Investigation of multiwavelength clock recovery based on heterodyne beats of sideband-filtered signal

We investigate a new parallel all-optical clock recovery scheme based on heterodyne beats of an optical sideband-filtered signal. The oscillating clock signal is recovered when the filtered sideband is combined with a stable local oscillator. The filtering is performed with an optical resonator, which by nature provides possibility for multiwavelength operation. The local oscillator could be realized by a multiwavelength laser, whose emission wavelengths are injection seeded with carrier wavelengths of the input data. The output signal of such a configuration benefits from a reduced bit-pattern effect and a stable offset level. The sideband filtering is demonstrated for 23 simultaneous channels at 100 GHz DWDM grid, each hosting a data stream of 10 Gbit/s.     

数码相机原理与系统设计研究

介绍了数码相机的工作原理 ,分析了数码相机的系统结构 ,提出了设计数码相机的处理流程。典型的数码相机系统有镜头、闪光灯、光学取景器、LCD显示屏、图像数据存储扩展设备接口、图像数据传输接口、供电系统以及核心处理器等八个主要模块。数码相机的数据流向从图像传感器开始 ,止于图像数据的存储和传输。数据流的处理主要包括模数转换、光学黑电平钳位、针对镜头的边缘畸变的运算修正、坏像素处理、白平衡处理、伽马校正、色彩合成处理、边缘检测 (锐度检测 )和伪彩色检测 (伪彩色抑制 )、JPEG压缩和图像存储器等模块     

Current R & D activities at TRCRE in polymer processing by EB

The current status of the R & D activities is presented on electron beam processing of polymers being carried out at TRCRE. Topics included are sterilization of medical products, graft polymers for selective separation or absorbents and curing of liquid prepolymer-monomer systems.     

用频域法实现圆环形目标物的计数

研究了用频域法实现圆环形目标物计数的方法。对空域中含有圆环形目标物的二值图像，经傅里叶变换后在频域内进行滤波，再经傅里叶反变换后取一阈值进行处理，则对应于圆环形目标物即变为一个实心体，然后对实心体进行计数即可实现对圆环形目标物的计数。对该方法进行了数学描述，并分别用模拟图像和实际图像进行了实验。结果表明，该方法消除噪声的效果好，对部分封闭圆的检测同样有效，且可用于目标物有粘连的情况。该方法对圆环形目标物的尺寸相差不大的情况更为有效。     

石墨-六角氮化硼微晶混合物与水高压反应产物分析

 利用球磨法制备石墨-六角氮化硼微晶混合物，并在6.1 GPa、800~1 500 ℃条件下与水进行高压反应，以便研究用水作触媒合成B-C-N三元化合物的可能性。通过对反应产物的XRD、XPS谱分析发现：高压下随着温度的升高，反应产物中出现再结晶石墨，其晶化程度逐渐提高；但没有出现再结晶六角氮化硼，也未出现立方氮化硼。在球磨不充分条件下，石墨-六角氮化硼混合物的XRD谱没有完全弥散，它们与水高压反应时，能观察到石墨与立方氮化硼分别结晶的现象，但都没有形成B-C-N晶化结构。     

Parallelization of population-based multi-objective meta-heuristics: An empirical study

In single-objective optimization it is possible to find a global optimum, while in the multi-objective case no optimal solution is clearly defined, but several that simultaneously optimize all the objectives. However, the majority of this kind of problems cannot be solved exactly as they have very large and highly complex search spaces. Recently, meta-heuristic approaches have become important tools for solving multi-objective problems encountered in industry as well as in the theoretical field. Most of these meta-heuristics use a population of solutions, and hence the runtime increases when the population size grows. An interesting way to overcome this problem is to apply parallel processing. This paper analyzes the performance of several parallel paradigms in the context of population-based multi-objective meta-heuristics. In particular, we evaluate four alternative parallelizations of the Pareto simulated annealing algorithm, in terms of quality of the solutions, and speedup.     

脉冲磁场处理对碳纳米管掺杂MgB2线材临界电流密度的影响

对碳纳米管(CNT)掺杂MgB₂超导体磁场处理后的行为进行了研究. 结果表明，CNT掺杂MgB₂超导体经5T脉冲磁场处理后临界电流密度J_c(H)在低磁场下提高了2—3倍，高场下提高一个数量级以上，扫描电镜结果显示CNT沿着处理磁场方向规则排列并且成为MgB₂基体的形核中心和高效的磁通钉扎中心. 关键词： 2')" href="#">MgB₂ 碳纳米管 脉冲磁场处理     

基于机器视觉的离散傅里叶变换目标识别方法

提出了一种基于机器视觉与离散傅里叶变换的目标特征识别方法。利用计算机图像技术采集和处理图像信号;利用离散的傅里叶变换对图像数据提取特征,能够更好的辨别数据细节,从而可通过图像的比对来实现目标的识别。该方法在对实际的静止图像进行处理与计算后,能够很好的对图像的细节变化进行识别。     

书籍扫描图像畸变参数自动计算方法的研究

为实现书籍扫描图像的畸变自动校正,提出用多项式来描述各像素的理论灰度g(zi)与页面上对应点到扫描仪工作平面距离zi二者之间的关系。为确立该多项式,在畸变参数已知条件下扫描一幅图像,根据已知畸变参数求出zi,即可按最小二乘法原理由各像素灰度的实际值求出多项式的各个系数。实验证明,采用4阶多项式已能满足一般要求,并求出了各系数。对任意扫描图像,自动计算畸变参数的方法为:首先利用扫描图像上页边空白处各像素的灰度,对畸变参数进行估计,并求出zi的估计值;然后代入所确立的多项式,可求得g(zi);通过调整各畸变参数的估计值,直到g(zi)与gi最为接近,即得最佳畸变参数。用于图像校正实验,获得了较好的校正效果,最大误差由不校正时的41%下降到了6.9%。这使得无需用户测量并输入有关畸变参数即可进行自动校正。