化学发光消耗型锰传感器

化学和生物发光是由化学反应产生的一种光辐射,不需要任何光源。又由于它们具有高灵敏度、宽线性范围和相对比较便宜的仪器等优点,因而在化学和生物传感器领域引起了广泛的兴趣。已用于H_2O_2、乳酸和胆固醇等多种生物活性物质的测定,但未见有金属离子传感器的报道。本文发展了一种新型的全固态模式的消耗型锰离子化学发光传感器。该传感器将除待测物外的所有化学发光反应试剂全部固定在阴离子交换树脂Amberlyst A-27上,于化学发光反应之前,将一定量化学发光试剂从固定化试剂柱上洗脱,与样品中的锰离子产生化学发光。已成功地应用于水样中痕量锰离子的测定。每个固定化试剂柱可连续使用100次以上。 1 实验部分 1.1 仪器和试剂 化学发光传感器由流动系统和检测系统两部分组成。其中流动系统主要由蠕动泵、六通阀、固定化试剂柱和流通池组成。检测系统由光电信增管、负高压、放大器和记录仪组成(图1)。     

动力学—压电石英晶体传感器测定水中微量汞的研究

基于涂银压电石英晶体对ＣＮ＾－离子的灵敏响应，应用汞对六氰合铁酸钾与邻二氮杂菲反应的动力学催化作用，建立了动力学－ＰＱＣ传感器单面触液测定微量汞的新方法。研究了ＰＱＣ传感器对汞的响应机理，响应曲线，实验条件及共存离子干扰情况。     

Nonenzymatic Glucose Detection with Good Selectivity Against Ascorbic Acid on a Highly Porous Gold Electrode Subjected to Amalgamation Treatment

A nonenzymatic glucose sensor with good selectivity for the ascorbic acid oxidation is presented. After the gold polycrystalline electrode was subjected to amalgamation treatment, two advantageous effects were observed. One is the enhancement of the surface roughness and the other is an increase in the catalytic current in the glucose oxidation. Besides the known first effect, the latter provided another advantageous effect in a fabrication of nonenzymatic glucose sensor. Using a gold electrode subjected to amalgamation treatment for 60 s, two calibration curves for glucose oxidation at two different potentials of ?0.1 V and 0.25 V were obtained and compared. At the potential of ?0.1 V, at which no ascorbic acid was oxidized and no interference effect was observed, a current sensitivity of 16 μA cm^?2 mM^?1 from zero to 10 mM glucose concentration range was obtained. At the other potential of 0.25 V, at which ascorbic acid was easily oxidized, a satisfactory calibration curve with negligible ascorbic acid interference was also obtained together with a more enhanced current sensitivity of 32 μA cm^?2 mM^?1.     

Optimization of a portable microanalytical system to reduce electrode fouling from proteins associated with biomonitoring of lead (Pb) in saliva

There is a need to develop reliable portable analytical systems for on-site and real-time biomonitoring of lead (Pb) from both occupational and environmental exposures. Saliva is an appealing matrix since it is easily obtainable, and therefore a potential substitute for blood due to existing reasonably good correlation between Pb levels in blood and saliva. The microanalytical system is based on flow-injection/stripping voltammetry with a wall-jet (flow-onto) microelectrochemical cell. Samples that contain as little as 1% saliva can cause electrode fouling, resulting in significantly reduced responsiveness and irreproducible quantitations. In addition, incomplete Pb release from salivary protein can also yield a lower Pb response than expected. This paper evaluates the extent of in vitro Pb-protein binding and the optimal pretreatment for releasing Pb from the saliva samples. Even in 50% by volume of rat saliva, the electrode fouling was not observed, due to the appropriate sample pretreatment and the constant flow of the sample and acidic carrier that prevented passivation by the protein. The system offered a linear response over a low Pb range of 1-10 ppb, low detection limit of 1 ppb, excellent reproducibility, and reliability. It also yielded the same Pb concentrations in unknown samples as did the ICP-MS. These encouraging results suggest that the microanalytical system represents an important analytical advancement for real-time non-invasive biomonitoring of Pb.     

Intramolecular dimers: a new design strategy for fluorescence-quenched probes

Fluorogenic probes dual-labeled with reporter and quencher dyes use a change in fluorescence to monitor biochemical events (e.g., substrate binding or enzyme digestion). Such events change the reporter-quencher distance, which affects fluorescence. Recently, it is has been shown that static quenching through intramolecular dimers is an important mechanism that can sometimes be more efficient than F?rster resonance energy transfer (FRET).     

Use of a Carbon Paste Electrode Modified with Spinel‐Type Manganese Oxide as a Potentiometric Sensor for Lithium Ions in Flow Injection Analysis

A potentiometric sensor constructed from a mixture of 25% (m/m) spinel‐type manganese oxide (lambda‐MnO₂), 50% (m/m) graphite powder and 25% (m/m) mineral oil is used for the determination of lithium ions in a flow injection analysis system. Experimental parameters, such as pH of the carrier solution, flow rate, injection sample volume, and selectivity for Li⁺ against other alkali and alkaline‐earth ions and the response time of this sensor were investigated. The sensor response to lithium ions was linear in the concentration range 8.6×10^?5–1.0×10^?2 mol L^?1 with a slope 78.9±0.3 mV dec^?1 over a wide pH range 7–10 (Tris buffer), without interference of other alkali and alkaline‐earth metals. For a flow rate of 5.0 mL min^?1 and a injection sample volume of 408.6 μL, the relative standard deviation for repeated injections of a 5.0×10^?4 mol L^?1 lithium ions was 0.3%.     

High-level expression of soluble human β-defensin-2 fused with green fluorescent protein in Escherichia coli cell-free system

Human β-defensin-2 (hBD2), a small cationic peptide, exhibits a broad range of antimicrobial activity and does not acquire any microbial resistance. To produce this uneasily detectable, degradable, and toxic polypeptide efficiently, an alternative approach based on the Escherichia coli cell-free biosynthesis system was proposed. The approach implies that a polypeptide of interest is synthesized as a fusion protein linked to a green fluorescent protein (GFP) through a cleavable spacer. With batch-mode operation, a significant amount of hBD2 fused with GFP (0.25 mg/mL) can be expressed in this cell-free system. The productivity of the fusion protein can be improved up to 1.2 mg/mL by employing a continuous-exchange cell-free system. Furthermore, the GFP moiety provides directly visible and quantitative monitoring of the polypeptide synthesis, and the product is soluble and stable. This work will be helpful in allowing the rapid and visible expression of other similar defensins using an in vitro cell-free system.     

Nafion-PAN optical chemical sensor: optimization by FIA

A copper-sensitive optical chemical sensor (optrode) is described. The optrode is based on a Nafion membrane and an immobilized organic ligand coupled with a flow injection (FI) system. The FI system includes a flow-through removable measuring cell and a simple spectrophotometer. Owing to the miniature size of the system and the efficient use of optical fibers, this optrode is well suited for monitoring environmental water samples. The success of the described optrode system depends on the effectiveness of the FI reagent delivery system. Optimum contact time with the membrane (as determined by the reagent flow rates) and the injected sample volume are critical. Environmental water samples were analyzed for copper content using the optimized optrode system. To validate the optrode's performance, the same water samples were analyzed using the atomic absorption spectrophotometer.     

Chemical sensors (review)

The capabilities and development prospects of chemical sensors as a new area in analytical chemistry and instrument engineering are discussed. Problems of terminology, principles of operation, basic characteristics, and also applications of chemical sensors and sensor analyzers made from them are discussed.From the materials of a report given at a joint scientific session of the departments of the physicochemistry and technology of inorganic materials and of general and technical chemistry.V. I. Vernadskii Institute of Geochemistry and Analytical Chemistry, Russian Academy of Sciences, Moscow 117975. Translated from Izvestiya Akademii Nauk, Seriya Khimicheskaya, No. 3, pp. 487–493, March, 1992.     

Immobilization of glucose oxidase with the blend of regenerated silk fibroin and poly(vinyl alcohol) and its application to a 1,1′- dimethylferrocene-mediating glucose sensor

The structure and properties of the blend of regenerated silk fibroin (RSF) and poly(vinyl alcohol) (PVA) were investigated. The two polymers in the blend are in the state of phase segregation. Infrared (IR) spectra indicate that the RSF in the blend maintains its intrinsic properties, thus, ethanol treatment can transfer silk I structure of RSF to silk II structure. The water absorption property and mechanical property of the blend are improved in comparison with those of RSF. The blend maintains the major merit of RSF, that is, it can immobilize glucose oxidase on the basis of the conformational transition from silk I structure to silk II structure. The properties of the immobilized enzyme are examined. Moreover, the second generation of glucose sensor based on the immobilized enzyme is fabricated and it has a variety of advantages including easy maintenance of enzyme, simplicity of construction, fast response time and high stability.