XRM) computed tomography is used to analyse the three-dimensional internal damage in carbon fibre/poly-ether-ether-ketone (AS4/PEEK) and carbon fibre/epoxy (CCF300/Epoxy) laminates. With the materials and testing conditions used, it was shown that thermoplastic composites have better interlaminar and intralaminar properties, and the following quantitative conclusions were drawn. Under the same impact energy, the maximum contact force of AS4/PEEK laminate was approximately twice that of CCF300/Epoxy laminate. Dissection of the reconstructed XRM volume along a characteristic slicing surface showed that AS4/PEEK had less internal damage than CCF300/epoxy. When the impact energy was 15 J, the XRM results showed that the sum of delamination areas between each ply in AS4/PEEK was only 9% of that in CCF300/Epoxy, whereas the ultrasonic C-scan results showed that the total delamination area of AS4/PEEK was 54.78% of that of CCF300/Epoxy.     

Noninvasive prenatal paternity testing by maternal plasma DNA sequencing in twin pregnancies

SNPs, combined with massively parallel sequencing technology, have proven applicability in noninvasive prenatal paternity testing (NIPPT) for singleton pregnancies in our previous research, using circulating cell-free DNA in maternal plasma. However, the feasibility of NIPPT in twin pregnancies has remained uncertain. As a pilot study, we developed a practical method to noninvasively determine the paternity of twin pregnancies by maternal plasma DNA sequencing based on a massively parallel sequencing platform. Blood samples were collected from 15 pregnant women (twin pregnancies at 9–18 weeks of gestation). Parental DNA and maternal plasma cell-free DNA were analyzed with custom-designed probes covering 5226 polymorphic SNP loci. A mathematical model for data interpretation was established, including the zygosity determination and paternity index calculations. Each plasma sample was independently tested against the alleged father and 90 unrelated males. As a result, the zygosity in each twin case was correctly determined, prior to paternity analysis. Further, the correct biological father was successfully identified, and the paternity of all 90 unrelated males was excluded in each case. Our study demonstrates that NIPPT can be performed for twin pregnancies. This finding may contribute to development in NIPPT and diagnosis of certain genetic diseases.     

Anisotropic compressive behavior of rigid PVC foam at strain rates up to 200 s−1

The elevated strain rate compressive response of closed-cell polyvinyl chloride (PVC) foam at various densities is investigated. Two loading directions, (i.e., parallel and perpendicular to foam rise direction) were considered to investigate structural anisotropy. The elevated strain rates tests (up to 200 s⁻¹) were performed using a customized drop tower device. Engineering stress/strain behavior, energy dissipation, and maximum stress capacity were obtained for each density and compared against each other. Except for the lowest density of 45 kg/m³, strain rate effects were clearly observed through increased compressive strength and plateau stress when loading in the foam rise direction. The strain rate effect is more evident at higher densities. However, no significant strain rate effect was observed when loading perpendicular to the foam rise direction. Scanning electron microscopy (SEM) analysis showed that plastic hinges are the primary deformation mechanism for PVC foam cells. An analytical model has been calibrated using the experimental results and successfully predicted the mechanical response of the foam. Shape anisotropy has been measured employing the SEM images. The analytical approach was also able to predict the foam's anisotropic mechanical response.     

Adaptive nematic liquid crystal lens array with resistive layer

ABSTRACT

We propose an adaptive nematic liquid crystal (LC) lens array using a dielectric layer with low dielectric constant as resistive layer. With the resistive layer and periodic-arranged iridium tin oxide (ITO) electrodes, the vertical electric field across the LC layer varies linearly over the lens aperture is obtained in the voltage-on state. As a result, a centrosymmetric gradient refractive index profile within the LC layer is generated, which causes the focusing behaviour. As a result of the optimisation, a thin cell gap which greatly reduces the switching time of the LC lens array can be achieved in our design. The main advantages of the proposed LC lens array are in the comparatively low operating voltage, the flat substrate surface, the simple electrodes, and the uniform LC cell gap. The simulation results show that the focal length of the LC lens array can be tuned continuously from infinity to 3.99 mm by changing the applied voltage.     

转换屏发光光谱对闪光照相成像质量影响研究

转换屏的X射线激发发光光谱与透镜系统的匹配偏差会对闪光照相光电接收系统的成像质量造成影响.提出了一种一维线阵全分辨的模拟计算方法,对在理想光源照射下系统成像视觉全分辨能力进行了模拟计算.用白光光源加滤波片照明分辨率板的实验方法,对不同光源照射下系统的成像质量进行了评估.分析表明,转换屏发光宽光谱及其中心波长与透镜系统不匹配均对成像分辨率造成一定影响,而对图像对比度造成较大影响.只有在透镜系统针对的消像差波段540～550 nm附近窄带发光的转换屏,其成像质量才能基本不受匹配影响,近似于模拟计算的结果.     

Recent advances in the development of colorimetric analysis and testing based on aggregation-induced nanozymes

Colorimetric sensing strategies as a powerful point-of-care testing(POCT) tool have attracted significant interest in various chem/biosensing applications.Taking the excellent bare-eye-detectable signaling feature,nanozymes-based colorimetric sensors enable more potential applications and have been a new forefront in the colorimetric POCT analysis toward different target analytes.However,the low catalytic activity of nanozymes in most cases limits their practical application.Recent efforts demonstrate that the aggregation-induced nanozymes provide a general means to modulate nanozymes activity and enhance colorimetric sensing performances of some nanozymes-based colorimetric sensors.But there are few reports are explored to discuss and review such aggregation-induced nanozymes and their colorimetric sensing applications.To highlight the advances and progress in aggregation-induced nanozymes based colorimetric assays,we herein summary the fundamentals,classify and applications of this newlydeveloping field,focusing on the aggregation-induced activity enhancement of nanozymes(AIAEnanozymes) with a significant "signal-on" feature and aggregation-induced activity inhibition of nanozymes(AIAI-nanozymes) with a dramatical "signal-of" characteristics.Finally,we also propose the current challenges and the future prospects on both AIAE-nanozymes and AIAI-nanozymes.