Interlaboratory comparisons and improvements of methods for acid number determination in used motor oils

The results of two interlaboratory comparisons of acid number determinations in used motor oils are discussed. It is shown that the comparability of the measurement results is not as good as that required by known standards for petroleum products. The problem is motor oil contaminants which accumulated during use, and which are the source of a matrix effect in the acid number determination. The standard methods’ drawbacks are analyzed and some improvements are proposed. Repeatability and accuracy of the improved methods are evaluated. Received: 11 December 2001 Accepted: 15 February 2002     

Novel model of FM-noise conversion in a UMZI using RF external phase modulation of lasers: Theoretical and experimental results

In this paper, we propose and demonstrate a new and original model for theoretical calculation and experimental measurement of the noise power spectral density (NPSD) in phase-modulated optical links. The phase modulation is operated in the RF frequency range by an external phase modulator. The NPSD is derived for the first time in interferometric systems, by considering all effects such as the 1/f FM noise of the laser and white noise applied to light from a 1550 nm DFB laser, with phase modulation. The results show for the first time the influence of the phase modulation index, modulation frequency and interferometric delay in the phase-to-intensity noise conversion. The experimental and simulation results of conversion of FM-noise to intensity noise in an optical link by considering the external RF phase modulation are shown with good agreement.     

推广x重新标度模型的重标度参数经验公式

给出了推广x重新标度模型的重标度参数经验公式,其中建立了重标度参数与原子核的平均结合能之间的联系,由该公式可以得出A≥12的所有核的重标度参数值,利用这些参数值可以计算有关核过程并做出预言.     

在BEPC上建造γ束线站的分析

考虑电子的反冲并利用康普顿散射,研究了激光同步辐射光源(LSS)辐射的光子波长、光子能量。结果表明,对于不同的γ,LSS辐射的光子波长和能量有不同的近似公式。当γ<<λ1/4λe时,LSS辐射的光子波长λ2≈λ1/4γ2,能量(εc2≈4γ2εc1;当γ>>λ1/4λe时,LSS辐射的光子波长λ2≈λe/γ,能量cε2≈m0γc2;结果表明,LSS辐射的条件是种子激光的波长λ1大于电子的物质波波长λm;LSS辐射的极值波长是λ2m ax=h/m0γv,极值能量是cε2m ax=βeε;本文后半部分提出了利用北京正负电子对撞机的强流高亮度电子束与激光的康普顿背散射产生单色γ射线的建议。     

(Ni0.8Zn0.2Fe2O4)epoxy-PZT双层膜中的磁电效应

讨论了Ni_0.8Zn_0.2Fe₂O₄ (NZFO)与锆钛酸铅(PZT)的双层膜结构样品的磁电(ME)效应.NZFO粉料由溶胶-凝胶法制成，再经900℃热压，并高温烧结.在该双层膜中测量到了很强的磁电相互作用.发现横向的磁电效应比纵向效应大一个数量级，并且随NZFO烧结温度的提高而增加.当烧结温度从950℃上升到1380℃时，横向ME电压系数(α_E)的最大值变化范围为25.6 mV Am^-2≤α_E≤199.6 mV Am^-2.理论分析显示NZFO-PZT双层膜样品中ME效应源于NZFO与PZT之间相对良好的磁电耦合. 关键词： 镍铁氧体 PZT 热压法 ME效应     

Diode-pumped 671 nm laser frequency doubled by CPM LBO

A design of diode-pumped high-efficiency Nd:YVO₄/LBO red laser is reported. Using critical phase-matching (CPM) LBO, 671 nm red laser was obtained from 1342 nm light by intracavity frequency doubling. With an incident pump laser of 800 mW, using type-I and type-II CPM LBO, 97 and 52 mWTEM₀₀ mode red laser outputs were obtained, with optical-to-optical conversion efficiencies of up to 12.1% and 6.5%, respectively.     

Au-Au2S复合纳米球壳微粒的空腔谐振及参量讨论

Au-Au2S复合纳米球壳微粒（金纳米球壳），是一种新型复合结构的纳米微粒，其结构为纳米级的Au2S介质球外包裹了一层几个纳米厚的黄金球壳。这种复合纳米球壳微粒可以被抽象为球型谐振腔。报道了它的空腔谐振吸收的实验结果，并且运用经典理论结合介观结构特征，讨论了有关Au-Au2S复合纳米球壳微粒空腔谐振吸收的一些重要参量，其中包括谐振吸收波长、品质因数、谐振能量等。另外，还讨论了金球壳的厚度对这些重要参量的影响。     

动态激光衍射法测量细丝直径

基于夫琅禾费衍射理论和巴比涅互补原理,提出了利用激光衍射对细丝直径进行动态测量的方法.该方法具有测量精度高、速度快、非接触、使用方便且易于微机联接实现自动化测量等优点.     

The influence of pulse duration on the stress levels in ablation of ceramics: A finite element study

We present a finite element model to investigate the dynamic thermal and mechanical response of ceramic materials to pulsed infrared radiation. The model was applied to the specific problem of determining the influence of the pulse duration on the stress levels reached in human dental enamel irradiated by a CO₂ laser at 10.6 μm with pulse durations between 0.1 and 100 μs and sub-ablative fluence. Our results indicate that short pulses with durations much larger than the characteristic acoustic relaxation time of the material can still cause high stress transients at the irradiated site, and indicate that pulse durations of the order of 10 μs may be more adequate both for enamel surface modification and for ablation than pulse durations up to 1 μs. The model presented here can easily be modified to investigate the dynamic response of ceramic materials to mid-infrared radiation and help determine optimal pulse durations for specific procedures.     

Spectral and temporal characteristics of metallic nanoparticles produced by femtosecond laser pulses

We study the time of flight optical emission from titanium and tungsten nanosized particles, generated through femtosecond laser-matter interaction in vacuum, in the wavelength spectral range from 300 to 900 nm. Typical spectra consist of broadband structureless signals similar to black body emission from a macroscopic object. Nanoparticles temperature, deduced from their emission spectra, decreases drastically as a function of their time of arrival at a given distance from the target. This behaviour is seen to be independent of individual particle velocities.