Investigation of patch antennas based on crossed idiosyncratic PBG structure

The method of finite difference time domain (FDTD) was used, and characteristics of the patch antenna based on drilling periodic air holes in the substrate were studied, the results indicate that the surface waves which propagate along the surface of the substrate can be suppressed by the crossed idiosyncratic PBG (photonic crystal band-gap) structure because of its effect of forbidden-band, that it can radiate most of electromagnetic waves’ energy in the substrate significantly, and that it has lower return loss (S11) compared to the conventional patch antennas, thus, a high gain is attained, its performance is improved. Due to these advantages, the use of photonic crystal patch antennas will be extended in areas such as mobile communication, satellite communication, aviation, etc.     

Analysis of athermalizing performance of thermal infrared optical system with Cassegrain antenna

The thermal infrared imaging system is of greatest importance in modern optics and the image quality closely relies on the accuracy of the optical system. Heat-induced mirror deformation influences the transmission performance of the optical antenna system significantly, which further degrades the accuracy of the whole system. In this work, the simulation on lens deformation circumstances under the thermal environment is carried out using the finite-element analysis software ANSYS. The focus shift property caused by the thermal effect is studied in the cases of reflective and refractive Cassegrain optical antennas, and the athermalizing performance of Cassegrain optical antenna system is also concluded. This work presents a direction to accurate designing of the thermal infrared optical system.     

X波段左手材料高功率微波天线罩实验研究

为改善高功率微波天线的性能,设计了一种新型X波段左手材料高功率微波天线罩,并对其进行了实验冷测研究。结果表明,加载一到四层左手材料天线罩均可在一定频率范围内汇聚波束和提高增益,其中加载一层左手材料天线罩时,天线增益提高最大,在频率为9.32 GHz时增益提高最大幅度约为9.64 dB。将实验结果与理论仿真进行对比发现,两者并没有吻合一致。分析了天线罩的功率容量,可以实现高功率微波的应用。     

TEM喇叭天线脉冲辐射特性

采用时域有限积分法（FIT）对相同几何口径尺寸下不同长度TEM喇叭天线的主轴辐射特性进行了研究,分析了有限长TEM喇叭天线与理想（无限长）TEM喇叭天线主轴辐射场存在差异的原因,导出了有限长TEM喇叭天线主轴辐射场在接近理想TEM喇叭天线辐射场条件下天线长度与激励脉冲宽度（或脉冲上升时间）之间的关系。在此基础上,根据文献中的研究结果,并结合激励脉冲波形,给出了TEM喇叭天线几何参数的优化设计方法。     

密集阵高功率微波空间功率合成

对基于矩形阵列的高功率微波二维密集阵阵列合成进行了研究。仿真分析了均匀矩形栅格阵列的远场方向图,结果表明采用密集阵可以实现高效的、具有确定主波束的空间功率合成。并分析了阵元间距及阵元初相位对阵列空间功率合成的影响,结果表明:阵元间距越小,栅瓣越少,主波束宽度越宽,具有确定主波束的临界距离越小;当目标高度超过阵临界距离时,阵元初相位相差越小合成效率越高,阵列初相位分布范围超过/2时,阵列得不到确定的主波束,进行阵列设计时应充分考虑阵元间距及初相位对阵列合成的影响。     

近地面三阵子天线估计电磁波到达角和极化参数

从自由空间中的三阵子天线求入射电磁波极角和方位角的基本原理出发, 结合电场各个分量与极化方式之间的关系给出了左手极化波计算波达角的公式, 及地球表面上方三阵子天线判断入射波极化方向的方法; 本文提出了一种新颖的滤除地面反射波的方法, 保证了波达角的求解精度; 利用获得的高精度的波达角和测得的电场强度, 计算出了电磁波的各种极化参数, 这些极化参数可以作为电离层研究和电磁波在电离层中传播研究的参考. 关键词： 地球表面 三阵子天线 波达角 极化参数     

反射天线设计的一个数学理论

本文讨论反射天线面设计中出现的一个偏微分方程, 这是一个完全非线性Monge-Ampère型方程. 我们先给出一个广义解的定义, 然后介绍如何得到广义解的存在性、唯一性和正则性, 最后我们给出求数值解的一个方法.     

Flexible antenna design on PDMS substrate for implantable bioelectronics applications

In the current field of biomedical engineering, the research on implanted antennas has attracted more and more attention. This paper presents a flexible terrestrial radiating antenna with circular polarization characteristics that satisfy various requirements for biomedical implantable antennas. The new type of flexible material is adopted and a novel model is proposed. The square ground with small gap is implemented in the proposed antenna. The passive components can match the impedance and meet the requirements of the circular polarization wave. Simulation is carried out in a single layer tissue model to estimate the performance of the antenna and compared with multilayer tissue model. In addition, the flexible circularly polarized antenna has low profile characteristics and a wide axial ratio bandwidth of 250 MHz, ranging from 2.28 to 2.53 GHz. This paper uses pork to simulate single‐layer and multi‐layer tissue model. The flexible circular polarized antenna prototype is placed in the organization model for performance simulation test, and the measurement impedance bandwidth of 500 MHz is realized in the industrial scientific medical frequency band of 2.4–2.48 GHz.     

Perturbation Analysis for a New Omni-Directional Antenna Consisted of Circular Rod Corrugations Gloved with a DNG Shell

A new omni-directional leaky-wave antenna is proposed in the paper, which is consisted of circular rod corrugations gloved with a Double-negative (DNG) shell. The leaky characteristics of the new antenna are analyzed by improved perturbation method. The electromagnetic fields are described in terms of a radial transmission-line network, which tremendously simplifies the analysis procedure with good calculation accuracy and brings considerable physical insight into the overall behavior of the dielectric grating antenna. The case where the n = −1 space harmonic of TE₀₁ mode radiating into the space is carefully investigated, it is demonstrated that the gloved cylindrical DNG shell greatly enhances the leaky strength of the antenna. As a result, the dimension of the antenna could be largely reduced keeping the radiation efficiency unchanged, which is of practical significance for some applications.     

Antenna Performance of a Directly Dug Corrugated Feedhorn for the 150-GHz Band

We have developed a 150 GHz band corrugated feed horn. These corrugated feed horns have been established by a new machining method, which involves digging corrugations through a metal material. We were able to realize E plane and H plane symmetry, low side lobe level, and low cross-polarization level. Measured co-polarization beam patterns above − 35 dB were consistent with the simulated patterns within a designed frequency range. The peak levels of cross-polarization beam patterns were less than − 30 dB. And, the performances were uniform in several horns. In the present paper, we describe the corrugated horn produced by this methods.