神光-Ⅱ装置三倍频实验中靶场单元技术的改进

 主要介绍为了满足神光-Ⅱ高功率激光装置三倍频光（351nm，3ω）的物理实验要求，靶场三倍频模拟光源和瞄准监视系统两个主要单元技术的改进，即三倍频模拟光源由基频光（1 053nm，3ω）通过腔外的KTP+BBO晶体倍频获得，再经八路分光系统和主激光耦合；瞄准监视系统由透射式光学系统改进为反射式光学系统，避免原系统存在较大的色差，提高瞄准精度。     

Review of Fluorescence Spectroscopy in Environmental Quality Applications

Fluorescence spectroscopy is an optical spectroscopic method that has been applied for the assessment of environmental quality extensively during the last 20 years. Most of the earlier works have used conventional light sources in spectrofluorometers to assess quality. Many recent works have used laser sources of light for the same purpose. The improvement of the energy sources and of the higher resolution spectrometers has led to a tremendous increase in applications. The motivation for the present review study is the increasing use of laser sources in environmental applications. The review is divided in two parts. The fundamental principles of fluorescence spectroscopy are described in the first part. The environmental applications are described in the second part.     

Dielectric Properties Investigation of Metal–Insulator–Metal (MIM) Capacitors

This study presents the construction and dielectric properties investigation of atomic-layer-deposition Al₂O₃/TiO₂/HfO₂ dielectric-film-based metal–insulator–metal (MIM) capacitors. The influence of the dielectric layer material and thickness on the performance of MIM capacitors are also systematically investigated. The morphology and surface roughness of dielectric films for different materials and thicknesses are analyzed via atomic force microscopy (AFM). Among them, the 25 nm Al₂O₃-based dielectric capacitor exhibits superior comprehensive electrical performance, including a high capacitance density of 7.89 fF·µm⁻², desirable breakdown voltage and leakage current of about 12 V and 1.4 × 10⁻¹⁰ A·cm⁻², and quadratic voltage coefficient of 303.6 ppm·V⁻². Simultaneously, the fabricated capacitor indicates desirable stability in terms of frequency and bias voltage (at 1 MHz), with the corresponding slight capacitance density variation of about 0.52 fF·µm⁻² and 0.25 fF·µm⁻². Furthermore, the mechanism of the variation in capacitance density and leakage current might be attributed to the Poole–Frenkel emission and charge-trapping effect of the high-k materials. All these results indicate potential applications in integrated passive devices.     

基于铰链式六面顶压机的二级6-8模超高压大腔体内置加热元件的设计与温度标定

 首次报道了一种新型的基于铰链式六面顶压机的二级6-8模大腔体静高压装置的内置加热元件的设计与温度标定。此加热组装结构简单,升温快,保温效果好,并有效地解决了国外基于两面顶压机构架下的二级6-8模内加热组装中热电偶在施加压力时易断的问题。以低成本的碳管为加热元件,采用直接和间接两种加热方式,用双铂铑（Pt6%Rh-Pt30%Rt）B型热电偶进行温度测量,并根据实验过程中加热功率与腔内实际温度的关系,对不同压力下腔体内的温度进行了标定。实验结果表明：此加热系统的油压达到40 MPa（腔体压力约10 GPa）时,温度可以达到1 700 ℃以上;在油压为30 MPa、样品室温度为1 000 ℃时,保温时间可达2 h,甚至更长;实验中获得样品的直径可达3 mm,高度可达7 mm,实现了在高温超高压条件下大样品的制备,满足了实验对产生高温超高压条件的需要。     

一种蓝色聚合物激光材料

聚合物作为一种有机发光材料,由于在平板显示和光电子器件中的良好应用前景而受到广泛研究［１～２］．近年来,一个重要进展是在聚合物中观测到了受激发射（简称Ｐｏｌｙ－ｍｅｒ激光）现象［３～６］．Ｐｏｌｙｍｅｒ激光最早是在溶液中实现的［３～４］．作为一种新型...     

扫描环形光斑激光束优化研究

激光束的形状和能量分布限定了激光的应用范围,为满足不同的激光加工需要,必须对激光束进行变换。针对实验室用CO2激光器在热处理方面的应用,提出了激光扫描环形光斑光束优化法。基于温度场叠加原理建立了扫描环形光斑温度场的数学模型,模拟其温度场,可得到其温度分布特性;通过实验研究,分析了聚焦光斑与扫描环形光斑在激光淬火中对材料的热作用效果。结果表明,扫描环形光斑能改善激光热处理硬化层分布。理论和实验研究表明,激光扫描环形光斑技术可以实现激光热处理光束的优化,有一定的应用前景。     

激光激发水中产生超声波的实验研究

采用压电陶瓷水听器研究了Nd：YAG脉冲激光激发水中产生瞬态超声波的特性,给出了声压信号随距离的变化关系。研究结果表明：用激光产生水下声波是完全可行的。当观测点与光击穿区的距离r远大于柱体长度时,垂直于光传播方向的激光瞬态超声波幅值与r成反比;当观测点与光击穿区的距离r很小时,垂直于光传播方向的声压幅值与产成反比。此外,当激光入射角度发生变化,超声脉冲的幅值也随之发生变化,其幅值在激光束垂直入射的时候最大。     

辐射在CH泡沫中传输的数值模拟

利用一维多群辐射输运程序对辐射在CH泡沫中的传输过程进行了数值模拟,给出一些细致的物理图像和定量结果。在一定的入射辐射流条件下,密度变化对辐射传输特征、辐射加热介质的热力学平衡弛豫过程有重要影响。随着密度下降,辐射由亚声速传输转变为超声速传输,辐射在传输过程中的能谱形状也不同。     

连续激光辐照ZnSe/MgF2/K9滤光片的透射特性研究

分析了连续激光辐照ZnSe/MgF2/K9滤光片引起透射特性的变化。在室温条件下,用波长0.632 8μm激光作为探测光束,测量了1.06μm连续激光辐照ZnSe/MgF2/K9滤光片温升引起薄膜折射率的改变,导致探测光束通过干涉滤光片后透过率的热致非线性变化。在光斑直径0.75mm条件下,测量了不同功率激光辐照ZnSe/MgF2/K9滤光片引起温升随时间的变化。在激光功率30W,辐照时间2.52s条件下,实验观测到ZnSe/MgF2/K9滤光片薄膜破坏温度约为90℃,辐照时间10s时干涉滤光片形成的薄膜龟裂形貌。     

激光辐照PC型HgCdTe探测器的实验研究

分别用连续波1.319μm激光和10.6μm激光辐照PC型HgCdTe红外探测器时,得到了不同辐照光功率密度下,探测器输出的一系列实验结果。给出了在波长为1.319μm的波段内激光辐照下PC型HgCdTe探测器的饱和阈值;用波长为10.6μm的波段外CO2激光辐照探测器时,发现了一些与波段内激光辐照探测器时大不相同的实验现象;对实验结果进行了分析。简要总结了PC型HgCdTe探测器对于波段内和波段外激光辐照的响应机制。