超短强激光脉冲在等离子体隧道中传输的理论与数值模拟研究

研究了超短强激光脉冲在非扰动抛物型部分电离的预等离子体隧道中的传输特性.从Maxwell方程出发得到了两个包含衍射、三阶强度非线性、等离子体散焦、等离子体隧道聚焦以及相对论自聚焦等效应在内的激光场演化方程，即折射率方程和哈密顿-雅可比方程.在此基础 上得到了激光在等离子体隧道中传输的包络方程以及光斑半径与传输距离、隧道宽度等初始 参量的关系. 关键词： 等离子体隧道聚焦 相对论自聚焦 势阱     

基于FPGA的42英寸全色PDP存贮控制电路的实现

从等离子体平板显示器(PDP)的发光原理出发，分析和研究了存贮控制电路的工作原理，提出基于FPGA的电路设计方案，并给出数据整理电路和驱动信号产生电路的具体电路框图，最后给出部分仿真波形．     

类锂铝复合机制产生X光激光的等离子体状态

本文从速率方程出发,讨论了类锂铝复合等离子体的激发态结构,衰减常数,反转率和小信号增益等表征介质增益特性的物理量以及它们随电子温度,电子密度和光子逃逸几率的变化。找到了进行类锂铝离子通过复合机制产生X光激光设计应创造的等离子体状态目标区域。还讨论了这些物理量随原子序数变化的定标律。     

Sample preparation procedure for the determination of sulphur and trace metals in oil products by the ICP with a minitorch using emulsions

A quick sample preparation method was used for the determination of sulphur and trace metals in oil and oily products by the ICP with a minitorch. Stable aqueous emulsions of oils and oil products were made by using two kinds of emulsifiers (one with low sulphur content, the other sulfonated). Aqueous standard solutions can be used for the preparation of calibration solutions. The contents of S, Al, Cr, Cu, Fe, Mg, Ni and Pb in aqueous emulsions were determined and the results were in good agreement with the composition of oil standard solutions used for control analysis procedure.     

Effect of the pore surface modification of an inorganic substrate on the plasma‐grafting behavior of pore‐filling‐type organic/inorganic composite membranes

We have investigated the effect of the surface state and surface treatment of the pores of an inorganic substrate on the plasma‐grafting behavior of pore‐filling‐type organic/inorganic composite membranes. Shirasu porous glass (SPG) was used as the inorganic substrate, and methyl acrylate was used as the grafting monomer. The grafting rate increased as the density of silanol on the SPG substrate increased. This result suggests that radicals are generated mainly at the silanol groups on the pore surface by plasma irradiation. The SPG substrates were treated with silane coupling agents used to control the mass of organic material bonded to the pore surface. The thickness of the grafted layer became thinner as the mass of organic material bonded to the pore surface of SPG increased. This decrease in the thickness of the grafted layer could be explained by the decrease in the penetration depth of vacuum ultraviolet rays contained in plasma having a wavelength of less than 160 nm that generated radicals in the pores of the substrate. The thickness of the grafted layer inside the SPG substrates could be controlled through the control of the mass of organic material bonded to the pore surface of the SPG substrate. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 846–856, 2006     

Surface characterization and barrier properties of plasma‐modified polyethersulfone/layered silicate nanocomposites

This study describes the preparation of polyethersulfone (PES)/layered silicate nanocomposites (PLSNs) by mixing PES polymer chain into organically‐modified layered silicate in 1‐methyl‐2‐pyrrolidinone (NMP) solution. Both X‐ray diffraction data and transmission electron microscopy images of PLSNs indicate that the silicate layers were almost exfoliated and randomly distributed into the PES matrix. The mechanical and barrier properties of PLSNs show remarkable enhancement in the storage modulus and water/oxygen permeability when compared with that of neat PES matrix. Surfaces modification of PES and PLSN films with various treated times, system pressures, and radio frequency (RF) powers were performed using a mixture of oxygen (O₂) and nitrogen (N₂) plasmas. The topographical and physical properties of plasma‐modified PES and PLSN surfaces were investigated using scanning probe microscopy (SPM), contact‐angle measurements, and X‐ray photoelectron spectroscopy (XPS). These results indicate that the surface roughness of PLSNs with the same condition of plasma modification is lower than that of neat PES matrix and is probably due to the increase of stiffness with the presence of inorganic layered silicates in PES matrix. The surface properties of the PES and PLSNs are also changed from hydrophobic to hydrophilic. The XPS spectra suggest that the exposure of the PES and PLSNs to the plasmas led to the combination of etching reactions of polymer surface initiated by plasma and the following addition reactions of new oxygen‐ and nitrogen‐containing functional groups onto polymer surfaces to change their surface properties. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 3185–3194, 2006     

Multiscale Finite Element Modeling of Arc Dynamics in a DC Plasma Torch

The dynamics of the electric arc inside a direct current non-transferred arc plasma torch are simulated using a three-dimensional, transient, equilibrium model. The fluid and electromagnetic equations are solved numerically in a fully coupled approach by a multiscale finite element method. Simulations of a torch operating with argon and argon–hydrogen under different operating conditions are presented. The model is able to predict the operation of the torch in steady and takeover modes without any further assumption on the reattachment process except for the use of an artificially high electrical conductivity near the electrodes, needed because of the equilibrium assumption. The results obtained indicate that the reattachment process in these operating modes may be driven by the movement of the arc rather than by a breakdown-like process. It is also found that, for a torch operating in these modes and using straight gas injection, the arc will tend to re-attach to the opposite side of its original attachment. This phenomenon seems to be produced by a net angular momentum on the arc due to the imbalance between magnetic and fluid drag forces.     

Studies on the Plasma Shielding of 1.06μm Laser on the Aluminum Target

ＳｔｕｄｉｅｓｏｎｔｈｅＰｌａｓｍａＳｈｉｅｌｄｉｎｇｏｆ１．０６μｍＬａｓｅｒｏｎｔｈｅＡｌｕｍｉｎｕｍＴａｒｇｅｔＬＵＪｉａｎ；ＮＩＸｉａｏｗｕ；ＨＥＡｎｚｈｉ（ＤｅｐａｒｔｍｅｎｔｏｆＡｐｐｌｉｅｄＰｈｙｓｉｃｓ，ＮａｎｊｉｎｇｏｆＳｃｉｅｎｃ...     

HCN laser scattering on the JIPP T-IIU tokamak

A 4-channel HCN laser scattering system has been developed and applied to the JIPP T-IIU tokamak. Main aim of this system is to study microturbulence excited in the plasma, especially in the high power ICRF heating experiment. The observed density fluctuations are in a frequency range of the electron diamagnetic drift wave and have broad frequency spectra. The main part of the wavenumber is found to satisfy the condition of . In the heating experiments, deterioration of the energy confinement time is observed, and the density fluctuation level increases with the increase of the heating power.