均匀分层介质中标准矢量波函数的构成

研究了在均匀分层介质中构成标准矢量波函数的必要条件。研究结果表明在均匀分层介质中构成标准矢量波函数一般需遵循Morse-Feshbach判据外，领示矢量只能选取与折射率变化方向一致的那根坐标轴单位矢量。但在某些特定的条件下，对领示矢量的选取条件可以放宽为只需遵循Morse-Feshbach判据即可。     

基于有限差分光束传播法的过渡波导功耗分析

为了在既定尺寸下减小斜坡波导和弯曲波导的功耗，设计了4种过渡波导形状函数。用有限差分光束传播法(FD-BPM)进行了模拟分析，发现过渡波导形状的选取与坡度和曲折角存在条件有关，并给出了条件表达式及其详细说明。     

THE LARGE TIME BEHAVIOR OF SPECTRAL APPROXIMATION FOR A CLASS OF PSEUDOPARABOLIC VISCOUS DIFFUSION EQUATION

The asymptotic behavior of the solutions to a class of pseudoparabolic viscous diffusion equation with periodic initial condition is studied by using the spectral method. The semidiscrete Fourier approximate solution of the problem is constructed and the error estiation between spectral approximate solution and exact solution on large time is also obtained. The existence of the approximate attractor AN and the upper semicontinuity d(AN,A)→0 are proved.     

采用级联原子滤光器的新型卫星激光链路系统研究

提出级联佛克脱型原子滤光器(Linked VADOF)的新构想。从理论上分析并计算了级联佛克脱型原子滤光器的透射谱。结果表明，级联佛克脱型原子滤光器将佛克脱型原子滤光器的多峰改造为单峰结构，具有比佛克脱型原子滤光器更窄的线宽和更高的噪声抑制比。将这种新型结构应用于激光信标锁频。该锁频方案提高了信标光频率的稳定性。在此基础上，给出了发射端采用级联佛克脱型原子滤光器锁频，接收端采用法拉第型原子滤光器(FADOF)滤光的新型卫星激光链路系统。外场初步联调实验表明了该系统的可行性。     

Martingale property of empirical processes

It is shown that for a large collection of independent martingales, the martingale property is preserved on the empirical processes. Under the assumptions of independence and identical finite-dimensional distributions, it is proved that a large collection of stochastic processes are martingales essentially if and only if the empirical processes are also martingales. These two results have implications on the testability of the martingale property in scientific modeling. Extensions to submartingales and supermartingales are given.

     

飞秒激光脉冲在三能级有机分子介质中传播时的频谱分析

通过采用预估校正的时域有限差分法求解麦克斯韦-布洛赫方程,我们研究了飞秒激光脉冲在三能级有机分子(4,4-二甲氨基二苯乙烯分子)介质中传播时脉冲的频谱演化情况.在单光子共振情况下,即入射脉冲频率等于1、2能级之间的共振频率,对大面积入射脉冲,由于强的二次激发的作用,电场频谱中出现了在ω32附近振荡的频率成分,ω32是2、3能级之间的共振频率,说明对大面积入射脉冲二能级模型已经失效,需要采用多能级模型来描述分子介质.在双光子共振情况下,即入射脉冲频率等于1、3能级之间的共振频率的一半,由于介质中放大的自发辐射和四波混频的作用,部分入射脉冲能量转化为高频和低频电场成分的能量,分子介质表现出了很强的光功率限幅特性.     

Chemical Reactions in the Manufacture of Waveguides for Long Distance Optical Data Transmission

One of the modern high technologies which has advanced enormously in the last few years is glass fiber technology. This is used in the manufacture of glass fibers for lighting purposes and for the optical transfer of analog and digital data with a high transfer density. The technical demands made on the glass fibers required for data transfer, the optical waveguides, are extremely high and are already fulfilled to a large extent by industry. At present about four million kilometers of fiber, worth ca. 800 million DM are produced worldwide (10% in the Federal Republic of Germany). Numerous chemical processes take place during the manufacture of optical waveguides. However, in contrast both to the high and constantly growing demands on the quality and to the increasing production volume of such fibers, little is in fact known about the reactions involved. The present article will attempt to develop a picture of the multifarious reactions occurring in the course of this technical process on the basis of literature data and our own studies.     

Novel fiber-optic biosensor based on immobilized glutathione S-transferase and sol–gel entrapped bromcresol green for the determination of atrazine

The aim of this work was to investigate, for the first time, the potential of the enzyme glutathione S-transferase I (isoenzyme GST-I) for uses in analytical chemistry. A novel fiber-optic biosensor for the detection and determination of the triazine herbicide atrazine was developed based on maize GST-I expressed in E. coli. The sensing bioactive material was a three-layer mini-sandwich. The enzyme was immobilized on the outer layer that consisted of a hydrophilic polyvinylidenefluoride membrane. This membrane was supported on an inner glass disk by means of an intermediate binder sol–gel layer that incorporated bromcresol green (BCG). The biosensor operated in a static mode at 25 °C and the rate of the enzymatic reaction, using atrazine as a substrate, served as an analytical signal. A calibration curve was obtained for atrazine, with analytically useful concentration range 2.52–125 μM. The sensor detection limit was 0.84 μM. The reproducibility of atrazine sensing was in the order of ±3–5%. The method was successfully applied to the determination of this herbicide in real water samples, without sample preparation steps. Atrazine recovery ranged between 85 and 110%. No interference from other pesticides, such as alachlor and carbaryl was observed in the absence of atrazine. The immobilized enzyme retained about 75% of its original activity after 1 month use. Simply unscrewing the terminal holding ring of the probe and placing a new bioactive sandwich could easily replace a deteriorated mini-sandwich.     

Two-photon absorption in quadrupolar pi-conjugated molecules: influence of the nature of the conjugated bridge and the donor-acceptor separation

Quadrupolar-type substitution of pi-conjugated chromophores with donor and acceptor groups has been shown to increase their two-photon absorption (TPA) response by up to two orders of magnitude. Here, we apply highly correlated quantum-chemical calculations to evaluate the impact of the nature of conjugated bridge and the charge-transfer distance on that enhancement. We compare chromophores with phenylenevinylene-, thienylenevinylene-, polyene-, and indenofluorene-type backbones substituted by dimethylamino and cyano groups. In all compounds, we find a strongly TPA-active A(g) state (either 2A(g) or 3A(g)) in the low-energy region, as well as a higher lying TPA-active state (mA(g)) at close to twice the energy of the lowest lying one-photon allowed state; the smaller energy detuning in the mA(g) states results in very large TPA cross sections delta. We also investigate the influence of the degree of ground-state polarization on TPA. Independent of the nature of the backbone and the donor-acceptor separation, delta displays the same qualitative evolution with a maximum before the cyanine-like limit; the highest TPA cross sections are calculated for distirylbenzene- and polyene-based systems.     

Structural dependence of non-linear optical properties of 4-Dimethylamino-3-cyanobiphenyl

 4-Dimethylamino-3-cyanobiphenyl (4-DMA-3-CB) was characterized with respect to linear and nonlinear optical properties in a crystal as well as in solution. The crystal structure was studied dependent on the crystallization conditions. It is shown that the crystal structure exhibiting NLO-activity can completely be solved by a combination of electron diffraction and computer modeling. There are four molecules per unit cell in the space group Pna2₁ with dimensions a=10.28 Å, b=22.64 Å, c=5.27 Å. From this model structure the values and orientation of the dipole μ and static second order polarizability β can be calculated. Their relevance to the values obtained by a combination of polarization dependent measurements of Electric Field Induced Second Harmonic Generation (EFISH) and Hyper-Rayleigh-Scattering (HRS) in solution are discussed. The molecular second order polarizability tensor was found to be dominated by one single component. The orientations of the dipole and the vectorial parts of the second order polarizability delivered by the semiempirical calculations are in good agreement with the results of the EFISH and HRS-measurements and allow a deeper insight into the nonlinear optical properties of the crystal. Received: 15 April 1996 Accepted: 21 June 1996