Wake-induced vibrations of an elastically mounted cylinder located downstream of a stationary larger cylinder at low Reynolds numbers

Two-dimensional numerical simulations of flow past two unequal-sized circular cylinders in tandem arrangement are performed at low Reynolds numbers (Re). The upstream larger cylinder is stationary, while the downstream cylinder has both one (transverse-only) and two (transverse and in-line) degrees of freedom (1-dof and 2-dof, respectively). The Re, based on the free stream velocity U_∞ and the downstream cylinder diameter d, varies between 50 and 200 with a wide range of reduced velocities U_r. The diameter of the upstream cylinder is twice that of the downstream cylinder, and the center-to-center spacing is 5.5d. In general, for the 1-dof case, the calculations show that the wake-induced vibrations (WIV) of the downstream cylinder are greatly amplified when compared to the case of a single cylinder or two equal-sized cylinders. The transverse amplitudes build up to a significantly higher level within and beyond the lock-in region, and the U_r associated with the peak amplitude shifts toward a higher value. The dominant wake pattern is 2S mode for Re=50 and 100, while with the increase of Re to 150 and 200, the P+S mode can be clearly observed at some lower U_r. For the 2-dof vibrations, the transverse response characteristics are similar to those presented in the corresponding 1-dof case. The in-line responses are generally much smaller, except for several significant vibrations resulting from in-line resonance. The obvious in-line vibration may induce a C (chaotic) vortex shedding mode for higher Re (Re=200). With regard to the 2-dof motion trajectories, besides the typical figure-eight pattern, several odd patterns such as figure-double eight and single-looped trajectories are also obtained due to the wake interference effect.     

Modelling of fluidelastic instability in a square inline tube array including the boundary layer effect

Flow-induced vibration (FIV) is a design concern in many engineering applications such as tube bundles in heat exchangers. When FIV materializes, it often results in fatigue and/or fretting wear of the tubes, leading to their failure. Three cross-flow excitation mechanisms are responsible for such failures: random turbulence excitation, Strouhal periodicity, and fluidelastic instability. Of these three mechanisms, fluidelastic instability has the greatest potential for destruction. Because of this, a large amount of research has been conducted to understand and predict this mechanism. This paper presents a time domain model to predict the fluidelastic instability forces in a tube array. The proposed model accounts for temporal variations in the flow separation. The unsteady boundary layer is solved numerically and coupled with the structure model and the far field flow model. It is found that including the boundary layer effect results in a lower stability threshold. This is primarily due to a larger fluidelastic force effect on the tube. The increase in the fluidelastic effect is attributed to the phase difference between the boundary layer separation point motion and the tube motion. It is also observed that a non-linear limit cycle is predicted by the proposed model.     

Nonlinear transverse vibrations of a slightly curved beam carrying a concentrated mass

In this study, a slightly curved Euler Bernoulli beam carrying a concentrated mass was handled. The beam was resting on an elastic foundation and simply supported at both ends. Effects of the concentrated mass on nonlin- ear vibrations were investigated. Sinusoidal and parabolic type functions were used as curvature functions. Equations of motion have cubic nonlinearities because of elongations during vibrations. Damping and harmonic excitation terms were added to the equations of motion. Method of mul- tiple scales, a perturbation technique, was used for solving integro-differential equation analytically. Natural frequen- cies were calculated exactly for different mass ratios, mass locations, curvature functions, and linear elastic foundation coefficients. Amplitude-phase modulation equations were found by considering primary resonance case. Effects of nonlinear terms on natural frequencies were calculated. Frequency-amplitude and frequency-response graphs were plotted. Finally effects of concentrated mass and chosen curvature function on nonlinear vibrations were investigated.     

Wake dynamics of external flow past a curved circular cylinder with the free-stream aligned to the plane of curvature

The fundamental mechanism of vortex shedding past a curved cylinder has been investigated at a Reynolds number of 100 using three-dimensional spectral/hp computations. Two different configurations are presented herein: in both cases the main component of the geometry is a circular cylinder whose centreline is a quarter of a ring and the inflow direction is parallel to the plane of curvature. In the first set of simulations the cylinder is forced to transversely oscillate at a fixed amplitude, while the oscillation frequency has been varied around the Strouhal value. Both geometries exhibit in-phase vortex shedding, with the vortex cores bent according to the body's curvature, although the wake topology is markedly different. In particular, the configuration that was found to suppress the vortex shedding in absence of forced motion exhibits now a primary instability in the near wake. A second set of simulations has been performed imposing an oscillatory roll to the curved cylinder, which is forced to rotate transversely around the axis of its bottom section. This case shows entirely different wake features from the previous one: the vortex shedding appears to be out-of-phase along the body's span, with straight cores that tend to twist after being shed and manifest a secondary spanwise instability. Further, the damping effect stemming from the transverse planar motion of the part of the cylinder parallel to the flow is no longer present, leading to a positive energy transfer from the fluid to the structure.     

Effects of axial preload of ball bearing on the nonlinear dynamic characteristics of a rotor-bearing system

This research studies the effects of axial preload on nonlinear dynamic characteristics of a flexible rotor supported by angular contact ball bearings. A dynamic model of ball bearings is improved for modeling a five-degree-of-freedom rotor bearing system. The predicted results are in good agreement with prior experimental data, thus validating the proposed model. With or without considering unbalanced forces, the Floquet theory is employed to investigate the bifurcation and stability of system periodic solution. With the aid of Poincarè maps and frequency response, the unstable motion of system is analyzed in detail. Results show that the effects of axial preload applied to ball bearings on system dynamic characteristics are significant. The unstable periodic solution of a balanced rotor bearing system can be avoided when the applied axial preload is sufficient. The bifurcation margins of an unbalanced rotor bearing system enhance markedly as the axial preload increases and relates to system resonance speed.     

Monoharmonic vibrations and vibrational heating of an electromechanically loaded circular plate with piezoelectric actuators subject to shear strain

The paper addresses the forced flexural vibrations and dissipative heating of a circular viscoelastic plate with piezoactive actuators under axisymmetric loading. A refined formulation of this coupled problem is considered. The viscoelastic behavior of materials is described using the concept of complex moduli dependent on the temperature of dissipative heating. The electromechanical behavior of the plate is modeled based on the Timoshenko hypotheses for the mechanical variables and analogous hypotheses for the electric-field variables in the piezoactive layers of the actuator. The temperature is assumed constant throughout the thickness. The nonlinear problem is solved by a time stepping method using, at each step, the discrete-orthogonalization and finite-difference methods to solve the elastic and heat-conduction equations, respectively. A numerical study is made of the effect of the shear strain, the temperature dependence of the material properties, fixation conditions, and geometrical parameters of the plate on the vibrational characteristics and the electric potential applied to the actuator electrodes to balance the mechanical load Translated from Prikladnaya Mekhanika, Vol. 44, No. 9, pp. 104–114, September 2008.     

Application of nonsmooth transformations to analyze a vibroimpact duffing system

The forced vibrations of an impact Duffing oscillator with one degree of freedom are studied using Zhuravlev's nonsmooth transformation and the multiple-scales method. Detailed consideration is given to the forced vibrations in the domain of resonance family. The stability and bifurcations of periodic vibrations are analyzed Translated from Prikladnaya Mekhanika, Vol. 44, No. 10, pp. 114–121, October 2008.     

环形调液阻尼器振动控制中拍的研究

对环形调液阻尼器减振控制中的拍现象进行研究,分析了环形调液阻尼器对结构纯扭转振动控制中的拍现象,分别考虑无阻尼结构体系、主体结构有阻尼而CTLCD无阻尼的体系及主体结构和CTLCD中均有阻尼的体系,从数学角度对拍现象发生的机理进行解释.研究结构表明,当拍现象发生时,主体结构的振动不仅不会受到抑制,有时反而会加强;当环形调液阻尼器的阻尼增大到一定程度时,拍现象会消失;对于受廹振动,发生拍现象时,由于结构反应的瞬态部分不能得到迅速衰减,结构的瞬态响应将会占结构响应的很大一部分,如果仅考虑结构的稳态响应会带来较大的误差.     

A modified variation–perturbation approach to zero-point vibrational motion

We present a detailed investigation of the perturbation approach for calculating zero-point vibrational contributions to molecular properties. It is demonstrated that if the sum of the potential energy and the zero-point vibrational energy is regarded as an effective potential energy, the leading contribution to the first-order wave function vanishes in the perturbation approach. Two different perturbation approaches have been investigated numerically by calculations of some magnetic properties for a few diatomic molecules and the results obtained have been compared to the exact numerical results. It is shown that only a few terms need to be included in a perturbation expansion to obtain an accuracy in the calculated rovibrational contribution better than the quality normally obtained for the potential and property surfaces in electronic structure calculations. Received: 16 April 1999 / Accepted: 1 July 1999 / Published online: 4 October 1999