光纤光栅激光器激射波长的研究

一般认为，用光纤光栅作选频元件的光纤激光器，激射波长与光纤光栅中心反射波长一致，本文报道了不同的实验研究结果。通过细致的实验研究，发现光纤光栅激光器激射波长相对于光纤光栅中心反射波长有一定的偏移。激射波长可以出现在光栅中心反射波长的长波端，也可以出现在其短波端。对不同腔结构的掺镱、掺铒光纤光栅激光器的深入研究证明，谐振腔的各向异性对激光器的激射波长偏移起到决定性的作用，波长最大偏移量主要受限于光纤光栅的反射带宽。通过激光腔内的偏振控制器改变谐振腔的各向异性，可以在光纤光栅的反射带宽内控制激射波长的位置。     

Polytetrafluoroethylene and metal structure convective-flow CO laser

A convective flow CO laser composed of polytetrafluoroethylene discharge tubes, nickel–chromium steel components, a cupric heat exchanger and other components is described. Operating in liquid nitrogen condition, output power of 60 W has been obtained from a non-selective cavity.     

电子束流品质对自由电子激光小信号增益影响的计算

对电子束有一定初始能量分散或角度分散时的自由电子激光小信号增益用较简便的方法进行了分析计算,并给出了一个渐近公式,结果与用计算机模拟解自由电子激光微分方程组得到的结果一致。     

New FIR laser lines and frequency measurements for optically pumped CD3OH

Twenty new cw FIR laser lines in CD₃OH, optically pumped by a CO₂ laser, are reported. The frequencies of 39 of the stronger laser lines were measured relative to stabilized CO₂ lasers with a fractional uncertainty, as determined by the reproducibility of the FIR frequency itself, of 2 parts in 10⁷.Contribution of the U.S. Government, not subject to copyright.     

Laser-induced damage of Ta2O5/SiO2 narrow-band interference filters under different 1064 nm Nd:YAG laser modes

The laser-induced damage (LID) behavior of narrow-band interference filters was investigated with a Nd:YAG laser at 1064 nm under single-pulse mode and free-running mode. The absorption measurement of such coatings was performed with surface thermal lensing (STL) technique. The damage morphologies under the two different laser modes were also studied in detail. It was found that all the filters exhibited a pass-band-center-dependent absorption and laser-induced damage threshold (LIDT) behavior, but the damage morphologies were diverse. The explanation was given with the analysis of the electric field distribution and the operational behavior of the irradiation laser.     

用于机械振动实时监测的光纤光栅有源传感装置

把一对中心反射波长分别为1562.11nm和1562.71nm的光纤光栅粘贴在均质、等厚、等腰三角形悬臂梁上下表面作为环形腔光纤激光器端镜，当机械振动激励自由端时，通过观测激光输出脉冲，地施加于自由端的机械振动的频率进行了实时监测；观察两光栅波长漂移量差值的变化，可在0～6.1mm的范围内判断所测振动的振幅。低于100Hz时，实验结果与实际值基本吻合。     

束晕-混沌的复杂性理论与控制方法及其应用前景

本文系统论述涉及强流加速器等强流离子束装置中产生的束晕-混沌的复杂性理论与控制方法及其应用前景。强流离子束在核材料生产与增殖、洁净核能、放射性废物嬗变、放射性药物生产、重离子聚变、高能物理、核科学与工程、国防与民用工业和医疗等许多方面都有极其重要的应用潜力和诱人的发展前景。尤其是，近年来强流加速器驱动的放射性洁净核能系统是国内外关注的热门课题，因为它比常规核电更安全、更干净、更便宜。但是，强流离子束形成的束晕-混沌的复杂性现象已引起了国内外广泛关注，需要加以抑制、控制和消除这类现象，解决这一难题已经成为强流离子束应用中的关键问题之一。目前不仅必须深入研究这类束晕-混沌的复杂特性及其产生的物理机制，而且需要研究如何实现对束晕-混沌的有效控制，并寻求和发展其新理论、新方法和新技术。这就向强流离子束物理和非线性-复杂性科学及其技术提出了一系列极富挑战性的新课题。本文结合国内外的研究概况，根据我们多年来的研究成果，特别是我们首创性地提出了一些束晕-混沌的有效控制方法，它们包括：非线性反馈控制法，小波反馈控制法，变结构控制法，延迟反馈控制法，参数自适应控制法等，进行重点的介绍。对上述课题当前的主要进展及相关问题进行系统的总结和比较全面综述的评论。最后，指出该领域今后的研究方向，以推动这个崭新领域的深入研究和应用发展。     

Variational Derivative for Buckling Loads of Beams and Frames

The finite-difference method is a numerical technique for obtaining approximate solutions to differential equations. The main objective of the present study is to give a new aspect to the finite-difference method by using a variational derivative. By applying this formulation, accurate values of the buckling loads of beams and frames with various end supports are obtained. The performance of this formulation is verified by comparison with numerical examples in the literature __________ Published in Prikladnaya Mekhanika, Vol. 41, No. 7, pp. 139–144, July 2005.     

Photoluminescence linewidth broadening due to alloy/thickness fluctuation of CdxZn1 − xSe/ZnSe triple quantum wells

Photoluminescence (PL) linewidth broadening of Cd_xZn_{1 − x}Se/ZnSe triple quantum wells, grown on GaAs substrates by molecular beam epitaxy (MBE), has been investigated. Various quantum well (QW) samples have been prepared with different QW thickness and composition (Cd-composition). Measured and calculated PL linewidth are compared. Both composition and thickness fluctuations are considered for the calculation with the parameters such as the volume of exciton, nominal thickness and composition of QWs. Surface roughness measured by atomic force microscopy (AFM) is used to estimate the interface roughness. Results show that when Cd-composition increases additional linewidth broadening due to Zn/Cd interdiffusion is enhanced.     

电子束驱动的回旋激射不稳定性

对弱相对论性电子束驱动的回旋激射(maser)不稳定性的一般理论作了详细讨论.对在获得增长率实用表达式过程中若干解析表达式的推导与细节做了仔细的补充讨论和说明，还增加了增长率的近似表达式，并由此得到了回旋激射不稳定性主要特征的解析分析以及与精确计算的比较，使整个理论有一个完整的描述.侧重解析讨论，也提供了部分一般性的数值计算结果. 关键词： 回旋激射不稳定性 弱相对论性电子束 增长率