A realization of digital wireless transmission for MRI signals based on 802.11b

In this paper, a digital wireless transmission system based on 802.11b standard for magnetic resonance imaging (MRI) application is designed and built for the first time to eliminate the interference aroused by coil array cables. The analysis shows that the wireless receiver has a very high sensitivity to detect MRI signals. The modulation technique of differential quadrature phase shift keyed (DQPSK) can be applied to MRI data transmission with rate of 2 Mbps and bandwidth of 2 MHz. The bench test verifies that this wireless link has a dynamic range over 86 dB supporting up to 3 T MRI system data transmission. The 2D spin echo imaging of phantom is performed and the SNR of the image obtained by the wireless transmission can be comparable with that got by the coaxial cables.     

An optimization method for designing SENSE imaging RF coil arrays

An optimization method in RF coil array design for SENSE imaging is described. Using this method the optimized RF coil geometries can be calculated numerically given the required SENSE imaging performance. Although this method can be applied to optimize the RF coil arrays for both 1D and 2D SENSE imaging, to demonstrate the potential applications of this method, we designed RF coil arrays for 2D SENSE imaging and compared their performance by simulation. An optimized 4-channel receive-only RF coil array designed for 2D SENSE imaging was implemented and tested to demonstrate the feasibility of the proposed technique. Imaging results showed reasonable agreement with the simulations, thus the method can be applied to RF coil array designs for SENSE imaging when optimum imaging performance is desired.     

复合材料柔软性对倒金字塔微结构阵列传感器性能的影响

采用模压成型方法制备了2种柔软性不同的热塑性聚氨酯/短切碳纤维/碳纳米管(TPU/SCF-CNT)复合材料复制物, 其表面上具有倒金字塔微结构阵列, 内部有SCF与CNT共同构成的导电通路. 将复合材料复制物和相应的复合材料平整片封装成柔性传感器. 结果表明, 压力作用下传感器内复制物和平整片之间的接触电阻因倒金字塔底棱的形变而显著降低. 对使用柔软性较高的复合材料封装的传感器, 虽然其相对迟滞稍大, 但压力作用下倒金字塔底棱形变量较大, 且复制物和平整片内导电通路增加量较大, 因此其在0~2.5 kPa的线性区内具有较高的灵敏度(0.32 kPa^?1). 制备的2种传感器均具有快速响应特性, 且能在500 s(约1580次)的循环压缩/释放测试(峰值压力约3 kPa)中保持较稳定的电阻响应. 研究表明, 利用模压成型的表面倒金字塔结构复合材料复制物封装成的柔性压力传感器具有良好的传感性能.     

Dithienylmaleimide-based D-A Conjugated Polymer Film: Photo-Responsive Behavior and Application in Electrical Memory and Logic Gates

Solid-stated smart polymers responsive to external stimuli have attracted much attention for potential application in the field of photoelectron devices, logic gates, sensor, data storage and security. However, it is a bigger challenge for polymers than that for small molecules in solid state to acquire stimuli-responsive properties, because polymers with high molecular weight are not as easy to change the packing structure as small molecules under external stimulation. Here, a D-A type alternating copolymer PTMF-o containing 3,4-bisthienylmaleimide(A unit) and fluorene(D unit) is designed and synthesized. Upon irradiation of sunlight, PTMF-o film exhibits a photo-response with the color altering from purple to colorless. It is attributed to the structure of copolymer transformed from ring-opening form(PTMF-o) to ring-closure form(PTMF-c), resulting from the oxidative photocyclization of 3,4-bisthienylmaleimide unit. Consequently, the ability of charge transfer(CT) from fluorene to 3,4-bisthienylmaleimide unit in PTMF-o can be easily weakened by light stimuli. PTMF-o film displays a WORM-type resistive storage performance for the strong CT. Interestingly, after exposure, the electrical memory behavior in situ transfers into FLASH type, due to weak CT in PTMF-c. PTMF-o film can also be employed as smart material to construct NAND and NOR logic gates by using light as input condition. The work provides a simple way to modify the electronic properties of polymers and realize stimuli-response in solid states.     

高效液相色谱-二极管阵列检测法测定小麦粉及面粉改良剂中福美双

福美双是重要的二硫代氨基甲酸酯(DTC)杀菌剂,在小麦中使用限量以1 mg/kg二硫化碳(CS₂)计。目前我国相关检测方法是针对二硫代氨基甲酸酯一类的化合物,二硫代氨基甲酸酯通过与酸反应生成CS₂,采用光谱法或色谱法测定CS₂,间接实现二硫代氨基甲酸酯测定。该方法无法特异性实现对福美双的检测,因此开展小麦粉中福美双检测方法的研究具有重要意义。研究建立了高效液相色谱-二极管阵列检测(HPLC-DAD)测定小麦粉及面粉改良剂中福美双的分析方法。小麦粉及面粉改良剂样品用乙腈溶剂提取后,经涡旋、振荡、冰水浴超声和静置后取上清液过滤,供高效液相色谱测定。采用ZORBAX plus-C18色谱柱(150 mm×4.6 mm, 5 μm)分离,以水-乙腈为流动相洗脱分析,在波长280 nm下检测。实验优化了提取溶剂及其体积、振荡超声条件、色谱柱、检测波长、流动相等条件。该方法采用保留时间和紫外光谱图定性,外标法定量。该方法在线性范围内(0.30~30.0 μg/mL)线性关系良好,相关系数(r²)为0.99999。对小麦粉及面粉改良剂进行1.5、3.0、15 mg/kg 3个水平的加标回收试验,福美双的回收率为89.6%~98.3%,相对标准偏差为1.6%~3.9%(n=6)。方法的检出限和定量限分别为0.5 mg/kg和1.5 mg/kg。该方法采用溶剂提取,操作简单,分析时间短,特异性好,具有精密度高、重复性好、检出限低等特点,适用于小麦粉及面粉改良剂中福美双快速、准确的定量检测。     

Copper-cobalt-nickel oxide nanowire arrays on copper foams as self-standing anode materials for lithium ion batteries

Numerous scientists are in the pursuit of energy storage materials with high energy and high power density by assembly of electrochemically active materials into conductive scaffolds, owing to the emerging need for next-generation energy storage devices. In this architectures, the active materials bonded to the conductive scaffold can provide a robust and free-standing structure, which is crucial to the fabrication of materials with high gravimetric capacity. Thus, hierarchical copper-cobalt-nickel ternary oxide (CuCoNi-oxide) nanowire arrays grown from copper foam were successfully fabricated as free-standing anode materials for lithium ion batteries (LIBs). CuCoNi-oxide nanowire arrays could provide more active sites owing to the hyperbranched structure, leading to a better specific capacity of 1191 mAh/g, cycle performance of 73% retention in comparison to CuO nanowire structure, which exhibited a specific capacity of 1029 mAh/g and capacity retention of 43%, respectively.     

相控阵雷达导引头便携测试方法及误差角波动机理分析

相控阵雷达导引头组成复杂、测试指标多、数据量大,通常需要在符合远场条件的微波暗室内测试。本文介绍了一种相控阵雷达导引头便携测试方法及测试系统的组成,分析了便携测试机理、便携屏蔽装置设计原理,解释了该便携测试系统中相控阵雷达导引头角跟踪参数测试时偶尔引起的误差角波动现象。该测试方法简便、快捷、实用、成本低,较好的解决了外场或环境试验中产品测试的需求。本文所述相控阵雷达导引头便携测试方法和相关分析结论有较高的实用价值。     

基于光楔阵列产生光学涡旋阵列的研究

在研究光楔衍射法产生单涡旋的基础上,基于长条形光楔阵列,提出了利用光束阵列衍射产生涡旋阵列的方法.该方法要求光束阵列在平行于光楔边缘方向上的光束间距等于光束直径的整数倍.利用超精密机床采用一体化加工法加工了光楔阵列元件,验证了该方法的可行性.利用空间光调制器快速灵活调整光束阵列的优点,搭建了借助空间光调制器加载达曼光栅衍射产生所需光束阵列的实验光学系统.针对光束阵列与光楔阵列的匹配问题,研究了达曼光栅掩模图基本单元对光束阵列的调控,获得了可调结构的光束阵列.实验产生了拓扑荷一致的光学涡旋阵列,与仿真结果相一致,证明所提方法的有效性.     

Three‐Phase Barker Arrays

A 3‐phase Barker array is a matrix of third roots of unity for which all out‐of‐phase aperiodic autocorrelations have magnitude 0 or 1. The only known truly two‐dimensional 3‐phase Barker arrays have size 2 × 2 or 3 × 3. We use a mixture of combinatorial arguments and algebraic number theory to establish severe restrictions on the size of a 3‐phase Barker array when at least one of its dimensions is divisible by 3. In particular, there exists a double‐exponentially growing arithmetic function T such that no 3‐phase Barker array of size with exists for all . For example, , , and . When both dimensions are divisible by 3, the existence problem is settled completely: if a 3‐phase Barker array of size exists, then .     

1/f Noise QWIPs and nBn detectors

The low-frequency noise is a ubiquitous phenomenon and the spectral power density of this fluctuation process is inversely proportional to the frequency of the signal. We have measured the 1/f noise of a 640 × 512 pixel quantum well infrared photodetector (QWIP) focal plane array (FPA) with 6.2 μm peak wavelength. Our experimental observations show that this QWIP FPA’s 1/f noise corner frequency is about 0.1 mHz. With this kind of low frequency stability, QWIPs could unveil a new class of infrared applications that have never been imagined before. Furthermore, we present the results from a similar 1/f noise measurement of bulk InAsSb absorber (lattice matched to GaSb substrate) nBn detector array with 4.0 μm cutoff wavelength.