稀薄气体二维外部柱体绕流特性研究

本文采用直接模拟蒙特卡罗方法对稀薄气体二维外部柱体绕流问题进行了数值模拟。结果表明:外部绕流问题,在特定情况下会产生激波,激波的产生,不仅与气体的稀薄程度有关,还与来流马赫数有关。而气流与壁面之间的换热,随来流马赫数增加而增加,随气体稀薄程度增加而减小。     

混凝土动态劈裂拉伸试验的数值模拟

采用LS-DYNA有限元编码程序，对混凝土的动态劈裂拉伸试验进行了数值模拟，给出了混凝土试样在不同类型加载情况下应力分布之间的差异，证实了动态劈裂拉伸试验的有效性，提出了改进试验方法的若干结论．     

环形燃烧室火焰简及旋流器流场计算

本文采用偏微分方程法生成贴体网格,在任意曲线坐标系下数值研究两种先进燃烧室火焰筒及其旋流器三维紊流流场。由于旋流器的形状复杂,本文采用型线定点法确定网格的边界。在非交错网格系下采用SIMPLE算法和混合差分格式对离散方程进行求解。计算结果表明计算方法合理,这计算程序进一步扩展,可用来预估环形燃烧室反应流流场。     

地源热泵的运行特性模拟研究

依据圆柱源理论,建立起了耦合地面热泵机组和地下埋管换热器特性的模拟模型,该模型可用于长期运行的地源热泵系统的短时间步长运行特性模拟。探讨了模拟过程中有关参数的确定方法,并运用所建模型对地源热泵的冬季和夏季运行特性进行了模拟。运行特性模拟与实验数据的验证结果表明,所建模型可以对地源热泵的运行特性做出符合实际的预测。     

Microwave promoted methylation of plant polysaccharides

O-Methylation is of outstanding importance in structural polysaccharide chemistry. A novel method for the methylation of polysaccharides using microwave (MW) irradiation is described. Seed gum from Cyamopsis tetragonolobus (Guar) was fully methylated with dimethyl sulphate and sodium hydroxide using 100% microwave power for 4 min in 68% yield. The completely methylated seed gum thus obtained was hydrolyzed by 70% formic acid followed by 0.5N H₂SO₄ under full microwave power for 1.16 and 1.66 min, respectively. The partially methylated monosaccharides were separated and identified.     

短脉冲强激光在稀薄等离子体中传播时的电磁类孤立子

 采用二维粒子模拟方法，研究了短脉冲强激光在稀薄等离子体中传播时电磁类孤立子的产生和时空演化过程。通过分析电磁场与等离子体波的非线性能量交换和激光场的频率谱结构等，给出了电磁类孤立子形成的基本物理图像，讨论了等离子体参数对电磁类孤立子形成的影响。模拟结果表明：类孤立子的形成是由于局部电磁波振荡频率减小至等离子体频率引起的，初始等离子体密度越高越容易形成空间局域结构。     

Microwave-assisted Regioselective 1-O-Deacylation of Peracylated Glycopyranoses on Alumina

A facile, rapid and regioselective method for the 1-O-deacylation of peracylated glycopyranoses is described which occurs under mild conditions by absorption onto alumina using microwave irradiation.     

离子束合成钇硅化物的结构及红外谱特征

将稀土金属钇离子注入到n型单晶Si(111)中制备出钇硅化物埋层.利用x射线衍射、卢瑟福背散射和傅里叶红外吸收谱测量分析了样品的结构、原子的埋层分布和振动模式.结果表明，Y离子在注入过程中已与基底中的Si原子形成了YSi2结构相.真空下的红外光辐照处理促使YSi2择优取向生长，埋层中Si与Y的平均原子浓度比由24下降为20，与六方YSi2的化学计量比一致.还给出了钇硅化物的特征红外吸收谱.     

风冷热泵冷热水机组动态过程仿真

本文给出了风冷热泵冷热水机组动态过程模型。系统的高、低压段被分成制冷剂侧、管壁、以及水或空气侧三个控制容积。针对每个控制容积建立了质量和能量平衡的微分方程。由于压缩机、热力膨胀阀阀体、以及四通换向阀具有较小的热惯性,因而采用稳态模型描述压缩过程、膨胀过程、以及内泄露过程。膨胀阀感温包中的制冷剂温度对于蒸发器出口温度的延迟用一阶惯性环节来描述。通过“预测-校正”和“自适应步长”方法实现系统仿真。仿真结果与测试数据吻合良好。     

Effect of secondary electrons from latent tracks created in YBCO by swift heavy ion irradiation

Swift heavy ions (SHI) with electronic energy loss exceeding a value of 14.4 keVnm⁻¹ create amorphized latent tracks in YBCO type superconductors. In the low fluence regime of an ion beam where tracks do not overlap, a decrease of the superconducting transition temperature as probed through resistivity studies, is not expected due to availability of percolating current paths. The present study however shows T_c decrease by about 1–3 K in thin films of YBCO when irradiated by 250 MeVAg ions at 79 K at a fluence of 5×10¹⁰–1×10¹² ionscm⁻². The highest fluence used in the present study is three times less than the fluence where track overlapping becomes significant. The T_c tends to increase towards the preirradiation value on annealing the films at room temperature. To explain this unusual result, we consider the effect of ion irradiation in inducing materials modification not only through creation of amorphized latent tracks along the ion path, but also through creation of atomic disorder in the oxygen sublattice in the Cu–O chains of YBCO by the secondary electrons. These electrons are emitted radially from the tracks during the passage of the SHI. Considering the correlation between the charge state of copper and its oxygen coordination, we show in particular that the latter process is a consequence of the inelastic interaction of the SHI induced low-energy secondary electrons with the YBCO lattice, which result in chain oxygen disorder and T_c decrease.