Simulation of viscous water column collapse using adapting hierarchical grids

An adaptive hierarchical grid‐based method for predicting complex free surface flows is used to simulate collapse of a water column. Adapting quadtree grids are combined with a high‐resolution interface‐capturing approach and pressure‐based coupling of the Navier–Stokes equations. The Navier–Stokes flow solution scheme is verified for simulation of flow in a lid‐driven cavity at Re=1000. Two approaches to the coupling of the Navier–Stokes equations are investigated as are alternative face velocity and hanging node interpolations. Collapse of a water column as well as collapse of a water column and its subsequent interaction with an obstacle are simulated. The calculations are made on uniform and adapting quadtree grids, and the accuracy of the quadtree calculations is shown to be the same as those made on the equivalent uniform grids. Results are in excellent agreement with experimental and other numerical data. A sharp interface is maintained at the free surface. The new adapting quadtree‐based method achieves a considerable saving in the size of the computational grid and CPU time in comparison with calculations made on equivalent uniform grids. Copyright © 2005 John Wiley & Sons, Ltd.     

Stress-Strain State in the Zone of Load Transfer in a Composite Specimen under Uniaxial Tension

The stress-strain state in the zone of load transfer in a uniaxially stretched specimen made of a unidirectional epoxy carbon-fiber-reinforced plastic (CFRP) is investigated. A parametric analysis of the influence of geometric and mechanical characteristics of the specimen on its stress-strain state is performed by means of finite-element modeling. The parameters allowing us to significantly reduce the dangerous concentration of transverse and tangential stresses are revealed. The mechanical tensile characteristics of a high-strength pultruded unidirectional CFRP are determined experimentally, and the size effect of its strength is estimated.     

Energy Spectrum Width and Nonequilibrium Energy of Rayleigh Waves Scattered on a Two-Dimensional Near-Surface Electron Layer

We obtain expressions for the energy spectrum widths of Rayleigh waves corresponding to their deformational coupling to Fermi and Boltzmann electrons in a two-dimensional layer near the surface of a semibounded solid. We evaluate the nonequilibrium energy of Rayleigh waves that depends on these widths and is caused by the same coupling to the corresponding hot electrons. We show that this energy is independent of the degeneracy degree of the electrons and is given by the mean energy of free Rayleigh waves heated up to temperature of the electrons. We find conditions under which the thermodynamics is determined by this nonequilibrium energy of Rayleigh waves in films of a certain thickness with Fermi electrons near the surface and by the equilibrium energy of bulk phonons in thicker samples. All the results are obtained using the Keldysh diagram technique applied to the case of semibounded media.     

Ultraslow phonon-assisted collapse of tubular image states

We predict ultraslow collapse of “tubular image states” (TIS) on material surfaces. TIS are bound Rydberg-like electronic states formed at large distances (∼30 nm) from the surfaces of suspended circularly-symmetric nanowires, such as metallic C nanotubes. The states are formed in potential wells, resulting from a combination of the TIS-electron attraction to image charges in the nanotube and its centrifugal repulsion, caused by spinning around the tube. We demonstrate that TIS can collapse on the tube surface by passing their angular momentum l to circularly polarized flexural phonons excited in the tube. Our analysis shows that for highly detached TIS with l ? 6 the relaxation lifetimes are of the order of 10 ns-1 μs, while for l < 6 these lifetimes are reduced by several orders of magnitude.     

164Lu的三轴超形变核态的理论计算

用三维TRS(totalrouthiansurface)自洽理论对奇奇核164Lu的位能面进行了计算,计算结果与实验上得到的ε2=0.38基本一致,从而从理论上确认了164Lu是三轴超形变核,并且指出了存在三轴超形变带的两个组态. Total routhian surface in~(164)Lu nuclei is calculated according to the three dimensional Total Routhian Surface (TRS) theory. The result of the calculation is in agreement with the experiment. At the same time, two TSD bands could be assigned to the configuration(π\(1/2), α=1/2)(ν\(5/2), α=1/2), (π\(1/2), α=1/2)(ν\(3/2), α=-1/2).     

一维粗糙表面散射特征的数值分析

使用Monte Carlo模拟的方法得出了随机粗糙表面，在Kirchhoff近似的基础上，利用数值分析的方法分析了一维随机粗糙表面的散射特征，得出了一维随机粗糙表面散射分布曲线，我们还考虑了遮蔽效应的影响，并且讨论了Kirchhoff近似的有效性。     

纳米氧化钛-乙二醇溶胶溶液的研究

选用了钛酸丁酯、硬脂酸和乙二醇作为表面活性剂，采用表面化学修饰和表面物理修饰2种方法修饰纳米氧化钛，然后分散在乙二醇溶剂中形成溶胶溶液．并通过红外光谱仪、紫外分光计、原子力显微镜，分析了表面化学修饰后的纳米氧化钛表面化学结构的变化，观测了纳米氧化钛溶胶在乙二醇溶剂中稳定性．试验结果表明表面活性剂与纳米氧化钛的表面的不饱和键之间形成了新的化学结构，粒子表面可能接枝上有机长链，提高了纳米粒子在溶剂中的相容性．表面化学修饰后的纳米氧化钛与乙二醇溶剂形成了较稳定的溶胶体系，而且纳米溶胶粒径较小．表面活性剂添加量与纳米粒子添加量控制在(1～1．2)：1时，可以获得纳米溶胶粒径较小，同时溶胶稳定性较好的纳米氧化钛-乙二醇溶胶体系．     

Experimental investigation of time-dependent cavitation in an oscillatory squeeze film

The occurrence of time-dependent cavitation and tensile stress in an oscillatory oil squeeze film were investigated experimentally. The test apparatus was a simple thrust bearing consisting of two parallel circular plates separated by a thin viscous oil film. During the test, one plate was at rest while the other (transparent) oscillated in a direction normal to its surface. This test configuration was chosen to avoid the rotational motion and complicated geometry of a squeeze film journal bearing. The frequency of oscillation was in the range of 5 to 50 Hz and was controlled by an electro-magnetic exciter. The process of cavity formation and its subsequent development was recorded by a high-speed video camera. Concomitant pressure in the oil film was measured both within and without the cavitation region. It was found that both tensile stress and cavities existed in a squeeze film under certain working conditions.     

Generating Quadratic Pseudo-Anosov Homeomorphisms of Closed Surfaces

In this note, we show that given a closed, orientable genus-g surface S _g , any hyperbolic toral automorphism has a positive power which induces a quadratic, orientable pseudo-Anosov homeomorphism on S _g . To show this, we lift Anosov toral automorphisms through a ramified topological covering and present the lifted homeomorphism via a standard set of Lickorish twists. This construction provides a general method of producing pseudo-Anosov maps of closed surfaces with predetermined orientable foliations and quadratic dilatation. Since these lifted automorphisms have orientable foliations, this construction is a sort of converse to that of Franks and Rykken [Trans. Amer. Math. Soc. 1999], who established that one can associate to a quadratic pseudo-Anosov homeomorphism with oriented unstable foliation a hyperbolic toral automorphism.     

浮栅ROM器件辐射效应机理分析

分析了浮栅ROM器件的辐射效应机理，合理地解释了实验中观察到的现象.指出辐射产生的电子空穴对在器件中形成的氧化物陷阱电荷和界面陷阱电荷是导致存储单元及其外围电路出现错误的原因.浮栅ROM器件的中子、质子和⁶⁰Co γ辐射效应都是总剂量效应 . 关键词： FLASH ROM EEPROM 中子 质子 60Co γ')" href="#">⁶⁰Co γ 总剂量效应