氰乙基纤维素溶致性液晶的研究

氰乙基纤维素在二甲基甲酰胺、二甲基乙酰胺、二甲基亚砜、乙腈以及丙酮等溶剂中可以形成溶致性液晶。随浓度增加,溶液从各向同性状态经两相共存态转变成为完全的液晶态。升高温度到T_c,液晶相消失;降低温度到T′_c,液晶相再生成。T_c总大于T′_c。而且,浓度越高,过冷温度△T=T_c—T′_c越小。在各向同性,两相共存或完全的液晶状态,溶液平均折射率和消光度均与浓度呈线性关系。但在两相间相互转变时,即在C_1~*和C_2~*处,n-C和 A-C 曲线上出现转折点。高聚物与溶剂的相互作用参数X_(12)愈小,临界浓度C_1~*愈小。把描述大分子链柔顺性的参数f与X_(12)联系起来,可用 1956年 Flory的理论定性地解释溶剂对高聚物溶致性液晶形成的影响。     

丁酸壳聚糖液晶的临界行为研究

用偏光显微镜法测定了丁酸壳聚糖在四种酸性溶剂中的临界浓度值．发现临界浓度值（ｖ／ｖ％）与溶剂的酸性无关，都是１６％～１７％．在以二氯乙酸为溶剂时，不同丁酰化程度的丁酸壳聚糖有相同的临界浓度．用ＤＳＣ法测定了丁酸壳聚糖／二氯乙酸体系的临界温度，并绘制了相图．结果表明，浓度达６０％（ｗ／ｗ％）后，临界温度基本不再变化，稳定在３９℃左右．     

Effect of HF addition on the microwave-assisted acid-digestion for the determination of metals in coal by inductively coupled plasma-atomic emission spectrometry

The microwave-assisted acid-digestion for the determination of metals in coal by ICP-AES was investigated, especially focusing on the necessity of adding HF. By testing five certified reference materials, BCR-180, BCR-040, NIST-1632b, NIST-1632c, and SARM-20, it was found that the two-stage digestion without HF (HNO₃ + H₂O₂ was used) was very effective for the pretreatment of ICP-AES measurement. Both major metals (Al, Ca, Fe, and Mg) and minor or trace metals (Co, Cr, Cu, Mn, Ni, Pb, and Zn) in coal gave good recoveries for their certified or reference values. The possibility of ‘HF-memory effect’ was cancelled by the use of a set of vessels which had been never contacted with HF. Twenty-four Japanese standard coals (SS coals) were analyzed by the present method, and the concentrations of major metals measured by the present method provided very high accordance with those from the authentic JIS (Japanese Industrial Standard) method.     

Direct determination of estriol 3- and 16-glucuronides in pregnancy urine by column-switching liquid chromatography with electrospray tandem mass spectrometry

Using column-switching liquid chromatography/tandem mass spectrometry (LC-MS/MS), we developed an improved analytical method of urinary estriol glucuronides. This new method is derived predominantly from maternal and fetal precursors in pregnancy. We used in the following procedure: first, we filtered urine samples with a membrane filter. Next, we directly injected the 50 microL aliquot of urine samples onto a pre-column. Then, after activating the column-switching valve, we backflushed the loaded samples onto the C(18) analytical column. Urine samples can be assayed within 20 min without any sample preparation steps. We monitored separated estriol glucuronides by negative electrospray ionization (ESI) and selected-reaction monitoring (SRM). The calibration range of estriol-3-glucuronide (E3-3G) and estriol-16-glucuronide (E3-16G) was 0.1-20 microg/mL and the linearity of the method was 0.9984 for E3-3G and 0.9987 for E3-16G. The limits of detection at a signal-to-noise (S/N) ratio of 3 were 10 ng/mL (E3-3G) and 5 ng/mL (E3-16G). The analytical recovery was over 85% and, in general, inter-day and intra-day variability for precision and accuracy were less than 10%. When applied to a pregnancy urine sample to biomedical monitoring of the function of the maternal/fetal unit, the proposed method allowed rapid and sensitive screening for the detection of E3-3G and E3-16G.     

Use of intermittent jets to enhance flux in crossflow filtration

This paper deals with the influence of a new flow unsteadiness on the permeate fluxes in crossflow filtration. A pneumatically controlled valve generates intermittent jets from the main flow, causing the formation of large vortices moving downstream along the tubular membrane. The main results of the numerical calculation of such flows are given. The experimental study was carried out by filtering a bentonite suspension through an ultrafiltration mineral membrane. Time evolutions of flux were achieved in steady and unsteady operating conditions. Results concerning the influence and limits of the nozzle to tube diameter ratio and the jet velocities are discussed. The applicability of such an unsteady flow is examined with a view to effects on energy consumption and possible viscosity effects.     

Correction for the Concentration Polarization for Simultaneous Reduction of Several Reactants: Platinum(II) Aquachloride Complexes

The reaction of electroreduction of platinum(II) aquachloride complexes on a negatively charged dropping mercury electrode is used to determine specific features of interpretation of experimental data in the case of parallel conversion of several forms of a reactant, connected with the manner of introducing a correction for the concentration polarization. The difference in the charges of species undergoing simultaneous reduction gives rise to ambiguity when analyzing kinetic data on the dependence of current on the supporting-electrolyte concentration at constant electrode charge. A new self-consistent technique for deducing model parameters (ratio between reactant discharge rate constants) is proposed.     

支化高分子在溶液中的交叠与缠结

溶液中高分子的交叠和缠结与其链结构密切相关。支化聚苯乙烯的临界交叠浓度C和临界缠结浓度C_E比分子量相同的线型聚苯乙烯的大,说明交叠和缠结同分子在溶液中线团的体积有直接关系。     

BaCe0.8Ho0.2O3-a陶瓷的性质与应用

Ceramic BaCe0.8Ho0.2O3-α with orthorhombic perovskite structure was prepared by conventional solid state reaction, and its conductivity and ionic transport number were measured by ac impedance spectroscopy and gas concentration cell methods in the temperature range of 600-1000 ℃ in wet hydrogen and wet air, respectively. Using the ceramics as solid electrolyte and porous platinum as electrodes, the hydrogen-air fuel cell was constructed, and the cell performance at temperature from 600-1000 ℃ was examined. The results indicate that the specimen was a pure protonic conductor with the protonic transport number of 1 at temperature from 600-900 ℃ in wet hydrogen, a mixed conductor of proton and electron with the protonic transport number of 0.99 at 1000 ℃. The electronic conduction could be neglected in this case, thus the total conductivity in wet hydrogen was approximately regarded as protonic conductivity. In wet air, the specimen was a mixed conductor of proton, oxide ion and electron hole. The protonic transport numbers were 0.01-0.09, and the oxide-ionic transport numbers were 0.27-0.32. The oxide ionic conductivity was increased with the increase of temperature, but the protonic conductivity displayed a maximum at 900 ℃, due to the combined increase in mobility and depletion of the carriers. The fuel cell could work stably. At 1000 ℃, the maximum short-circuit current density and power output density were 346 mA/cm^2 and 80 mW/cm^2, respectively.     

Thermoreversible gelation of polyacrylonitrile/dimethylformamide-solution

The thermoreversible gelation of semi-diluted atactic polyacrylnitrile (PAN)/dimethylformamide (DMF)-solutions has been studied. The structural features of PAN/DMF-gels, formed by supercooling have been investigated by DSC-, x-ray- and swelling measurements. A new structural model has been introduced to describe the morphology of the junction zones of PAN/DMF-gels and to also explain the gelation behavior of PAN/DMF-solutions as the structural features of PAN/DMF-gels. The junction zones of a PAN/DMF-gel have been defined as ordered junction zones.A gelation enthalpy of about H=–6 kJ/mol supports the idea that an ordered junction zone is formed by intermolecularly neighboring stereoregular parts of atactic PAN chains due to a nucleation process in the solution. It can be defined as a strongly distributed fringed micelle.     

Increased viscosity of erythrocyte suspension upon hemolysis

Viscous properties of partially hemolyzed erythrocyte suspensions were studied with a cone-plate viscometer. A Casson plot was successfully applied for analysis of the viscous properties. When the degree of hemolysis was increased, Casson viscosity ( _c) of the partially hemolyzed erythrocyte suspensions increased, but the substitution of hemoglobin solution with the same O₂-carrying capacity of hemolyzed fraction (containing ghost) reduced the _c remarkably. The yield stress (f _c) of the intact erythrocyte suspension increased with increasing hematocrit, but thef _c of partially hemolyzed erythrocyte suspension was dependent on both hematocrit and the degree of hemolysis. The apparent viscosity ( _a) of erythrocyte suspension was drastically increased with the slight hemolysis, and became maximum at a certain degree of hemolysis which was dependent on both total hemoglobin concentration and shear rate. Such influence of hemolysis on the _a was also evident in the mixture of erythrocyte suspension and hemoglobin solution. These results suggest that the hemoglobin molecule plays a certain role in erythrocyte-erythrocyte interaction in their suspension, which modifies the viscosity.