Sol-Gel Processing of PbZrO3 Thin Films

PbZrO₃ (PZ) thin films have been prepared by 2-methoxyethanol route from lead oxide or lead acetate and zirconium n-butoxide. The use of lead oxide as lead source and the seeding layer of TiO₂ on Pt/TiO₂/SiO₂/Si substrate facilitate the formation of the perovskite phase.     

Pore size distributions in low‐k dielectric thin films from X‐ray porosimetry

X‐ray reflectivity has been used to determine the mass uptake of probe molecules in porous thin films supported on thick silicon wafers. The adsorption occurs by capillary condensation when the films are exposed to probe vapor at controlled partial vapor pressures. The probe solvent partial pressure was varied by mixing saturated air and dry air at constant temperature or by changing sample temperature at a constant vapor concentration. Pore size distribution in the films can be calculated from the probe uptake with typical porosimetric approaches such as the application of the Kelvin equation to convert partial pressure into pore size. For illustration, the pore size distribution of three different nanoporous thin films, the primary candidate of ultra‐low‐k interlevel dielectrics in the next generation of integrated circuit chips, was determined with this technique. These samples represent different generations of low‐k dielectrics developed by industry. © 2002 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 40: 2170–2177, 2002     

Irreversible and reversible phase transitions of alkyl monolayers. Gas chromatographic evidence of polar solvent influence on the adsorbing properties of the layer

Summary Further to Gilpin's observations in liquid chromatography of the irreversible transformation of alkyl grafts, following the replacement of an organic mobile phase by an aqueous one, we describe some gas chromatographic experiments which lead to similar (log V_s, I/T) plots, as a consequence of the same solvent release process.We use paraffin films on siliceous supports or hydroxylated liquid substrates or C₂₂-alkyl bonded silica. These experiments demonstrate that this irreversible transition and the melting-like reversible transition are completely different phenomena. They confirm the existence of at least three kinds of monomeric alkyl films.     

Magnetism of metal cyanide networks assembled at interfaces

Studies of metal cyanide thin films prepared directly at interfaces are reviewed. The systems range from monolayers, single-layer analogs of Prussian blue-like networks, to bulk powders prepared as thin films. Monolayer networks are prepared at the air/water interface and transferred to solid supports using Langmuir-Blodgett film methods. Films of bulk materials are prepared directly on solid surfaces using a templated sequential deposition procedure. The magnetic properties of the films have been explored, and in some cases, these monolayers and surface films give rise to new behavior that is only possible because of the fabrication method or thin film architecture. The methods of synthesis can generate oriented samples, even when the materials are poorly crystalline. Furthermore, the interface-assembled networks are inherently anisotropic, leading to phenomena not present in the solid-state analogs, such as anisotropic photomagnetism in a thin film of Rb_jCo_k[Fe(CN)₆]_l·nH₂O.     

Influence of target surface degradation on the properties of r.f. magnetron‐sputtered calcium phosphate coatings

This paper reports a detailed study of how repeated r.f. magnetron sputtering from a hydroxyapatite (HA) powder target affects the nature and reproducibility of a sequential series of thin‐film coatings deposited onto Ti6Al4V substrates. An evaluation of the effective lifespan of the HA sputter targets and the reproducibility of the calcium phosphate (CaP) coatings produced from them has been made from Fourier transform infrared spectroscopy, XPS and, as appropriate, atomic force microscopy and SEM/energy dispersive x‐ray analyses. The annulus region of the target surface, from which sputtering under r.f. magnetron conditions normally occurs, showed severe surface degradation after only one deposition run, as indicated by significant PO₄^3? and OH^? depletion. This deterioration continued after each subsequent deposition cycle but to a much lesser extent than that observed in the initial sputtering period. The layers produced from all of the sputter runs contained the expected Ca²⁺ and PO₄^3? species characteristic of a CaP system but were OH^? deficient in the as‐deposited state. However, the chemical and morphological properties of the coatings did not change significantly until after the third consecutive sputter cycle. Hence, these data indicate that, even though a significant level of degradation of the HA target occurs at the outset of the sputtering procedure, the general plasma conditions employed here have a dominant influence on the coating properties until a critical degradation condition is met. As such, the compacted HA powder targets of interest can have a life‐cycle greater than single usage without detriment to the chemistry and morphology of the coatings produced from them. Copyright © 2003 John Wiley & Sons, Ltd.     

A technique for coating capillary columns with a very thick film of cross-linked stationary phase

A method for preparation of capillary columns and traps with a very thick film (up to 100 μm) of stationary phase is described. The principle of this method is based on an immediate fixation of a film of prepolymer, formed during dynamic coating. Thus, the development of film irregularities, such as are caused by Rayleigh instability is avoided. Fixation of the film is conveniently accomplished by heat-accelerated crosslinking as was demonstrated in this work, where a commercially available silicone prepolymer (Sylgard 184, Dow Corning) was employed. The low phase ratio columns which thus can be prepared are interesting both in chromatography with dense mobile phases and as enrichment devices. Examples of the latter application are shown, where trace organic components from air and water were concentrated.     

COMPENSATION EFFECT OF POLYIMIDE THIN FILMS ON NORMALLY WHITE TWISTED NEMATIC LIQUID CRYSTAL DISPLAYS

The disadvantages of Normally White Twisted Nematic Liquid Crystal Display (NW-TN-LCD) were discussed. The reason that the negative birefringent polyimide thin filmswere used to compensate NW-TN-LCD to decrease off-axis leakage, improve contrast ratiosand enlarge viewing angles was explained in this paper. A certain polyimide thin film wastaken as an example to show compensation effect on NW-TN-LCD.     

Photocatalytic Oxidation of Aniline in the Gas Phase Using Porous TiO2 Thin Films

The gas-phase photocatalytic oxidation of aniline on a new kind of porous nano-TiO₂ composite films is investigated. The composite film was prepared on glass fiber with the water glass as binders and dilute H₂SO₄ solution as solidifying reagent. The surface characters were observed by scanning electron microscope. The photocatalytic degradation of aniline on the composite films was carried out in a TiO₂/UV system. Some important factors affecting the photodegradation, such as the concentration of TiO₂, the initial concentration of aniline, and the existing water vapor, are also studied. The product of photocatalytic oxidation was detected by Fourier transform-Infrared. The partial intermediate products were absorbed on TiO₂ surface, which resulted in catalyst deactivation. But when it was irradiated under UV illumination or solar irradiation for some time, the catalyst could be reused without loss of catalytic activity. Translated from the Journal of Wuhan University (Natural Science Edition), 2005, 51(2) (in Chinese)     

ELECTROCHROMETIC STUDIES ON POLAR MULTILAYERS OF LIQUID CRYSTALLINE POLYMERS

Electrochrometic measurements were carried on the Z-type Langmuir-Blodgett films oftwo liquid crystalline polymers: mono-{6-[4-(phenylazo) naphthyloxy] hexyl} (1a) andmono-{6-[4-(anthraquinone-1-azo) naphthyloxy] hexyl} (2a) ester of polymaleic acid. Itwas found that for both polymers, poling fields parallel and antiparalle1 to dipole momentsof the polymer side chains induce red and blue shift in absorption bands, respectively. Forpolymer la blue shift is accompanied by absorbance increase, while red shift by absorbancedecrease;but for polymer 2a only decrease in absorbance is observed. A simple model wasproposed to analyze the results.     

6AZO-CONTAINING SELF-ASSEMBLY ULTRA-THIN FILMS AND THEIR PHOTOVOLTAIC PROPERTIES

A kind of azo-containing resin (Azo-R) was synthesized by a simple way through the coupling reaction of 2-nitro-N-methyldiphenylamine-4-diazoresin (NDR) with phenol, and a new covalentely attached multilayer film from Azo-R as H-donor and photosensitive diazoresin, diphenylamine-4-diazoresin (DR) as H-acceptor via H-bonding attraction by selfassembly technique has been fabricated. Following the decomposition of diazonium group of DR under exposure to UV light, the H-bonds between the layers of the film convert to covalent bonds and the film becomes very stable toward polar solvents or electrolyte aqueous solutions. Thus the UV-irradiated azo-containing films can be used to measure photocurrent in a conventional three-electrode photoelectrochemical cell using KCl as supporting electrolyte. It was confirmed that the azo-containing multilayer film is responsible for the photocurrent generation.