磁力负刚度薄膜结构低频吸声特性

针对背腔深度较小的薄膜吸声结构难以实现低频吸声的问题,提出了磁力负刚度的解决方法。采用传递矩阵法,建立了负刚度薄膜吸声结构理论模型,分析得出该结构的声阻抗等同与大背腔常规薄膜吸声结构的声阻抗;阻抗管实验验证得出,在一定磁场条件下,不同背腔的负刚度薄膜吸声结构与无负刚度结构相比其共振频率显著下降,吸声系数曲线与理论结构吻合。负刚度机制能够降低薄膜吸声结构的共振频率,用较小背腔实现低频吸声,从而实现薄型低频吸声结构设计。     

共焦腔增强的空气拉曼散射

拉曼光谱是一种无损、快速的物质成分分析和检测方法.由于拉曼信号强度微弱,使得拉曼光谱的检测应用受到极大的限制.针对增强拉曼散射信号强度、提高检测灵敏度这一问题,设计了一种用于自发拉曼散射信号增强的共焦腔样品池,开展了基于该共焦腔的空气拉曼散射信号增强研究.共焦腔的腔镜反射率为92%,这一设计在保证共焦腔通带宽度与激光器线宽匹配的同时能有效地降低共振调节难度.实验中采用0°探测构型收集拉曼信号,并由成像式拉曼光谱仪获取光谱信号.实验发现,在共振状态下,共焦腔的耦合效率达到87.5%,单向激光功率实现约11倍放大;与无共振腔相比,共焦腔对拉曼信号实现17倍放大,信噪比提高2倍.此外,空气中CO_2的3σ检测限达到200 ppm量级.结果表明,该系统对自发拉曼散射信号增强效果显著,并且有较高的检测灵敏度.     

Atomic NOON state generation in distant cavities by virtual excitations

A general scheme of generating NOON states of virtually-excited 2N atoms is proposed. The two cavities are fibre-connected with N atoms in each cavity. Although we focus on the case of N = 2, the system can be extended to a few atoms with N 〉2. It is found that all 2N atoms can be entangled in the form of NOON states if the atoms in the first cavity are initially in the excited states and atoms in the second cavity are all in the ground states. The feasibility of the scheme is carefully discussed, it shows that the NOON state with a few atoms can be generated with good fidelity and the scheme is feasible in experiment.     

"量身定做"单光子波包:在量子网络中控制光子/自旋量子界面

文章简要地介绍了如何在量子网络中控制量子界面动力学以实现静态量子比特和动态量子比特的相互转换．具体言之，该界面由半导体量子点、固体光学微腔以及光学波导管构成，静态及动态比特分别为量子点中的电子自旋和波导管中的单光子波包所携带．界面动力学的控制则是基于对量子点、微腔和波导管耦合系统的量子电动力学的严格求解．据此可实现网络中两个远距离节点间的量子态传输、交换以及确定性的建立量子纠缠等量子操作．上述量子界面亦可用于任意指定波形的单光子源或者单光子探测装置。     

LD端抽运平直腔Nd:YVO4固态激光器的输出功率特性研究

对LD端抽运平直腔Nd:YVO₄固态激光器输出功率特性受激光器内在诸因素(热透镜效应、腔长、激活孔径等)的制约关系进行了研究.并用传播圆-变换圆图解分析方法给出了合理的解释，同时，对进一步提高其输出功率特性指出了方向. 关键词： 固体激光器 热透镜 变换圆 平直腔     

全固态高功率连续单横模Nd:YVO4/LBO绿光激光器

报道了激光二极管泵浦的高功率连续单横模绿光激光器。考虑到激光晶体因吸收泵浦光而产生的热透镜效应,我们选择低掺杂浓度Nd:YVO4激光晶体,设计了V字型热不灵敏折叠式驻波谐振腔,利用I类非临界相位匹配LBO非线性晶体,当泵浦功率为23 W时,得到7 W单横模532 nm绿光输出功率,光-光转化效率为33%,长期功率稳定性优于1.6%(自由运转3小时)。     

北京大学DC-SC光阴极注入器的升级设计

 基于直流电子枪-超导加速腔（DC-SC）光阴极注入器样机的初步实验结果,北京大学提出了新的注入器的改进设计。新注入器核心结构包括皮尔斯枪和3+1/2超导腔。文章给出了它们的详细结构参数,然后采用程序,对注入器的束流动力学进行了模拟。结果发现：新注入器可以提供具有高束流品质、高平均流强的电子束,束团的电荷量100 pC,横向发射度低于2 mm·mrad,脉宽5 ps,rms束斑可达0.5 mm,重复频率81.25 MHz;也可以提供电荷量为300 pC低重复频率的高峰值流强的电子束,其横向发射度小于3 mm·mrad,脉宽约为9 ps,以满足北京大学自由电子激光（PKU-FEL）实验平台的要求。     

Complete and Nondestructive Atomic Bell‐State Analysis Assisted by Inverse Engineering

A protocol for complete and nondestructive atomic Bell‐state analysis by using inverse engineering is presented. The setups for the Bell‐state analysis contain four atoms trapped in four separated cavities, respectively. The laser pulses designed by inverse engineering help in the manipulation of the transitions of atoms in a robust manner. By using the protocol, the information for distinguishing four Bell states of two information‐carrying atoms is encoded on two auxiliary atoms. Therefore, the four Bell states can be distinguished without being destroyed by detecting the states of the two auxiliary atoms. Moreover, as shown by the numerical simulations, the protocol has high successful probabilities to distinguish four Bell states when decoherence is considered. Thus, the protocol may provide some helpful perspectives for the quantum information tasks based on Bell states.     

Forced convection heat transfer from porous heat sinks placed in partially open cavity: Some case studies

In this present study, the forced convection heat transfer from aluminum foam heat sinks with 10, 20, 40 PPI pore density placed in a discrete form in a partially open cavity were experimentally investigated. Air was used as working fluid. The uniform heat flux was applied to 3 × 3 array of foam heat sinks horizontally mounted in the cavity. The experimental studies were performed for the 3363–9743 range of Reynolds number and the 2.7 x 10⁶ and 7.5 x 10⁶ range of modified Grashof number. The effects of the Reynolds number, the modified Grashof number and the pore density of foam heat sink on the heat transfer were investigated. The results obtained were compared with the results obtained without foam heat sink cases. In addition, the most heated elements within the cavity were identified and solution proposals were presented. In addition, the most heated elements within the cavity were identified and solution proposals were presented.     

利用法布里-珀罗腔抑制电光相位调制中的剩余幅度调制

激光经电光相位调制后,由于剩余幅度调制的存在造成调制边带幅度不相等。利用法布里-珀罗腔的透射特性和Pound-Drever-Hall技术对通过法布里-珀罗腔的调制光正、负一级边带的幅度产生不同的衰减,使得调制边带的幅度相等,从而实现对电光相位调制中剩余幅度调制的抑制。采用该方法,理论上计算了调制光经法布里-珀罗腔后的光外差光谱信号,获得锁定法布里-珀罗腔后调制边带幅度的不对称度较腔锁定前减小四个数量级。实验研究了调制光经法布里-珀罗腔透射的光外差光谱,结果表明将法布里-珀罗腔锁定于该透射光外差光谱中心零位时,对剩余幅度调制的抑制程度可达45 dB。