Chitosan‐modified graphene oxide as a modifier for improving the structure and performance of forward osmosis membranes

Chitosan (CS) with good hydrophilicity and charged property was used to modify graphene oxide (GO), the obtained GO‐CS was used as a novel modifier to fabricate thin film composite forward osmosis (FO) membranes. The results revealed that the amino groups on CS reacted with carboxyl groups on GO, and the lamellar structure of the GO nanosheets was peeled off by CS, resulting in the reducing of their thicknesses. The GO‐CS improved the hydrophilicity of polyethersulfone (PES) substrate, and their contact angles decreased to 64° with the addition of GO‐CS in the substrate. GO‐CS also increased the porosity of the substrate and surface roughness of FO membrane, thereby optimizing the water flux and reverse salt flux of FO membrane. The average water flux of the FO membrane reached the optimal flux of 21.34 L/(m² h) when GO‐CS addition was 0.5 wt%, and further addition of GO‐CS to the substrate would decrease the water flux of FO membrane, and the reverse salt flux also decreased to the lowest value of 2.26 g/(m² h). However, the salt rejection of the membrane increased from 91.4% to 95.1% when GO‐CS addition increased from 0.5 to 1.0 wt% under FO mode using 1 mol/L sodium chloride (NaCl) solution as draw solution (DS). In addition, high osmotic pressure favored water permeation, and at the same concentration of DS, magnesium chloride (MgCl₂) exhibited better properties than NaCl. These results all suggested that GO‐CS was a good modifier to fabricate FO membrane, and MgCl₂ was a good DS candidate.     

高温超导体磁通跳跃数值模拟

文中基于超导磁通动力学理论,考虑电磁力与热激活对磁通运动的影响,基本物理模型由等效电阻率随超导体温度和磁场变化的磁通扩散方程,以及比热随超导体温度变化的热传导方程组成。在此基础上,用差分法数值求解了这一复杂非线性系统的磁热耦合控制方程,得到了与实验观测结果基本一致的数值模拟结果。结果还表明：外加磁场变化速度、超导体初始温度以及超导尺寸对于磁通跳跃均产生明显的影响。     

高温超导体磁通钉扎和磁通动力学研究简介

ψ=ψ0eiφ行为用统一的波函数进行描述,其相位φ在宏观尺度上是相同的.当磁场低于一定值的时候,在超Φ0=h/2e保证最大的界面面积,降低系统能量.该最小的磁通束被称为磁通量子,其磁通量是(h为普朗克超导态是一个宏观量子相干态,其载流子是库珀对.在没有外加磁场和电流的时候,这些库珀对的运动导体的边界处穿透深度内会出现一...     

1.3 GHz超导腔磁通排出效应研究

设计并搭建了一套高精度的磁场测量和补偿系统,并结合中国科学院高能物理研究所(IHEP)的2K超导腔垂直测试平台对1.3 GHz单加速间隙超导腔的磁通排出效应开展了实验研究:利用研制的磁场测量和补偿系统能够精密地测量超导腔赤道位置磁场,并能够将磁场补偿至小于5.0×10-8 T;并对超导腔不同表面温度梯度下的磁通排出效应进行了测量分析;对钉扎了磁场的超导腔进行了射频性能测试,研究了超导腔电阻对磁通钉扎的敏感度,以及在不同电场梯度下超导腔的表面电阻变化情况。结果表明,研制的高精度磁场测量和补偿系统能够满足超导腔磁通排出研究的需求;高的超导腔表面温度梯度有利于磁通的排出;磁通钉扎电阻的敏感度随着加速电场梯度的增加而增大,导致超导腔的性能下降。此实验研究也为后续超导腔的研制奠定了一定基础。     

一种限制周期气固两相流直接数值模拟中整体质量流率的新方法

全周期边界条件的气固两相流系统是研究气固相互作用的一个常用计算模型。为平衡周期气固系统在流向上的受力,常对系统施加平衡系统总重力的固定压力梯度,但由于数值误差的影响,这种固定压力梯度的方法会使得气固系统整体不断加速进而导致模拟失真。为了降低系统质心加速度的影响,本文先后采用了前人提出的固定整体质量流率方法和本文提出的压力梯度后验修正方法,并对两种方法的模拟结果进行了对比。     

Anisotropic phononic crystal structure with low-frequency bandgap and heat flux manipulation

This study presents a two-dimensional phononic crystal with heat flux manipulation and wide bandgaps of out-of-plane modes within the low-frequency range. The anisotropic matrix made of spiral-multilayered materials with different thermal conductivities, and the coating layer inserted with metal are designed for heat flux manipulation. Rubber-coated metal cylinders are periodically embedded in the anisotropic matrix to obtain the low-frequency bandgaps of out-of-plane modes. Numerical simulation is carried out to validate the heat and elastic characteristics of the spiral-multilayered anisotropic structure and reveal the effects of the laying angle and temperature on the bandgaps. Subsequently, a spiral-multilayered plate with periodic structures is studied, which shows an obvious vibration attenuation in the frequency ranges of the bandgaps and a deflected heat flux from the initial propagation direction. In the experimental investigation, the multi-phase spiral-multilayered anisotropic plate is simplified to a single-phase anisotropic plate made of aluminum. The characteristics of this type of anisotropic phononic crystal structure may pave the way for the design of a new kind of thermo-acoustic metamaterial serving in combined thermal and acoustic environments.     

等热流密度加热垂直下降液膜的研究

利用等热流密度加热条件下降膜流动的三维模型方程进行线性稳定性分析和数值模拟。线性稳定性分析表明,模型方程在小到中等Reynolds数下都适用,并且流向不稳定性增长率随着Reynolds数和Marangoni数增加而增加,展向不稳定性增长率则随着Marangoni数增加而增加,随着Reynolds数增加而减小,流向和展向对扰动波数都存在一个不稳定区间。三维数值模拟表明,在等热流密度加热条件下,液膜在随机扰动的情况下最终会形成带孤立波的三维溪流状结构,液膜与气体的换热也因溪流状结构的出现而加强;在随机扰动的基础上引入占优势地位的展向最不稳定扰动会使得换热增强,液膜会提前破裂;在随机扰动的基础上引入占优势地位的流向最不稳定扰动时,液膜的换热会增强,但不会提前破裂;在随机扰动的基础上同时引入占优势地位的流向和展向最不稳定扰动时,换热会加强且液膜会提前破裂。     

Statistics of polymer capture by a nanopore: A Brownian dynamics simulation study

We investigate the statistics of polymer capture by a nanopore using Brownian dynamics simulations. It is found that when the velocity flux is greater than a critical velocity flux, the capture picture is a random selection process, otherwise it tends to a statistical process governed by energetic considerations. In addition, the chain ends capture probability decreases as the chain length increases and satisfies a power-law scaling of P0(N)~N-0.8.     

三嵌段两亲性聚乳酸共聚物的合成及其PVDF共混膜的制备

利用原子转移自由基聚合法(ATRP)合成三嵌段两亲性聚乳酸共聚物聚乙烯吡咯烷酮-聚乳酸-聚乙烯吡咯烷酮(PVP-b-PLA b-PVP),然后将其与聚偏氟乙烯(PVDF)进行其混,制备PVP-b-PLA-b-PVP/PVDF共混膜.结果表明:PVDF膜表面致密,膜断面中指状大孔和海绵状孔同时存在,而共混膜表面多孔,指状大孔贯穿整个断面;与PVDF膜相比,共混膜的孔隙率和孔径增大,水通量提高了158.87％,接触角下降了16.70％,抗污染指标下降了64.7％.     

神府烟煤以及贵阳贫煤分别与木屑掺烧灰沉积特性研究

利用CCD相机和沉积探针组成的在线监测系统，在50 kW下行炉上研究了木屑与神府烟煤以及贵阳贫煤的掺烧灰沉积特性。灰渣沉积过程可分为三个阶段：缓慢增长阶段、快速增长阶段和稳定阶段。烟煤掺烧灰沉积厚度随着木屑掺烧比例的增加而增加，贫煤掺烧灰沉积厚度则随着木屑掺烧比例增加而减小。烟煤中掺烧木屑比例为0、6.7%、15%和22%时，渣层稳定厚度分别为1.37、3.85、11.50、20.56 mm，稳定相对热流密度分别为0.44、0.41、0.30、0.26。贫煤掺烧木屑比例为6.7%、15%和22%时，稳定厚度分别为18.65、10.97和9.78 mm，稳定相对热流密度分别为0.29、0.31、0.33。掺烧木屑之后，灰渣初始层中Ca、K元素显著增加。在相同温度下，随着木屑掺烧比例的增加，灰中熔融相比例增加，因为木屑灰分中含有较多的Na₂O、K₂O等碱金属氧化物，而Al₂O₃、SiO₂等含量较少，降低了灰的熔融温度。