在不同激光脉宽下的高次谐波

用数值计算方法计算了不同强激光脉冲宽度下高次谐波的产生.我们发现对于激光场强度不高,不能有效电离初态的激光场,长脉冲宽度可以更有效产生高次谐波;而对于高场强的激光场,由于它能够在几个光学周期之内把原子的初态全部电离,所以短脉冲的激光场能够更有效产生高次谐波.     

Nd0.5Ca0.5Mn1-xAlxO3 (x=0,0.03)体系中电荷有序态的超声研究

系统研究了Nd0．5Ca0．5Mn1-xAlxO3(x=0,0．03)单相多晶样品在低温下的电磁性质和超声特性．电阻和磁化率测量表明,Nd0．5Ca0.5O3体系在TCO-257 K处发生了电荷有序相变．超声声速从室温开始随着温度的降低逐渐减小,并在TCO附近达到最小,之后,随着温度的进一步降低,声速急刷增加,同时伴随着一个尖锐的超声衰减峰出现.TCO附近的超声异常表明体系中存在着强烈的电-声子相互作用,该电-声子耦合来源于Mn3 的Jahn-Teller效应．在低温下,出现了另一个超声衰减峰,它的出现归结为反铁磁相与顺磁相之间的相分离现象.随着Al在Mn位的掺入,超声声速的最低点和衰减峰向低温移动,表明体系中的电荷有序态和反铁磁相均被部分抑制,     

空气/水界面水分子的取向和运动

对四种不同的实验构型下空气／水界面自由O-H键在3700cm~(-1)的和频振动光谱的分析表明,水分子在空气／水界面的取向运动只可能是在平衡位置附近有限角度之内的受限转动。界面水分子的自由O-H键取向距界面法线约33°,而取向分布或运动的宽度不超过15°。这一图像显著地不同于Wei等人(Phys. Rev. Lett.86,4799(2001))只通过单一的SFG实验构型所得出结论,即：空气／水界面的水分子在超快的振动弛豫时间内在很大的角度范围内运动。     

A method for calculating invariant subspaces of symmetric hyperbolic equations

An algorithm is constructed for calculating invariant subspaces of symmetric hyperbolic systems arising in electromagnetic, acoustic, and elasticity problems. Discrete approximations are calculated for subspaces that correspond to minimal eigenvalues and smooth eigenfunctions. Difficulties related to the presence of an infinite-dimensional kernel in the differential operator are successfully handled. The efficiency of the algorithm is demonstrated using acoustics equations.     

Commuting and stable feedback design for switched linear systems

In the paper, commuting and stable feedback design for switched linear systems is investigated. This problem is formulated as to build up suitable state feedback controller for each subsystem such that the closed-loop systems are not only asymptotically stable but also commuting each other. A new concept, common admissible eigenvector set (CAES), is introduced to establish necessary/sufficient conditions for commuting and stable feedback controllers. For second-order systems, a necessary and sufficient condition is established. Moreover, a parametrization of the CAES is also obtained. The motivation comes from stabilization of switched linear systems which consist of a family of LTI systems and a switching law specifying the switching between them, where if all the subsystems are stable and commuting each other, then the total system is stable under arbitrary switching.     

Luminescence investigations of the GaP-based dilute nitride Ga(NAsP) material system

Multi-quantum well heterostructures (MQWHs) of the novel Ga(NAsP)/GaP material system have been grown, pseudomorphically strained to GaP-substrate. The crystalline perfection is verified by transmission electron microscopy (TEM). For As-concentrations in excess of about 70%, a direct band structure and adequate luminescence efficiency for laser device application is observed. Temperature-dependent photoluminescence (PL) investigations show the influence of carrier localisation and non-radiative recombination processes typical for dilute nitride materials. With rising N content in the active material, the emission wavelength shifts towards longer wavelength, leading to Ga(NAs)/GaP MQW structures with photon energies below the indirect band gap of silicon (Si). At the same time the luminescence intensity drops due to an increase in non-radiative carrier traps and/or structural degradation.     

Generalized quasilinearization method for reaction-diffusion equations under nonlinear and nonlocal flux conditions

In this paper we consider an initial boundary value problem for a reaction-diffusion equation under nonlinear and nonlocal Robin type boundary condition. Assuming the existence of an ordered pair of upper and lower solutions we establish a generalized quasilinearization method for the problem under consideration whose characteristic feature consists in the construction of monotone sequences converging to the unique solution within the interval of upper and lower solutions, and whose convergence rate is quadratic. Thus this method provides an efficient iteration technique that produces not only improved approximations due to the monotonicity of its iterates, but yields also a measure of the convergence rate.     

Scale Invariance Properties in the Simulated Annealing Algorithm

The Boltzmann distribution used in the steady-state analysis of the simulated annealing algorithm gives rise to several scale invariant properties. Scale invariance is first presented in the context of parallel independent processors and then extended to an abstract form based on lumping states together to form new aggregate states. These lumped or aggregate states possess all of the mathematical characteristics, forms and relationships of states (solutions) in the original problem in both first and second moments. These scale invariance properties therefore permit new ways of relating objective function values, conditional expectation values, stationary probabilities, rates of change of stationary probabilities and conditional variances. Such properties therefore provide potential applications in analysis, statistical inference and optimization. Directions for future research that take advantage of scale invariance are also discussed.     

Cosmic dust and our origins

The small solid particles in the space between the stars provide the surfaces for the production of many simple and complex molecules. Processes involving the effects of ultraviolet irradiation of the thin (hundredth micron) mantles are shown to produce a wide range of molecules and ions also seen in comets. Some of the more complex ones inferred from laboratory experiments are expected to play an important role in the origin of life. An outline of the chemical evolution of interstellar dust as observed and as studied in the laboratory is presented. Observations of comets are shown to provide substantial evidence for their being fluffy aggregates of interstellar dust as it was in the protosolar nebula, i.e. the interstellar cloud which collapsed to form the solar system. The theory that comets may have brought the progenitors of life to the earth is summarized.     

Laser induced copper electroless plating on polyimide with Q-switch Nd:YAG laser

The results of laser induced deposition of copper on polyimide substrate from copper electrolyte solution are reported. Unlike most work reported in the literatures where CW Ar⁺ lasers were used, a second harmonic (532 nm wavelength) Q-switch Nd:YAG laser was used for our experiments. The deposition process was conducted by laser-catalyzing of the polyimide surface and subsequent photothermal-accelerated reduction of copper-complex ions in an alkaline reducing environment. The characteristics of the deposited copper line were investigated in terms of laser beam scanning speed, and the number of scans. The surface morphology and chemical composition of the deposited copper were analyzed using field emission scanning electron microscope (FESEM) and energy dispersive spectrometer (EDX). The optimum processing conditions have been identified. The copper deposit was found to adhere well to the substrate.