ZnSe及ZnSe/GaAs异质结构中压力导致的直接禁带向间接禁带的转变

用经验赝势方法计算了体ZnSe以及ZnSe/GaAs单异质结系统中ZnSe外延层г、X、L等特殊对称点导带底能量随压力的变化。结果表明，同Si、Ge、GaAs等半导体材料不同，ZnSe的X点导带底具有正的压力系数，但比г点的压力系数小，这是ZnSe材料以及ZnSe基异质结构材料发生直接禁带向间接禁带的转变时所需转变压力较大的根本原因。研究了ZnSe/GaAs异质结构中晶格失配造成的应变对外延层г、X、L对称点压力系数的影响，表明这种晶格失配造成的应变可以极大地减小ZnSe外延层材料由直接禁带向间接禁带的转变压力。     

基于同步辐射加速器的康普顿背散射γ射线源(Ⅰ)产生MeV量级γ光子的数值计算

提出在筹建的上海同步辐射装置上建造一条MeV量级γ射线束及应用站,采用μm波长的红外(或远红外)激光与储存环中3.5GeV电子束进行康普顿背散射,从而获得能区为1—25MeV的康普顿背散射γ光子束,该光子束具有高强度、高极化度(线和圆极化)、准单色、方向性好的优点,可以广泛地应用于核物理和核天体物理基础研究及相关的应用研究领域.介绍了康普顿背散射的基本原理,并结合储存环参数给出了光子束性能的数值计算结果.     

Active long pulse shaping technique of pulsed CO2 laser using multi-pulse discharge control

We describe the pulse forming of pulsed CO₂ laser using multi-pulse superposition technique. Various pulse shapes, high duty cycle pulse forming network (PFN) are constructed by time sequence. This study shows a technology that makes it possible to make various long pulse shapes by activating SCRs of three PFN modules consecutively at a desirable delay time with the aid of a PIC one-chip microprocessor. The power supply for this experiment consists of three PFN modules. Each PFN module uses a capacitor, a pulse forming inductor, a SCR, a high voltage pulse transformer, and a bridge rectifier on each transformer secondary. The PFN modules operate at low voltage by driving the primary of HV pulse transformer. The secondary of the transformer has a full-wave rectifier, which passes the pulse energy to the load in a continuous sequence.We investigated various long pulse shapes as different trigger time intervals of SCRs among three PFN modules. As a result, we could obtain laser beam with various pulse shapes and durations from about 250 to 1000 μs.     

光纤光栅激光器激射波长的研究

一般认为，用光纤光栅作选频元件的光纤激光器，激射波长与光纤光栅中心反射波长一致，本文报道了不同的实验研究结果。通过细致的实验研究，发现光纤光栅激光器激射波长相对于光纤光栅中心反射波长有一定的偏移。激射波长可以出现在光栅中心反射波长的长波端，也可以出现在其短波端。对不同腔结构的掺镱、掺铒光纤光栅激光器的深入研究证明，谐振腔的各向异性对激光器的激射波长偏移起到决定性的作用，波长最大偏移量主要受限于光纤光栅的反射带宽。通过激光腔内的偏振控制器改变谐振腔的各向异性，可以在光纤光栅的反射带宽内控制激射波长的位置。     

Polytetrafluoroethylene and metal structure convective-flow CO laser

A convective flow CO laser composed of polytetrafluoroethylene discharge tubes, nickel–chromium steel components, a cupric heat exchanger and other components is described. Operating in liquid nitrogen condition, output power of 60 W has been obtained from a non-selective cavity.     

用γ计数率的变化定位核元件的技术研究

用标准放射源进行模拟核材料库房监控实验,当放射源被转移出系统的时候,在不同位置探测了γ计数率变化,根据γ计数率变化的距离平方反比规律实现了被转移的放射源的定位,并估算了该放射源的源强.     

电子束流品质对自由电子激光小信号增益影响的计算

对电子束有一定初始能量分散或角度分散时的自由电子激光小信号增益用较简便的方法进行了分析计算,并给出了一个渐近公式,结果与用计算机模拟解自由电子激光微分方程组得到的结果一致。     

New FIR laser lines and frequency measurements for optically pumped CD3OH

Twenty new cw FIR laser lines in CD₃OH, optically pumped by a CO₂ laser, are reported. The frequencies of 39 of the stronger laser lines were measured relative to stabilized CO₂ lasers with a fractional uncertainty, as determined by the reproducibility of the FIR frequency itself, of 2 parts in 10⁷.Contribution of the U.S. Government, not subject to copyright.     

Laser-induced damage of Ta2O5/SiO2 narrow-band interference filters under different 1064 nm Nd:YAG laser modes

The laser-induced damage (LID) behavior of narrow-band interference filters was investigated with a Nd:YAG laser at 1064 nm under single-pulse mode and free-running mode. The absorption measurement of such coatings was performed with surface thermal lensing (STL) technique. The damage morphologies under the two different laser modes were also studied in detail. It was found that all the filters exhibited a pass-band-center-dependent absorption and laser-induced damage threshold (LIDT) behavior, but the damage morphologies were diverse. The explanation was given with the analysis of the electric field distribution and the operational behavior of the irradiation laser.