The MNDO-PM3 study of the mechanism of nucleophilic substitution of the phenoxide anion for the nitro group in 1,3,5-trinitrobenzene and 2,4,6-trinitrotoluene in the gas phase and in polar solvents

The semi-empirical quantum chemical MNDO-PM3 calculations of the enthalpies of formation of Meisenheimerortho- andipso--complexes of 1,3,5-trinitrobenzene (TNB) and 2,4,6-trinitrotoluene (TNT) with the phenoxide anion in the gas phase and in water are performed within the framework of the point dipole model. Based on the calculated heats and activation barriers to substitution of the nitro group by the phenoxyl group in TNB and TNT, the possibility of the reactions of TNB and TNT with the phenoxide anion in water is shown. These reactions in water occurvia the S_NAr mechanism involving the correspondingipso--complex as an intermediate. In the gas phase, the S_NAr mechanism is impossible, because the reaction is strongly endothermic. In the case of TNT, the exothermic reaction of elimination of a proton from the methyl group by the phenoxide anion competes with nucleophilic substitution in a polar solvent. The activation energy calculated for this exothermic reaction is 8 kcal mol^–1.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 4, pp. 624–628, April, 1995.     

2,4-二吡啶基方酸衍生物非线性光学性质的从头算研究

采用HF/4-31G方法优化分子几何构型,在此基础上用CPHF研究了系列2,4-二吡啶基方酸衍生物的二阶非线性光学系数βvec,并对影响βvec的因素进行了探讨.结果表明:此类化合物均有很大的βvec,它们的非线性光学性质与其分子结构有着密切的关系.     

Synthesis,Structure and Adsorption of AlPO-21 Prepared by Co-template Method

IntroductionAlPO 2 1isatypeofmicroporousaluminophosphatepreparedbyFlanigenandco workersin 1982 ,andthestructurewasresolvedbySmithetal.1in 1984 .AlmostatthesametimePariseetal.2 preparedAlPO 2 1phasebyanotherrouteandresolvedthestructureindependently .Inthenextyear ,GaPO 2 1phasewasobtainedaswell.3Al thoughAl(Ga)PO 2 1phasespreparedindifferentwayspossesssimilarchannelsystem ,amongthemtherearestillsomedifferencesinlatticeconstants ,indicatingthatdiffer enttemplatemoleculescanaffectlocallythe…     

光度分析中协同系数补偿方法的研究──三次标准加入法同时测定钼、钨和钛

本文在两次标准加入法[1]的基础上，提出了三组份同时测定的三次标准加入法，并应用于钼、钨和钛的流动注射同时测定。测定条件：［水杨基荧光酮（SAF）］＝1．25　×10-4mol／L，［溴化＋六烷基三甲基铵（CTMAB）」＝2．5×10－3mol／L，pH1．35，25℃，采样、进样时间分别为10s和18s，进样频率128次／h。为消除组份间协同作用引起的吸光度加合性的偏离，定义了三组份协同系数。将其引入三组份同时测定方法，补偿了吸光度对线性的偏离。补偿后钼、钨和钛的测定范围分别为0．05～0．35，0．25～1．00，0．025～0．30mg／L。测定了钢样及模拟样品中钼、钨和钛含量，结果较好。     

Synthesis of Ultrafine SiC Powders from Carbon-Silica Hybridized Precursors with Carbothermic Reduction

Inorganic-organic hybrid gels were prepared by simultaneous condensation of the liquid mixture of ethyl silicate, ethyl borate and water soluble phenol resin with low molecular weight. The liquid mixtures were changed into lightly colored transparent gels after a catalyst addition and stirring. The obtained gels were crushed, dried and fired in controlled conditions to yield the inorganic precursors. Since the tailored inorganic precursors mainly consisted of SiO2 and carbon, silicon carbide was formed with the heat treatments in an Ar atmosphere beyond 1773 K with carbothermic reduction. The properties and morphology of the formed silicon carbide powders in terms of the starting precursor compositions and the conditions of the carbothermic reduction were investigated with SEM, XRD and TG-DTA analysis.     

粉末化学镀法制备的NiB／TiO2非晶态合金催化剂对环丁烯砜加氢反应的催化性能

 采用诱导沉积法及粉末化学镀法分别制备了纯态NiB及负载型NiB／TiO2非晶态合金催化剂．用XRD，ICP，SEM，TEM和DSC等手段对催化剂的物性及TiO2载体与NiB非晶态合金之间的相互作用进行了表征，考察了非晶态合金的结构、组成、形貌和热稳定性，并将其用于环丁烯砜加氢反应中．结果表明，相对于NiB而言，NiB／TiO2催化剂具有优良的热稳定性和催化活性，这缘于NiB和TiO2载体之间的相互作用及载体的分散作用．     

巯基葡聚糖凝胶分离富集光度法测定镉的研究

研究了在ＴｒｉｔｏｎＸ－１００存在下，新显色剂邻羧基苯基重氮氨基偶氮苯（ＣＤＡＡ）与镉的显色体系，在ｐＨ１０．６的Ｎａ２Ｂ４Ｏ７－ＮａＯＨ体系中，显色反应灵敏度很高。络合物的最大吸收位于５４５ｎｍ处，其摩尔吸光系数为２．２２×１０＾５Ｌ·ｍｏｌ＾－１·ｃｍ＾－１。镉含量在０￣１２μｇ／２５ｍＬ符合比耳定律。将该体系用于巯基葡聚糖凝胶分离富集－光度法测水样中微量镉，结果令人满意。     

APPLICATION OF THE MOMENT METHODS TO ANALYSIS OF X-RAY DIFFRACTION LINE PROFILE FOR PA1010-BMI SYSTEM

Pure X-ray diffraction profiles have been analysed for polyamide 1010 and PA1010--BMI system by means of multipeak fitting resolution of X-ray diffraction.The methods ofvariance and fourth moment have been applied to determine the particle size and strainvalues for theparacrystalline materials.The results indicated that both variance and fourthmoment of X-ray diffraction line profile yielded approximately the same values of theparticle size and the strain.The particle sizes of(100)reflection have been found todecrease with increasing BMI content,whereas the strain values increased.     

Preparation of a sulfonated fused-silica capillary and its application in capillary electrophoresis and electrochromatography

In the present paper, two new methods, sol-gel and chemical bonding methods, were proposed for preparation of sulfonated fused-silica capillaries. In the sol-gel method, a fused-silica capillary was coated with the sol solution obtained by hydrolysis of 3-mercaptopropyltrimethoxysilane (MPTS) and tetramethoxysilane, and followed by age; while in the chemical bonding method, a capillary was chemically bonded directly with MPTS. Then, both the resulting capillaries were oxidized with an aqueous solution of hydrogen peroxide solution (H2O2) (30%, m/m) to obtain the sulfonated capillaries. The electroosmotic flow (EOF) for the sulfonated capillaries was found to remain almost constant within the studied pH range, and greater than that of the uncoated capillary. However, the coating efficiency of the capillary prepared by chemical bonding method was higher than that by sol-gel method, by comparing their magnitude of the EOF, the degree of disguise of the silanol and reproducibility of preparation procedure. The effects of the electrolyte's concentration and the content of methanol (MeOH) on the EOF were also studied. Especially, the study of the apparent pH (pH*) on the EOF in a water-MeOH system was reported. Finally, capillary electrophoretic separation of seven organic acids was achieved within 6.5 min under optimal condition using the chemically bonded sulfonated capillary. Moreover, separation of four alkaloids on the sulfonated capillary was compared with that on uncoated capillary in different conditions. Ion-exchange mechanism was found to play a key role for separation of these four basic analytes on the sulfonated capillary.     

Adsorption from Ternary Liquid Mixtures on Partially Dehydroxylated Silica Gel

The formation of mixed adsorbed layers has been tested for ternary mixtures containing a specifically adsorbed component—acetone and binary solvent benzene +n-hepane. The specific excess adsorption isotherms from the liquid phase were measured on silica gel samples partially dehydroxylated. The competition of liquid components for silica surface is discussed on the basis of changes in the mixed solvent composition.