Possible application of X-ray optical elements for reducing the spectral bandwidth of an X-ray SASE FEL

A new design for a single pass X-ray Self-Amplified Spontaneous Emission (SASE) FEL is proposed. The scheme consists of two undulators and an X-ray monochromator located between them. The first stage of the FEL amplifier operates in the SASE linear regime. After the exit of the first undulator the electron bunch is guided through a non-isochronous bypass and the X-ray beam enters the monochromator. The main function of the bypass is to suppress the modulation of the electron beam induced in the first undulator. This is possible because of the finite value of the natural energy spread in the beam. At the entrance to the second undulator the radiation power from the monochromator dominates significantly over the shot noise and the residual electron bunching. As a result the second stage of the FEL amplifier operates in the steady-state regime when the input signal bandwidth is small with respect to that of the FEL amplifier. Integral losses of the radiation power in the monochromator are relatively small because grazing incidence optics can be used. The proposed scheme is illustrated for the example of the 6 nm option SASE FEL at the TESLA Test Facility under construction at DESY. As shown in this paper the spectral bandwidth of such a two-stage SASE FEL (Δλ/λ 5 × 10⁻⁵) is close to the limit defined by the finite duration of the radiation pulse. The average brilliance is equal to 7 × 10²⁴ photons/(s × mrad² × mm² × 0.1% bandw.) which is by two orders of magnitude higher than the value which could be reached by the conventional SASE FEL. The monochromatization of the radiation is performed at a low level of radiation power (about 500 times less than the saturation level) which allows one to use conventional X-ray optical elements (grazing incidence grating and mirrors) for the monochromator design.     

采用级联原子滤光器的新型卫星激光链路系统研究

提出级联佛克脱型原子滤光器(Linked VADOF)的新构想。从理论上分析并计算了级联佛克脱型原子滤光器的透射谱。结果表明，级联佛克脱型原子滤光器将佛克脱型原子滤光器的多峰改造为单峰结构，具有比佛克脱型原子滤光器更窄的线宽和更高的噪声抑制比。将这种新型结构应用于激光信标锁频。该锁频方案提高了信标光频率的稳定性。在此基础上，给出了发射端采用级联佛克脱型原子滤光器锁频，接收端采用法拉第型原子滤光器(FADOF)滤光的新型卫星激光链路系统。外场初步联调实验表明了该系统的可行性。     

Surface Nitridation of Molybdenum by Laser-promoted Reaction

l.IntroductionowingtotheirpromisingproPertiesandPOtentialapplications,transitionmetalni-trideshavedrawngreatattentionandthepreparationandinvestigationofthesecom-poundshavebeenasubjectbothofscientificandoftechnologicalinterest.Transitionmetalnitridescombineadvantagesofexce1lenthardness,highmeltingPOint,goodchemi-calstabilityandhigheIectricalconductivity[11,henceoverlaySofthesecompoundshavefoundwideappIicationsinvariousfie1ds.Molybdenumnitrides,inparticular,havealsoemergedasverypromisingcandi…     

端面泵浦掺Yb3+双包层光纤激光器

从双包层光纤激光器的速率方程出发，得到了光纤中泵浦光与激光的功率分布、输出功率与泵浦功率的关系、腔镜反射率及光纤长度对输出功率的影响。研究结果表明：输出激光功率与光纤长度及后腔镜反射率有很强的依赖关系，存在一个输出功率最大的最佳光纤长度。后腔镜反射率越大，输出激光功率越小；当光纤长度较短时，在输出端放置反射镜使泵浦光高反射，可以提高输出功率和效率。通过对端面泵浦掺Yb3+双包层光纤激光器进行理论分析和实验研究，得到输出激光的中心波长为1088.3nm，斜率效率为33.7%，最大输出功率为1.75W。     

Output dynamics and stabilisation of a multi-mode double-clad Yb-doped silica fibre laser

The intensity dynamics of the double-clad Yb fibre laser have been characterised. Stabilisation of the fibre laser intensity by using uniform bi-directional pumping is demonstrated. For the single-end-pumped Yb fibre laser, the output becomes more stable for the shorter fibre length due to the higher threshold of stimulated Brillouin scattering, SBS, and Kerr effects and the reduction of saturated absorber effects caused by any unpumped fibre section. By additional pumping in a double-end-pumped configuration, the output power can be scaled higher before detecting high intensity pulses initiated by SBS in the Yb fibre laser due to the reduction of saturable absorption effect. It is confirmed that uniform pumping enhances the stability of the laser output.     

非谐振腔型KTP光参变振荡器

研究了双晶体走离补偿、非谐振腔型KTP光参变振荡器，利用一套膜片实现了KTP相位匹配所允许的全波段调谐，信号光调谐范围0.698μm-1.026μm，闲频光调谐范围1.105μm-2.237μm。5倍阈值处，信号光840nm最高输出能量53mJ，能量转换效率25.8%，量子转换效率40％，闲频光的量子郊率也达到32％。     

Operational characteristics and power scaling of a transverse flow transversely excited CW CO<Subscript>2</Subscript> laser

Transverse flow transversely excited (TFTE) CO₂ lasers are easily scalable to multikilowatt level. The laser power can be scaled up by increasing the volumetric gas flow and discharge volume. It was observed in a TFTE CW CO₂ laser having single row of pins as an anode and tubular cathode that the laser power was not increasing when the discharge volume and the gas volumetric flow were increased by increasing the electrode separation keeping the gas flow velocity constant. The discharge voltage too remained almost constant with the change of electrode separation at the same gas flow velocity. This necessitated revision of the scaling laws for designing this type of high power CO₂ laser. Experimental results of laser performance for different electrode separations are discussed and the modifications in the scaling laws are presented.     

极小孔半导体激光器近场区光场分布研究

利用时域有限差分法(FDTD)计算和分析了极小孔半导体激光器输出光端面附近的光场分布,指出小孔激光器近场区域光场分布的特点,讨论了小孔大小和金属厚度对光场分布和光源分辨率的影响,得到设计和制备极小孔半导体激光器的优化方法.     

Depth profiling of latex blends of fluorinated and fluorine‐free acrylates with laser‐induced secondary mass spectrometry

We explored phase separation and self‐assembly of perfluoroalkyl segments at the surface of polymer films obtained from latices of semifluorinated acrylate copolymers and the corresponding latex blends of nonfluorinated and semifluorinated polyacrylates. With laser‐induced secondary mass spectrometry the fluorine distribution was measured after annealing above the minimum film‐forming temperature of the polymers up to a depth of several micrometers. Depth profiles of a semifluorinated acrylate homopolymer and latex blends thereof with fluorine‐free alkylacrylates with 25, 50, and 75 mol % semifluorinated acrylate as well as a copolymer comprised of alkyl acrylate and semifluorinated acrylate (50/50 mol %) were investigated. In the case of latex blends containing both semifluorinated polyacrylates and fluorine‐free or low‐fluorine polymers, self‐assembly accounted for enrichment of the perfluoroalkyl segments at the surface. Coatings exhibiting low surface energy and having a substantially reduced total fluorine content were obtained. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 360–367, 2003     

Characterization of semiconductor laser frequency chirp based on signal distortion in dispersive optical fiber

In the paper, the simple method of laser chirp parameters estimation is presented. It is based on measuring time-domain distortions of chirped signal transmitted through dispersive fiber and finding laser chirp parameters by matching measured distortions to calculated ones. Experiments undertaken with 1.55 μm telecommunication grade distributed feedback (DFB) lasers and standard single-mode fiber are described, together with some practical remarks on measurement setup and main conclusions.