溶剂热法制备Ag/TiO2纳米材料及其光催化性能

以乙醇为溶剂, 钛酸四丁酯为前驱体, 用溶剂热法制备了Ag表面修饰的负载型纳米二氧化钛光催化剂. 利用X射线衍射(XRD)、N₂吸附-脱附(BET)、透射电子显微镜(TEM)、X射线光电子能谱(XPS)、紫外-可见(UV-Vis)光谱等技术对其进行了系统的表征, 以亚甲基蓝(MB)溶液的脱色降解为模型反应, 考察了不同Ag含量样品的光催化性能. 结果表明: 用溶剂热法制备的样品中TiO₂皆为锐钛矿相, 金属Ag颗粒沉积在TiO₂表面, 粒径为2 nm左右, 比表面积较溶胶凝胶法制备的样品大大增加, 最高可达151.44 m²·g^-1; UV-Vis光谱和光催化实验表明: Ag修饰使TiO₂对光的吸收能力大大增强, 吸收带边红移至可见光区, 亚甲基蓝在该复合材料上的光催化降解反应遵循一级反应动力学模型; 溶剂热法制备样品的光催化性能明显好于溶胶凝胶法制备的样品, 在紫外光和可见光下, Ag摩尔分数为5%的样品表现出最佳的光催化活性.     

分子筛表面酸性与液相合成乙酸丁酯催化活性的关联

本文用Ｈｓｍｍｅｔｔ指示剂正丁胺滴定法测定ＨＺＳＭ－５分子筛表面酸量按强度的分布并与液相合成乙酸丁酯的催化活性相关联，探明了分子筛催化剂中酸强度为－５．６＜Ｈ０≤－３．０和－３．０＜Ｈ０≤＋３．３范围的酸中心对催化反应的贡献分别为４８％和３３％。将表面酸量按其对反应的贡献折算成有效酸浓度以后，反应的有效酸浓度和反应速度常数之间符合均相酸催化反应的规律，对以ＨＺＳＭ－５分子筛为催化剂在１２０℃下液相     

一维棒状ZnO的制备及电化学嵌锂性能研究

目前,商业化锂离子电池一般采用石墨作为负极材料,因其电位与金属锂电极的电位很接近,所以当电池反复循环和过充时,石墨表面易析出金属锂,会因形成枝晶而短路。在温度过高时还容易引起热失控。同时,锂离子电池的容量在很大程度上取决于负极的锂嵌入量,而且石墨材料容量相对较低     

Multichannel homogeneous immunoassay for detection of 2,4,6-trinitrotoluene (TNT) using a microfabricated capillary array electrophoresis chip

A high-throughput homogeneous immunoassay for the sensitive detection of 2,4,6-trinitrotoluene (TNT) has been developed using radial capillary array electrophoresis microdevices. Samples consisting of equilibrium mixtures of anti-TNT antibody (Ab), fluorescein-labeled TNT, and various concentrations of unlabeled TNT were electrokinetically injected into 48 channels of a radial capillary array electrophoresis microchannel plate. The rapid electrophoretic separation allows us to analyze the equilibrium ratio formed by the competition between the labeled and the unlabeled TNT for Ab binding. The simultaneous parallel TNT separations facilitate determination of a calibration curve for the TNT assay, which has high sensitivity (LOD, 1 ng/mL) and a wide dynamic range (1-300 ng/mL).     

New organogermanium cations [RGe(OCH2CH2NME2)2]+ with intramolecular N→Ge coordination bonds

New organohalogermanes RGe(OCH₂CH₂NMe₂)₂X (R = Ph, X = I (5); R = Me, X = Cl (6) or I (7)) with an intramolecular N→Ge coordination bond were synthesized. According to the ¹H and ¹³C NMR spectroscopic data, iodides 5 and 7 exist in solution as ionic compounds with the pentacoordinated germanium atom. In solution of compound 4 (R = Ph, X = Cl), there is an equilibrium between the ionic and covalent forms. The equilibrium shifts toward the ionic form with increasing solvent polarity or temperature. In solution, chloride 6 is a covalent compound. The structures and relative stabilities of different isomers of compounds 4–7 were studied by quantum chemical calculations at the density functional level of theory. Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 5, pp. 892–900, May, 2007.     

单分散二氧化钛超微粒子的制备

以四丁氧基钛为原料，采用溶胶－凝胶法制备了超微二氧化钛粉末．改变热处理气氛、升温速率、水与四丁氧基钛的摩尔比以及溶剂，分别得到７ｎｍ球形单相锐钛矿以及四方形（４０ｎｍ×１０ｎｍ）、球形（４４ｎｍ）的主相金红石超微粒子．     

Theoretical studies of molecular conformation. II: Application of the SIBFA procedure to molecules containing carbonyl and carboxylate oxygens and amide nitrogens

The SIBFA procedure (Sum of Interactions Between Fragments computedAb initio, Ref [1]) is extended to the study of the conformational behavior of representative molecules containing amide nitrogens and carbonyl and carboxylate oxygens. The molecules studied are C- and N-ethylammonium formamide, C- and N-ethanol-formamide, ethylammonium formate and ethanolformate. The cases investigated include interactions of the types which occur between functional groups in proteins or ionophores. The accuracy of the procedure, assessed by comparing the results to those of correspondingab initio SCF computations, is very satisfactory. An application of the procedure to study the conformation of the glycyl and alanyl dipeptides as a function of the backbone torsional angles and is presented.     

Atomic Force Microscopy Study of TiO2 Films Obtained by the Sol-Gel Method

Atomic Force Microscopy (AFM) was used to study the influence of thermal treatments on the structural and textural properties of the sol-gel TiO2 films obtained from Ti(OC3H7i)4. X-ray diffraction (XRD), ellipsometric and porosity measurements have also been made.The TiO2 sol-gel films were homogeneous, transparent and amorphous. Heat treatments in the 400–600°C range indicate that the films have a strong tendency to crystallization. The high initial homogeneity of the TiO2 films was preserved during the crystallization process. AFM shows that the thermally treated films exhibit uniform, monodispersed crystals.     

Analysis of high-performance liquid chromatography bonded stationary phases using thermogravimetry

A thermogravimetric method was developed for determining the C-18 bonded phase content of reversed phase high performance liquid Chromatographic stationary phases. The method yielded data that were comparable to the sum of carbon and hydrogen content. Excellent agreement between the two methods was achieved by heating the stationary phase samples to 150°C in order to remove adsorbed species prior to elemental analysis.This research stemmed from the author's Master's degree research undertaken at California State Polytechnic University Pomona, and conducted at the Getty Conservation Institute (GCI).The author is greatly indebted to the following colleagues at the GCI for their advice during the course of this project: Neville Agnew, Charles Selwitz, Dusan Stulik and David Scott. The HPLC bonded stationary phase samples were prepared by John Streng, California State Polytechnic University, Pomona.     

Solution of periodic Poisson's equation and the Hartree–Fock approach for solids with extended electron states: Application to linear augmented plane wave method

We formulate a Hartree–Fock‐LAPW method for electronic band structure calculations. The method is based on the Hartree–Fock–Roothaan approach for solids with extended electron states and closed core shells where the basis functions of itinerant electrons are linear augmented plane waves. All interactions within the restricted Hartree–Fock approach are analyzed and in principle can be taken into account. In particular, we obtained the matrix elements for the exchange interactions of extended states and the crystal electric field effects. To calculate the matrix elements of exchange for extended states, we first introduce an auxiliary potential and then integrate it with an effective charge density corresponding to the electron exchange transition under consideration. The problem of finding the auxiliary potential is solved by using the strategy of the full potential LAPW approach, which is based on the general solution of periodic Poisson's equation. Here, we use an original technique for the general solution of periodic Poisson's equation and multipole expansions of electron densities. We apply the technique to obtain periodic potentials of the face‐centered cubic lattice and discuss its accuracy and convergence in comparison with other methods. © 2002 Wiley Periodicals, Inc. Int J Quantum Chem, 2002