毛细管气相色谱法测定烟草及烟气中有机氯农药残留量

烟草样品或从卷烟烟气中收集到的固态悬浮颗粒样品以正己烷在索氏提取器中提取,提取液用弗罗里硅土固相萃取净化,所得溶液经蒸缩至5mL后,供气相色谱法测定。采用DB-5弹性石英毛细管柱分离样品,电子捕获检测器检测,共测定了17种有机氯农药(OCP′s),其检出限(3S/N)在0.02～0.10μg.g-1范围内。平均加标回收率为86%～92%,相对标准偏差(n=7)为3.0%～4.1%。     

Stack effects on smoke propagation in subway stations

In fires of subway stations, the most immediate threat to passengers' life is not the direct exposure to fire, but the smoke inhalation because it contains hot air and toxic gases. To understand the mechanisms driving the motion of smoke is therefore an important issue of fire safety, and the stack effect is found to be an important mechanism having significant influence. In this paper, we compute the three-dimensional smoke flow fields under various fires happened in a representative subway station of Taipei Rapid Transit System. To clarify the mechanisms corresponding to the stack effect, a simplified three-dimensional configuration is also considered. Results indicate that, without mechanical smoke control, the stack effect plays a decisive role and is virtually the sole factor influencing the smoke movement. Because of the stack effect, most or sometimes all of the smoke will choose a vertical shaft (usually a stairwell) to evacuate, and the cross sectional area of the shaft and the location of fire determine which shaft is chosen. Present computational results show the evidences of the importance of the stack effect and provide both valuable information to the design of the passenger evacuation routes in fires as well as criteria to the design of smoke control systems of subway stations.Received: 16 January 2003, Accepted: 10 March 2003, Published online: 12 September 2003     

An asymptotic‐induced one‐dimensional model to describe fires in tunnels II: the stationary problem

We study stationary solutions of a one‐dimensional low‐Mach‐number model derived in Gasser and Struckmeier (Math. Meth. Appl. Sci. 2002; 25 (14): 1231) to describe fire events in long tunnels. The existence of solutions of the corresponding stationary model is shown to be equivalent to the existence of solutions of an algebraic problem. Multiple solutions are shown to be possible. The relation between different formulations of the problem is analysed. Weak and special distributional solutions are considered. Finally, numerical examples of realistic tunnel data with single and multiple solutions of the stationary problem are given. Copyright © 2003 John Wiley & Sons, Ltd.     

Application of vibrational spectroscopy techniques for material identification from fire debris

The primary goal of this research is to demonstrate the use of vibrational spectroscopy techniques as a tool for the identification of materials post fire. This paper discusses the use micro-Raman spectroscopy and ATR-FTIR to identify materials found in fire debris. The polymeric materials under study were high density and low density polyethylene (HDPE and LDPE), polyvinyl chloride (PVC), polymethyl methacrylate (PMMA) and cotton. These are commonly materials found in households around the world, their identification from the debris provides useful forensic information on the spatial distribution of fuels in a fire compartment, thus allowing for accurate analysis and modelling. Earlier work has established Raman spectroscopy to be a very good tool for material identification post fire. The addition of ATR-FTIR spectroscopy as a technique in developing this novel tool for identification of materials post fire has established vibrational spectroscopy in the area of fire investigation. This study indicated that the limitations associated with Raman spectroscopy in post fire identification, could be made insignificant by the strengths of ATR-FTIR spectroscopy and vice versa. To further establish the validity of this identification process principal component analysis was used to discriminate between the spectrum of the burnt materials and an error analysis computed. Both techniques demonstrated that identification could be done with very minimal confusion between the materials studied.     

固相萃取-超高效液相色谱法测定卷烟主流烟气中丙烯酰胺

建立了一种固相萃取-超高效液相色谱法(SPE-UPLC)快速检测主流烟气中丙烯酰胺的方法。使用剑桥滤片和吸收瓶捕集主流烟气后,蒸馏水做萃取溶剂,采用C18固相萃取小柱对样品液进行纯化,用UPLC检测,外标法定量。UPLC方法采用ACQUITY UPLCTMBEH C181.7μm 2.1×50 mm色谱柱,柱温30℃,流动相为V(乙腈)∶V(水)=6∶94,流速为0.15 mL/min,紫外检测器(TUV)检测波长为202 nm,分析时间为6 min。烤烟型香烟主流烟气中丙烯酰胺的含量为4.75μg/cig。方法的线性范围为0.1~10 mg/mL,线性相关系数为0.9999;平均回收率为98.7%;检出限为10 ng/mL(S/N=3);相对标准偏差为2.3%。该方法适合主流烟气中丙烯酰胺的快速检测。     

主流烟气中甲胺和乙胺离子色谱法测定

建立了用0.01 mol·L-1盐酸水溶液吸收,离子色谱法测定卷烟主流烟气中甲胺和乙胺的方法。该方法采用Ion Pac CS16(4×250 mm)分离柱和CG16(4×50 mm)保护柱,10mmol·L-1甲烷基磺酸(MSA)水溶液等梯度洗脱,在柱温60℃、流速1.0 m L·min-1的条件下,实现了甲胺和乙胺的有效分离。方法的线性关系良好,RSD均小于5%,甲胺检出限为0.04μg/支,加标平均回收率为92.7%~94.3%,乙胺检出限为0.05μg/支,加标平均回收率为93.5%~103.0%。该方法灵敏度高、准确性好、前处理简单,有良好的可靠性和实用性。     

气相色谱-质谱法测定卷烟烟气总粒相物中的乳酸

以三甲基氢氧化硫为甲酯化试剂,正戊醇为内标,采用CP-FFAP毛细管柱(25 m×0.15 mm i.d.×0.25μm d.f)和选择离子模式,建立了卷烟烟气总粒相物中乳酸的气相色谱-质谱分析方法。该方法的线性范围为0.285~0.0570mg/mL乳酸(r=0.9997),平均回收率为97.99%,RSD为1.58%。并用该法测定了部分卷烟烟气总粒相物中的乳酸。     

固相萃取-气相色谱/质谱联用法测定卷烟主流烟气中的香兰素和乙基香兰素

采用固相萃取-气相色谱/质谱联用技术,建立了一种同时测定卷烟主流烟气中香兰素和乙基香兰素的方法。方法优化了萃取条件,考察了萃取溶剂、萃取时间对检测结果的影响。通过硅藻土固相萃取柱净化并浓缩后,选取DB-HeavyWAX毛细管柱进行目标物分离,以香兰素-d3作为内标,对香兰素和乙基香兰素进行定量分析。结果表明,香兰素和乙基香兰素在浓度0.2~20.0 mg/L范围内具有良好的线性关系,其检出限分别为9.1 ng/支和6.5 ng/支,回收率均在96.3%~107.7%之间。     

离子色谱法测定卷烟主流烟气中的硫化氢

建立了测定卷烟主流烟气中硫化氢含量的离子色谱法.采用玻璃纤维滤片捕集卷烟烟气粒相物,并用0.5%(体积分数)乙二胺-50 mmol/L氢氧化钠-250 mmol/L乙酸钠溶液萃取粒相物,吸收液吸收气相物中的硫化氢,合并粒相萃取液与气相吸收液,经离子色谱柱分离,以1.5 mol/L氢氧化钠-1 mol/L乙酸钠-2%(体积分数)乙二胺(40∶50∶10,体积比)为流动相,安培检测器检测并施加-100 mv的检测电位.运用方法对12种市售卷烟样品进行了测定,结果表明:方法的线性范围为0.1~5.0μg/mL,检出限为1.03μg/mL,定量限为3.41μg/mL,回收率为102.3%~107.2%,相对标准偏差小于5%.方法处理简单、准确度高,可以用于卷烟烟气中硫化氢含量的测定.     

在线液相-气相二维色谱高灵敏测定卷烟主流烟气中的4-（N-甲基亚硝胺基）-1-（3-吡啶基）-1-丁酮

建立了在线液相-气相二维色谱测定卷烟主流烟气中4-(N-甲基亚硝胺基)-1-(3-吡啶基)-1-丁酮(NNK)的方法。 NNK 的分析在在线凝胶气质联用仪上进行,采用自行装填的微型碱性氧化铝柱,并把仪器上的凝胶柱换成氧化铝柱,用于 NNK 的分析。捕集有主流烟气总粒相物的剑桥滤片用二氯甲烷提取,以 D4-NNK 为内标,提取液经微型氧化铝柱分离,含 NNK 的部位切割进入气相色谱,排干溶剂后启动气相色谱升温经毛细管柱进行分离,用质谱检测。本方法将烟气国标方法 NNK 测定中的氧化铝柱色谱净化和气相色谱-质谱分析在线连接起来,可不经样品前处理净化直接进样分析;每次进样可达40μL,是常规气相色谱-质谱分析最大进样量(2.0μL)的20倍,显著提高了分析灵敏度。方法线性范围达1.2~120 ng/ mL,相关系数为r=0.9998,回收率为93.9%~96.0%;检出限和定量限分别为0.25 ng/ mL 和0.9 ng/ mL,样品分析结果与中国烟草总公司企业标准方法进行对比,结果相符合。