CALCULATING THE MOLECULAR INTERNAL ROTATING STERIC FACTOR OF POLYMERS BY THE RADIATION CROSSLINKING METHOD

In this paper, calculating the molecular internal rotating steric factor of polymers by the radiation crosslinking method is studied and a relationship between the molecular internal rotating steric factor (σ) and crosslinking parameter βis established~([1]) by taking account of the effect of polymer chain flexibility on βvalue, σvalue of polymer obtained by this method is in agreement with that given with other method.     

主动冷却点阵夹层防热结构温度响应计算模型北大核心CSCD

针对点阵夹层结构主动热防护问题,建立了夹层结构面板和芯体导热与冷却剂对流耦合的非稳态传热理论模型,利用有限体积法离散控制方程并在MATLAB中进行了迭代求解.模型首次考虑了面板与夹芯杆之间的收缩热阻,并利用分离变量法得到了收缩热阻的近似解析解.基于单胞模型和周期性边界条件,模拟得到了模型所需的表面对流传热系数h_(b)和h_(fin).最后,选取多单胞计算工况进行数值模拟和理论模型对比,并讨论了收缩热阻对模型预测精度的影响.结果表明:理论模型能够准确预测夹层结构及内部流体的温度变化,理论与仿真之间的最大误差不超过1%;随着外加热流密度不断增大,忽略收缩热阻使得计算结果造成的误差不断增大;与数值模拟相比,理论模型可显著地减少计算时间并节省计算资源,尤其适用于非均匀、非稳态复杂热载荷下点阵夹层结构的温度响应计算.     

HYPERFINITE TRANSVERSAL THEORY. II

We continue the investigation of validity of Hall's theorem in the case of the Loeb space of an internal, uniformly distributed, hyperfinite measure space initiated in1992 by the author. Some new classes of graphs are introduced for which the measure theoretic version of Hall's theorem still holds.

     

低温低内应力化学镀镍工艺的研究

化学镀广泛应用于非金属的电镀、电铸前的施加导电层。化学镀沉积层质量与其在零件上的附着力有着密切的关系 ,重视对化学镀沉积层内应力的研究 ,开发一个低温、低内应力的化学镀镍工艺 ,对于化学镀沉积层的推广应用有着十分重要的意义。本文采用正交实验方法对低温、低内应力化学镀镍工艺进行了系统研究 ,开发出了一个低温、低内应力的化学镀镍工艺。在实验过程中发现沉积层内应力同其在零件上的结合力具有密切关系并对其进行了初步探讨。1　实验方法1 1　正交实验根据探索性实验结果分析 ,影响化学镀镍层内应力σ和沉积层速率ｒ的主要因…     

Evaluation of the calibration errors on cooling of a differential scanning calorimeter using different sets of standard metals

The temperature calibration on cooling of thermal analysis instruments is important for the accurate study of the non-isothermal crystallization kinetics of semi-crystalline polymers. In previous works, a methodology was proposed for performing the calibration on cooling of differential scanning calorimeters (DSCs) with standard metals, and the calibration errors were checked using transitions of high-purity liquid crystals. In this work, alternative, physically meaningful, procedures for carrying out the calibration on cooling are analyzed and validated. The calibration errors are evaluated also with liquid crystalline transitions, when the calibration is performed with standard metals, in a wide temperature range, and when due account is taken for the need of isothermal corrections to the temperature measurements. It is shown that any pair of standard metals may be used to calibrate on cooling, that the calibration errors increase for wider working temperature ranges and that, providing that certain conditions are fulfilled, both calibration procedures yield similar results.     

Technological quality determination of pharmaceutical disintegrant by DSC cooling and DSC photovisual

A number of disintegrants are available on the market. They improve tablets’ disintegration. The objective of this work is the comparison of the technological quality parameters of disintegrants using different analytical techniques. Three batches of disintegrants and their binary mixtures (water:disintegrants) were investigated. Cooling experiments were used from –30 up to 200°C. The data obtained showed calorimetric differences between the samples. In the binary mixtures water showed different crystallization behaviour from the one found in the literature. According to the results DSC technique helped the quality control of different disintegrants.     

Antibody synthesis induced by endogenous internal images

In this study, immunization with a vaccine consisting of multiple F(abt’)₂ fragments of affinity-purified antitetanus toxoid antibodies covalently bound to a carrier protein successfully induced antitetanus toxoid antibodies. Further studies showed that this vaccine preparation contained no biologically detectable tetanus antigen. The induced antitetanus antibody (Ab1t’) titer was higher than the titer of antibodies binding control antigens. The immunizing F(abt’)₂ preparation did not elicit a secondary antitetanus response from mice primed with tetanus toxoid and, hence, appeared free of tetanus epitopes. The specificity of Ab1t’ was established by absorption and inhibition with antigen. Immunization with antitetanus F(abt’)₂ (Ab1t’) fragments appears to have elicited naturally occurring autologous antitetanus toxoid antibody (Ab1t’) through an idiotypic pathway. As predicted by network theory, anti-idiotype (Ab2) and antitetanus (Ab1t’) cycled reciprocally. Clonotypic characterization of Ab1t’ using isoelectric focusing and affinity immunoblotting showed increases in Ab1t’ titer to be the result of increased synthesis by limited subsets of antitetanus toxoid B-cell clones and not increased synthesis by multiple clones, as is characteristic of antigen-driven Ab1 responses. Many Ab1 and Ab1t’ clonotypes had identical pIs, suggesting that they either share V region genes or are the product of the same B-cell clones. These findings indicate that immunization with polyclonal multivalent Ab1 preparations can trigger active synthesis of antibodies with the same specificity. The results provide further evidence for naturally occurring idiotypic cascades that could be exploited for studies of catalytic antibodies.     

Using the diphosphanyl radical as a potential spin label: effect of motion on the EPR spectrum of an R1(R2)P--PR1 radical

The EPR spectrum of the novel radical Mes*(CH3)P--PMes* (Mes*=2,4,6-(tBu)3C6H2) was measured in the temperature range 100-300 K, and was found to be drastically temperature dependent as a result of the large anisotropy of the 31P hyperfine tensors. Below 180 K, a spectrum of the liquid solution is accurately simulated by calculating the spectral modifications due to slow tumbling of the radical. To achieve this simulation, an algorithm was developed by extending the well-known nitroxide slow-motion simulation technique for the coupling of one electron spin to two nuclear spins. An additional dynamic process responsible for the observed line broadening was found to occur between 180 K and room temperature; this broadening is consistent with an exchange between two conformations. The differences between the isotropic 31P couplings associated with the two conformers are shown to be probably due to an internal rotation about the P--P bond.     

The length of the polymethine chain and the spectral-luminescent properties of symmetrical cyanine dyes

The general characteristics that relate the length of the polymethine chain of symmetrical cyanine dyes to their spectral-luminescent properties depending on the electron-donor character of the heterocycles and the nature of the solvent are formulated. For various types of symmetrical cyanines, the Stokes shifts decrease with the elongation of the polymethine chain due to weakening of the vibronic interactions. The vinylene shifts of the band maxima are essentially constant and fall within the range 100 to 130 nm depending on the nature of the heterocycles and the solvent. When the polymethine chain elongates the fluorescence quantum yields first increase and then decrease. The greater the effective length of the heterocycle the stronger the decrease. The fluorescence decay occurring when the polymethine chain gets longer is associated with intensification of the internal conversion. For symmetrical cyanines, the changes in the shapes of the electronic bands (their width, asymmetry, excess, and fine structure) as the chain elongates are governed by the competing effects of the vibronic and intermolecular interactions. The former decrease as the chain lengthens, causing the narrowing of the absorption bands for the lower vinylogs. On the other hand, the latter increase as chain lengthens, which leads to broadening of the bands for the higher vinylogs. The higher the solvent nucleophilicity and the greater the deviation of the electron-donor ability of the heterocycle from the average value the greater the broadening. Any elongation of the polymethine chain of symmetrical cyanines causes only narrowing of the bands and an increase in the asymmetry, excess, and structuring in the fluorescence spectra, which, unlike the absorption spectra, is independent of the electron-donor character of the heterocycles and the nature of the solvent. These effects are caused by the fact that, in contrast to absorption, changes in the shape of emission bands with increasing chain length are governed predominantly by vibronic rather than by intermolecular interactions.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 7, pp. 1227–1239, July, 1994.