Experimental and numerical study of the effect of conjugate heat transfer on film cooling

Combined convection heat transfer and thermal conduction for film cooling of a flat plate with 45° ribs on one wall was investigated experimentally and numerically. The flat plate surface temperature was measured using thermochromic liquid crystals. The results show that the film cooling is the main mechanism for the local cooling with a very low thermal conductivity while the convection heat transfer of the coolant in the coolant channel is the dominant heat transfer mechanism for the high thermal conductivity plate, with both film cooling and convection heat transfer by the coolant being important with medium thermal conductivity walls.     

激光冷却OH分子的理论研究

采用高精度的多参考组态相互作用方法计算OH分子基态和第一激发态的势能曲线.为获得更精确的计算结果,在计算过程中考虑Davidson修正、标量相对论效应、核价相关效应和自旋轨道耦合效应.基于计算的Λ-S和?态的势能曲线,对一维径向薛定谔方程进行数值求解,得到各个电子态的光谱数据,与已报道的实验值和理论值相符合.获得OH分子的永久偶极矩、跃迁偶极矩、振动能级、Franck-Condon因子及辐射寿命,结果表明,A~2Σ~+→X~2Π跃迁具有高度对角化的Franck-Condon因子(0.9053)和短的辐射寿命(5.8363×10~(-7)s),符合激光冷却分子的条件.制定了激光冷却OH分子的具体方案,计算得到激光冷却跃迁A~2Σ~+→X~2Π所需的三束激光波长,主光束波长为307.1532 nm,两束重抽运激光波长为344.9163和349.7659 nm.计算结果为超冷OH分子的实验制备提供重要的理论依据.     

Determination of the thermal noise limit in test of weak equivalence principle with a rotating torsion pendulum

Thermal noise is one of the most fundamental limits to the sensitivity in weak equivalence principle test with a rotating torsion pendulum. Velocity damping and internal damping are two of many contributions at the thermal noise, and which one mainly limits the torsion pendulum in low frequency is difficult to be verified by experiment. Based on the conventional method of fast Fourier transform, we propose a developed method to determine the thermal noise limit and then obtain the precise power spectrum density of the pendulum motion signal. The experiment result verifies that the thermal noise is mainly contributed by the internal damping in the fiber in the low frequency torsion pendulum experiment with a high vacuum. Quantitative data analysis shows that the basic noise level in the experiment is about one to two times of the theoretical value of internal damping thermal noise.     

光学元件损伤在线检测图像处理技术

针对光学元件损伤图像中损伤区域的高精度检测问题,对内全反射照明下光学元件损伤图像的处理技术进行了研究。根据在线检测图像中损伤区域中心峰值的信号强度高于局部背景的信号强度这一特点,利用高斯滤波器生成待检测图像的局部信号强度比图像,实现了对损伤区域的低漏检率自动定位;根据CCD的成像原理,利用辐射标定的方法建立起损伤区域的尺寸与其在图像中总灰度的关系方程,实现了损伤区域的亚像素高精度尺寸测量。实验结果表明,与传统的光学元件损伤图像处理算法相比,本文提出的算法在保持低漏检率的同时大大提高了损伤区域的测量精度。     

射流注入角对平板气膜冷却特性影响的实验研究

本文对不同射流注入角的典型单排孔冷却结构的平板气膜冷却特性进行了实验研究,研究对象为轴线与主流来流方向分别成30°、60°、90°的射流孔板,对它们在吹风比为0.5、1.0、1.5条件下的射流孔下游的绝热气膜冷却效率分布特性进行了分析.在吹风比M=0.5时,三个射流注入角条件下近孔区域都能形成较好的冷气覆盖效果;M=1.0时,三者的下游横向平均冷却效率基本相同;M=1.5时,注入角60°的条件下冷却效果最好.     

全内反射式衍射光栅近场光学特性

 利用傅里叶模式理论分析了具有高衍射效率的全内反射式衍射光栅在TE 和TM偏振态下的近场光分布特点,讨论了光栅结构参数以及入射角度对光栅内电场增强的影响。结果表明：全内反射光栅内部电场分布对偏振态较敏感,光栅槽深和占宽比对电场增强影响较小,光栅内的峰值电场随光栅周期增大而增大,并且峰值电场随着入射角度的增大而减小。在应用于高功率激光时,降低光栅内部的电场增强可以有效降低损伤风险。     

全内反射瞬逝场照明高精度磁镊及其在DNA解旋酶研究中的应用

传统磁镊的测量精度受限于磁球的布朗涨落, 当磁力小于约10 pN时, 磁球的布朗涨落明显增大, 对应磁镊的空间分辨率显著下降. 为了提高传统磁镊在小力条件下的测量精度, 本文将全内反射荧光技术引入到磁镊技术中, 并建立相适应的“磁球-手柄-荧光微球-待测生物分子”单分子连接系统, 在小力条件下(小于10 pN)获得纳米量级的测量精度. 应用改进的磁镊对DNA发卡的折叠-去折叠态的转变过程进行了研究, 依据DNA发卡的折叠-去折叠态转变的性质对全内反射场的穿透深度进行了校正, 并结合实验结果对改进后的磁镊的测量精度进行分析. 观察了Bloom解旋酶的解旋动力学过程, 获得初步实验结果, 证实了改进的磁镊在单分子研究中的实用性. 关键词： 磁镊 全内反射荧光 DNA发卡 解旋酶     

Thermal modeling optimization and experimental validation for a single, concentrator solar cell system with a heat sink

A single concentrator solar cell model with a heat sink is established to simulate the thermal performance of the system by varying the number, height, and thickness of fins, the base thickness and thermal resistance of the thermal conductive adhesive. Influence disciplines of those parameters on temperatures of the solar cell and heat sink are obtained. With optimized number, height and thickness of fins, and the thickness values of base of 8, 1.4 cm, 1.5 mm, and 2 mm, the lowest temperatures of the solar cell and heat sink are 41.7℃ and 36.3℃ respectively. A concentrator solar cell prototype with a heat sink fabricated based on the simulation optimized structure is built. Outdoor temperatures of the prototype are tested. Temperatures of the solar cell and heat sink are stabilized with time continuing at about 37℃-38℃ and 35℃-36℃ respectively, slightly lower than the simulation results because of effects of the wind and cloud. Thus the simulation model enables to predict the thermal performance of the system, and the simulation results can be a reference for designing heat sinks in the field of single concentrator solar cells.     

The HITRAP project at GSI: trapping and cooling of highly-charged ions in a Penning trap

A decelerator will be installed at GSI in order to provide and study heavy nuclei without or with only few electrons at very low energies or even at rest. Highly-charged ions will be produced by stripping at relativistic energies. After electron cooling and deceleration in the Experimental Storage Ring (ESR) the ions are ejected out of the storage ring at 4 MeV/u and further decelerated in a combination of linear accelerator structures operated in reverse. Finally, they are injected into a Penning trap where the ions are cooled to 4 K by electron cooling in combination with resistive cooling. From here, the ions can be transferred in a quasi DC or in a pulsed mode to different experimental setups. This article describes the technical concepts of this project focused on the Penning trap.      

Microwave spectrum and structure of methyl phosphonic difluoride

The rotational spectrum of methyl phosphonic difluoride has been reinvestigated using a pulsed-molecular-beam Fabry-Perot cavity microwave spectrometer. The enhanced resolution of the Fourier transform microwave (FTMW) spectrometer (compared to the original work done in a conventional Stark spectrometer) has allowed the measurement of small A-E splittings of many of the rotational transitions caused by the internal rotation of the methyl top. The barrier to internal rotation, V₃ = 676 (25) cm⁻¹, has been determined experimentally from the A-E splittings of the rotational transitions in the ground vibrational state. This barrier height is substantially lower than the previously determined value for the barrier, which was 1252 (14) cm⁻¹. High-level ab initio calculations at the MP2/aug-cc-pVTZ level predict a barrier to internal rotation of 638 cm⁻¹, in agreement with the experimentally determined value found here. The high sensitivity of the FTMW spectrometer has also permitted the measurement of the ¹³C and ¹⁸O isotopomers in natural abundance. The addition of these two isotopomers has allowed an improved structural determination.