Electromagnetic properties of manganese-zinc ferrite with lithium substitution

Polycrystalline manganese-zinc ferrite with lithium substitution of composition Li_0.5xMn_0.4Zn_0.6−xFe_2+0.5xO₄ (0.0≤x≤0.4) was prepared by the usual ceramic method. X-ray diffraction analysis confirmed that the samples have a spinel structure and are of single phase for some values of Li content. Lithium doping considerably modifies saturation magnetization since its value increases from 57.5 emu/g for x=0.0 to 82.9 emu/g for x=0.4. Lithium inclusion increases the real permeability (over 1 MHz) while the natural resonance frequency shifts to lower values as the fraction of Li increases. These ferrites show good electromagnetic properties as absorbers in the microwave range of 1 MHz - 1 GHz.     

Improvement in magnetic properties of La substituted BaFe12O19 particles prepared with an unusually low Fe/Ba molar ratio

In this study, effect of lanthanum substitution on the phase composition, lattice parameters and magnetic properties of barium hexaferrite has been studied in samples synthesized in ammonium nitrate melt. Samples, prepared with different lanthanum amount and having various initial Fe/(Ba+La) ratios in between 12 and 2 {(Ba_1−xLa_x)·n Fe₂O₃, where 0≤x≤1 and 1≤n≤6)}, are sintered at temperatures from 800 to 1200 °C. The lattice parameters, both a and c, decreases with increasing La amount which results in a decrease of the unit cell volume. The scanning electron microscope micrographs show that the pure and La-substituted sample with x=0.3, both calcinated at 1000 °C, have grain sizes smaller than 1 μm. The coercivities of the La-substituted samples increase with increasing La amount and reaches to a maximum value of 5.73 kOe, when x=0.3. Sintering at higher temperatures (above 1000 °C) decreases the coercivity, resembling a transition from single to multi-domain behavior of the particles, while saturation magnetization of the samples continues to increase due to the increasing grain size. Magnetization measurements of the samples prepared with different Fe/(Ba+La) molar ratios, n's, revealed that the specific saturation magnetization slightly increases with decreasing n, while coercivities fluctuates around 5.5 kOe. However, a sharp increase in the saturation magnetization has been observed in the sample having n=1 and washed in HCl. It was measured as 59.2 emu/g at 15 kOe, which is higher than that of the pure sample (57.5 emu/g). Thus, the magnetic parameters are optimized in the sample Ba_0.7La_0.3Fe₁₂O₁₉ so as to maximize both coercivity and specific saturation magnetization in the HCl-washed sample synthesized by starting with an unusually low Fe/(Ba+La) molar ratio of 2 (or n=1).     

Influence of citric acid on the morphology and magnetic properties of barium ferrite thin films

Hexagonal barium ferrite (BaFe₁₂O₁₉) thin films were fabricated by spin coating of precursors from sol-gel methods. Different amount of citric acid was added. Weight loss and changes of chemical bonds during the heat treatment below 500 °C were recorded by thermogravity analyzer and Fourier transform infrared spectroscopy, respectively. The morphology of the films, i.e. the amount of acicular crystallites in the film, was controlled by adjusting the quantity of citric acid. The X-ray diffraction shows that the films are c-axis oriented, but the crystallization is less perfect with the increase of the citric acid. With the increase of the citric acid, the percentage of the acicular crystallites increased. At the same time, the coercivity force increased. The acicular crystallites were not exchange-coupled to the platelet crystallites. The citric acid was understood to form complex with iron ions and accelerate the exothermal auto-combustion. The c-axis oriented growth of the film was thus deteriorated.     

Effect of MgO additive on the high-frequency properties of Z-type hexaferrites

MgO was introduced into low-temperature sintered Z-type hexaferrites in order to improve their high-frequency electromagnetic properties. In the doped samples the major Z-type phase coexists with a small amount of W-type magnetoplumbite phase. The addition of MgO causes a decrease of the average grain size and an increase of the magnetocrystalline anisotropy (K₁) and the saturation magnetization (M_s) with the increment of K₁ being larger than that of M_s. These factors result in a reduce of the initial permeability. Also, the samples with MgO additive exhibit higher Q-factor and dc resistivity. Furthermore, the introduction of MgO can decrease the dielectric constant and improve the dielectric loss tangent of the samples by reducing the electronic transition in octahedral site (B-site) between Fe²⁺ and Fe³⁺ ions.     

Carbon dioxide reforming of methane on monolithic Ni/Al2O3-based catalysts

Nickel-alumina catalysts supported on cordierite monoliths of honeycomb structure surpass essentially the conventional granulated ones with respect to the output in carbon dioxide reforming of methane. Adjusting the surface acid-base properties of catalysts by introduction of alkali metal (Na, K) oxides inhibits the carbonization and as a result, improves the operational stability of these catalysts. An effect of promotion of nickel-alumina based composite doped by lanthanum oxide is found. This effect, caused by an additional route for the CO2 activation on Ni-La2O3/Al2O3/cordierite catalyst, is displayed in increase of methane conversion under conditions of an oxidant excess.     

Synthesis of NiFe2O4 Powders Well Defined in Size and Morphologies

The uniform NeFe2O4 powders with different particle size and morphologies (octahedral, cubic and spherical) have been prepared from different precursors via hydrothermal process. The nanocrystallines derived from precursor B in the weak alkali solution (pH≥10) are superparamagnetic.     

铈对纳米铁氧体粉末电磁学性质影响的研究

采用固相反应制备的Ce0 .2 5FeNiO3,FeNiO5,Fe3O4 ,Fe2 O34种纳米粉体 ,在 1～ 2 0 0 0MHz范围内进行了电磁学性质 (μ′,μ″ ,ε′,ε″)及吸波特性的比较研究。发现 4种纳米粉体的 μ′数据大小顺序为Ce0 .2 5FeNiO3>FeNiO5>Fe3O4 >Fe2 O3,μ″的变化幅度为Ce0 .2 5FeNiO3>Fe3O4 >FeNiO5>Fe2 O3。Ce0 .2 5FeNiO3的ε′和ε″的变化幅度大于其他几种纳米粉体。结果表明 ,加入稀土铈的铁氧体纳米粉体性能优于其他几种材料