A novel microwave dielectric ceramic Ca2Zn4Ti16O38: Preparation and dielectric properties

A novel microwave dielectric powder with composition of Ca₂Zn₄Ti₁₆O₃₈ was synthesized through a citrate sol-gel process. The development of crystalline phases with heat-treating temperature for the gel derived powders was evaluated by using thermo-gravimetric analysis and X-ray powder diffraction analysis techniques. The pure phase of Ca₂Zn₄Ti₁₆O₃₈ with crichtonite crystal structure was obtained at relatively low temperature of 1000 °C. The synthesized powder has high reactivity and the dense ceramics with single crystalline phase were obtained at low sintering temperature of 1100 °C. Impedance spectroscopy and microwave dielectric measurements on sintered samples showed the present compound to be a modest dielectric insulator with excellent dielectric properties of ε_r∼47-49, Qf value ∼27,800-31,600 GHz and τ_f∼+45 to +50 ppm/°C. It shows comparable microwave dielectric properties to other moderate-permittivity microwave dielectrics, but much lower sintering temperature of 1100 °C.     

Electrical Double Layer on Liquid Sn–Ga Alloy in Aqueous Solutions

Double-layer parameters of a liquid Sn–Ga electrode in aqueous electrolyte solutions are studied. It is shown that Sn in the alloy with Ga is a surface-active component and is forced out onto a surface layer of the electrode. The double-layer parameters of an Sn–Ga electrode (8 at. % Sn), which are measured in the experimentally accessible range of charges, differ radically from the parameters of Ga electrodes and are close to those of Sn electrode. Hence, an Sn–Ga electrode containing 8 at. % Sn simulates electrochemical properties of a liquid Sn electrode. The difference between reciprocal electronic capacitances of Hg and Sn and a corrected electrochemical work function of Sn are determined. It is shown that the chemisorption interaction of an Sn–Ga electrode with water molecules is virtually absent at charges more negative than –7 C/cm². A potential drop on uncharged Sn, which is associated with water chemisorption, is –20 mV. Thus, the hydrophilicity of Sn is slightly higher than that of Hg, Bi–Ga, Pb–Ga, and Tl–Ga and significantly lower than that of In–Ga, Cd–Ga, and Ga.     

Influence of nanoporous carbon electrode thickness on the electrochemical characteristics of a nanoporous carbon|tetraethylammonium tetrafluoroborate in acetonitrile solution interface

Electrochemical characteristics for the nanoporous carbon|Et₄NBF₄+acetonitrile interface have been studied by cyclic voltammetry and impedance spectroscopy methods. The influence of the electrolyte concentration and thickness of the nanoporous electrode material on the shape of the cyclic voltammetry and impedance curves has been established and the reasons for these phenomena are discussed. A value of zero charge potential, depending slightly on the structure and concentration of the electrolyte, the region of ideal polarizability and other characteristics have been established. The nanoporous nature of the carbon electrodes introduces a distribution of resistive and capacitive elements, giving rise to complicated electrochemical behaviour. Analysis of the complex plane plots shows that the nanoporous carbon|Et₄NBF₄+acetonitrile electrolyte interface can be simulated by an equivalent circuit, in which two parallel conduction paths in the solid and liquid phases are interconnected by the double-layer capacitance in parallel with the complex admittance of the hindered reaction of the charge transfer or of the partial charge transfer (i.e. adsorption stage limited) process. The values of the characteristic frequency depend on the electrolyte concentration and electrode potential, i.e. on the nature of the ions adsorbed at the surface of the nanoporous carbon electrode. The value of the solid state phase resistance established is independent of the thickness of the electrode material.     

Dynamic electrochemical impedance spectroscopy measurements of passive layer cracking under static tensile stresses

Electrochemical impedance spectroscopy allows the examination of corrosion susceptibility and resistance for different construction materials, in particular the determination of the properties of their passive films. This technique makes possible the analysis of electrochemical processes in time domain, including rapid phenomena such as changes in the properties of passive films, but it has never been used for passive layer cracking examination. In many cases, fracture of the passive film under tensile stresses leads to stress corrosion cracking. Therefore, investigations of passive layer cracking on austenitic stainless steels under tensile stresses facilitate the understanding of the mechanism of stress corrosion cracking in these common engineering materials. The effect of static tensile stresses on the passive film cracking behaviour of type 304L stainless steel immersed in 0.5 M NaCl solution at room temperature has been investigated. This paper presents the impedance spectra obtained for 304L stainless steel samples at different potential values.Contribution to the 3rd Baltic Conference on Electrochemistry, Gdansk-Sobieszewo, Poland, 23–26 April 2003Dedicated to the memory of Harry B. Mark, Jr. (28 February 1934–3 March 2003)     

POROUS MEMBRANE TEMPLATED SYNTHESIS OF POLYMER PILLARED LAYER

The anodic porous alumina membranes with a definite pore diameter and aspect ratio were used as templates tosynthesize polymer pillared layer structures. The pillared polymer was produced in the template membrane pores, and thelayer on the template surfaces. Rigid cured epoxy resin, polystyrene and soft hydrogel were chosen to confirm themethodology. The pillars were in the form of either tubes or fibers, which were controlled by the alumina membrane pore surface wettability. The structural features were confirmed by scanning electron microscopy results.     

Ultrathin-layer sodium dodecyl sulfate disc electrophoresis of proteins in the range from 10 to 220 kDa in homogeneous,low-concentrated polyacrylamide gels

This study describes an ultrathin-layer sodium dodecyl sulfate (SDS) disc electrophoresis in polyacrylamide gels of a thickness of only 150 microm. By use of 2-amino-2-methyl-1,3-propanediol/glycine instead of traditional Tris/HCl buffer in the resolving phase of the gel, proteins with a wide range of molecular sizes (10 kDa to over 220 kDa) are separated in unusually low-concentrated gels (4%T, 3.3%C). 2-Amino-2-methyl-1,3-propanediol in the resolving part of the gel contributes to stabilization of the pH value at 8.8, while glycine improves destacking as well as separation of small proteins from the bulk of stacked SDS. This method combines both the advantages of conventional slab-gel electrophoresis and capillary gel electrophoresis. It is easy to apply and well suited for all further miniaturization attempts.     

Kaolin as support for porous layer open tubular columns

Summary PLOT columns have been prepared with kaolin as the liquid phase support. These columns show good efficiency with different stationary phases and good thermal stability with polar phases. The performance of columns is shown by the separation of various mixtures such as fatty acids, phenols and anilines which are of analytical importance.     

Dielectric analysis of polystyrene microcapsules using scanning dielectric microscope

 A dielectric imaging technique with a scanning dielectric microscope was applied to polystyrene microcapsules in an aqueous environment to study the electrical properties of individual ones. The dielectric images obtained over a frequency range from 10 kHz to 10 MHz showed frequency dependence, which indicated dielectric dispersion (or relaxation) due to interfacial polarization or the build up of charge on the boundaries between the microcapsule shell and the aqueous phases. The dielectric dispersion was analyzed based on an equivalent electrical circuit model and a shell-sphere model in which a spherical core is covered with an insulating shell. Received: 26 September 1997 Accepted: 26 December 1997     

Structural Study of an Unusual Cubic Pyrochlore Bi1.5Zn0.92Nb1.5O6.92

Single-phase pyrochlore-type specimens of Bi_1.5Zn_0.92Nb_1.5O_6.92 were studied using combined electron, X-ray and neutron powder diffraction techniques. Rietveld refinements using neutron powder diffraction data confirmed an average pyrochlore structure A₂B₂O₆O′ (Fd&3macr;m, a=10.5616(1) Å) with both Bi and Zn mixed on the A-sites. However, refinements revealed significant local deviations from the ideal pyrochlore arrangement which were caused by apparent displacive disorder on both the A and O′ sites. The best fit was obtained with a disordered model in which the A-cations were randomly displaced by ∼0.39 Å from the ideal eight-fold coordinated positions. The displacements occur along the six 〈112〉 directions perpendicular to the O′-A-O′ links. In addition, the O′ ions were randomly displaced by ∼0.46 Å along all 12 〈110〉 directions. Crystal-chemical considerations suggest the existence of short-range correlations between the O′ displacements and both the occupancy of the A-sites (i.e., Bi or Zn) and the directions of the A-cation displacements. The combined A-cation and O′ displacements change the coordination sphere of the A-cations from 8 to (5+3); the resulting coordination environment of the A-cations bears similarities to that of the (5+1)coordinated Zn in zirconolite-like Bi₂Zn_2/3Nb_4/3O₇. The observed displacive disorder in the A₂O′ network of the Bi_1.5Zn_0.92Nb_1.5O_6.92 structure involves atoms associated with the lowest-frequency vibrational bending mode, and is likely responsible for both the high dielectric constant and the dielectric relaxation reported for this compound.     

Sequential centrifugal layer chromatography (SCLC): A new technique for the isolation of natural compounds. Part 2: Comparative study on centrifugal layer chromatography (CLC) and SCLC for the separation of furocoumarin isomers

The new sequential centrifugal layer chromatography extends the possibilities for preparative separation of furocoumarin isomers. In the present work, isobergapten, pimpinellin, bergapten, isopimpinellin, and sphondin were isolated from a prepurified extract of Heracleum sphondylium roots using two different techniques, namely, centrifugal layer chromatography (CLC) and sequential centrifugal layer chromatography (SCLC). The former technique was carried out with four plates, whereas the latter method required only one plate, using the same mobile phase in each case. A further advantage of the SCLC method was that all completely separated compounds could be quickly and efficiently eluted in small volumes of mehtanol.