硅光电二极管激光损伤阈值随激光脉宽的变化

 对飞秒激光辐照下硅光电二极管损伤阈值进行了实验测量，对从1s到60fs不同脉宽激光辐照下硅光电二极管损伤阈值进行了讨论。实验数据表明，在1s到10ns脉宽范围内损伤所需能量密度近似而非严格地与脉宽的平方根成正比。信号分析表明硅光电二极管的损伤主要由热效应造成，而60fs激光辐照下的损伤阈值为0.1J/cm2，明显偏离普通温度分布预言的趋势。     

超短脉冲超强激光与固体靶相互作用中高能离子的产生

 用2D3V PIC粒子模拟方法得到了超短脉冲超强激光与固体靶相互作用中高能离子产生的图像，并对其机理进行了研究。在靶前后表面都观察到了高能离子的产生，并诊断了离子能谱。模拟结果表明，在靶前表面所产生的高能离子，角分布较大，在向靶内输运过程中会损失能量；在靶后表面产生的高能离子，定向性很好，能获得很高的能量。模拟得到的离子能量和实验观测结果在量级上相符。     

用于激光推进的高功率激光器的选择

 从激光推进的要求出发，阐述了用于激光推进的高功率激光器的选择原则，即激光器必须满足：（1）高的平均功率和峰值功率；（2）高的单脉冲能量；（3）高的重复频率；（4）优良的大气传输特性。主要分析了目前YAG固体激光器、自由电子激光器和TEA脉冲CO₂激光器的特点，通过上述4个方面性能的比较，认为在目前水平下，TEA脉冲CO₂激光器是进行激光推进的首选强激光源，其优点表现在：功率可达10kW量级，单脉冲能量可达0.5~1kJ，重复频率为20~40Hz；激光波长处于大气传输窗口，对大气变化不敏感；工作物质快速流动，不存在热透镜效应和破坏阈值；相关光学元件易于制造；光束质量较好；运行成本低。     

Performance of a CW pumped Nd:YVO4 amplifier with kHz pulses

Until recently, simple and reliable high repetition-rate laser sources with nanosecond pulses much shorter than from conventional A-O Q-switch lasers were not available. However over the past 2 years we have developed such lasers based on proprietary fast E-O switching technology, which allows designs delivering 1 ns pulses and subnanosecond jitter for good synchronisation. The technology provides pulses with multi-kW peak power and repetition-rates to >100 kHz.Most recently, the performance of these short pulse lasers has been developed further by implementing oscillator/amplifier (master oscillator and power amplifier, MOPA) technology which increases the output to >1 W average power. Here we report on a simple model that has been used to predict the performance of the CW pumped Nd:YVO₄ amplifier used in the MOPA laser. The model is based on the well-known expressions for the saturated gain applying to laser pulses, but more usually applied to pulse-excited amplifiers. The model is shown to allow a good interpretation of the amplifier behaviour for kHz pulses and to be a useful tool for predicting the performance of the MOPA laser.     

氩离子激光器输出光功率稳定度与光反馈应用

通过实验观测氩离子激光器工作电流与输出光功率及其稳定性之间的关系，采用光反馈解决了反馈工作点的设置和跟踪调解，使输出光功率稳定性得到明显提高。     

高速色散补偿系统中喇曼放大器性能研究

利用喇曼放大器的非线性偏微分耦合方程组,对带喇曼放大器的色散补偿系统进行了仿真,并与传统的仿真方法进行了比较.结果表明:在色散完全补偿系统中,当传输速率较高时,忽略色散后的传统仿真方法的结果,与采用色散补偿技术后使整个系统色散为零的仿真结果有一定偏差,此时不能忽略色散的作用.还对前补偿系统和后补偿系统进行了研究,利用Q值性能判别法,分别得到了信号光脉冲的最佳占空比和最佳脉冲阶数.     

激光相位成像雷达的研究

利用无合作目标漫反射激光相位测距的原理,对关键单元技术进行分析和设计,研制成一种用于自主式车辆视觉导引的激光相位成像雷达的原理样机.     

Picosecond control of coherent magnetisation dynamics in permalloy thin films by picosecond magnetic field pulse shaping

We have measured the response of a 20×10 μm, 8 nm thin NiFe (80:20) permalloy film due to excitation by short in-plane magnetic field pulses. We will show that using a two-pulse-technique a complete control of the precessional motion of the magnetisation can be achieved on picosecond timescales. Furthermore, we will present numerical calculations which show that a complete suppression of magnetisation ringing after switching can only be realised by a cascade of short field pulses.     

射流式单重态氧发生器研究

单重态氧O2 (a1Δg)是迄今唯一能用纯化学反应高效产生的具有长寿命的亚稳激发态分子 .为了考察提出的用两个O2 (1Δ)能量汇集反应生成氧第二单重激发态O2 (b1Σ+ g)以实现近可见短波长化学激光方案的现实性 ,设计和实验了一个氯流量为 3～ 10mmol/s的射流式单重态氧发生器 (JSOG) .考察了三种具有不同孔径和孔数目的喷头、氯气流量和脱水冷阱温度等对JSOG出口的O2 (1Δ)浓度、O2 (1Δ)分压、氯利用率及水蒸气含量的影响 .发现用聚氯乙烯管作冷阱时 ,最佳冷阱介质温度为 - 140～ - 15 0℃ ,对此提出了O2 (1Δ)表面脱活与脱水互相竞争的解释 .在最佳条件下 ,可将O2 (1Δ)气中水分压降低至 4Pa ,这一结果是首次报导     

Analysis of far-infrared laser magnetic resonance spectra of CH2Br at 447.3 and 671.1μm

A simple model has been developed to describe the Zeeman patterns of far-infrared laser magnetic resonance spectra of the monobromomethyl radical CH₂Br observed at 447.3 and 671.1μm. A satisfactory agreement between the experimental spectra of the radical and their simulation with this simple model has been achieved. This approach can be used to gain further information about the structure and the spectrum of this interesting radical.