CO2置换CH4水合物实验研究进展

全面总结了目前CO2置换CH4水合物中CH4实验研究进展。首先从水合物结构角度出发讨论置换的可能性及置换效率;而后分别从热力学和动力学角度探讨置换反应机理;最后设计并优化了实验系统。作者认为探明置换内在机理是未来置换法开采水合物能源技术发展的关键。     

1.65μm附近CH4分子高分辨率吸收光谱研究

采用连续可调谐二极管半导体激光器为探测光源,以可调怀特型长光程多通池(46.36～1158.90m)作为吸收池,采用直接吸收的方法,探测了室温下1.65μm附近CH4分子的高分辨率吸收光谱。在6043.00～6053.72cm-1范围内探测了5组不同压力和光程下的吸收光谱,观测到了259条线新的CH4分子吸收谱线,实验数据用Gaussian线型进行拟合,得到了这些吸收谱线的线强、线位置以及线强的标准偏差值,并对光谱中难以分辨的吸收谱线进行了分析。探测得到的最小谱线线强是4.3×10-27cm-1·(molcule·cm-2)-1,吸收谱线线强大于3.0×10-24cm-1·(mol·cm-2)-1由于吸收饱和而未被处理,同时所测得的光谱也显示出CH4分子在1.65μm附近有非常丰富的弱吸收谱线和复杂的结构。文中所报道的吸收谱线都是HITRAN2004数据库中所未报道的,而且也未见有其他文献报道过。     

FR4相对电容率测量实验设计

采用由微带线与射频信号源、频谱分析仪构成的简易实验装置,可准确测量出FR4介质板的相对电容率,降低了射频电路或微带天线设计实验的成本.     

酸性离子液体催化合成对硝基苯甲酸乙酯的研究

在酸性离子液体([(CH2)3SO3Hmin]HSO4)催化剂存在下, 以对硝基苯甲酸和乙醇为原料合成对硝基苯甲酸乙酯. 对影响产率的诸多因素进行了考察, 其最佳反应条件为: 酸醇摩尔比1:15, 酸与离子液体摩尔比1:1.5, 反应温度85℃, 反应时间2h, 产品收率可达85.10%. 离子液体重复使用5次后, 其催化活性基本不变.     

Diode-pumped Q-switched Nd:GdVO4/KTP green laser formed with a flat–flat resonator

A diode-pumped acousto-optically Q-switched intracavity frequency-doubled Nd:GdVO₄/KTP green laser formed with a flat–flat resonator was demonstrated. 3.05 W of average green output power at pulse repetition frequency (PRF) of 40 kHz was obtained with an optical conversion efficiency of 18.4%, the effective intracavity frequency-doubling efficiency was 57%. At the incident pump power of 15 W, the shortest laser pulse occurred at PRF of 25 kHz with FWHM width of 14 ns, yielding the highest peak power of 7.44 kW; while the largest pulse energy of 0.14 mJ was achieved at PRF of 15 kHz.     

LD-pumped passively Q-switched Nd:YVO4 infrared and green lasers

A laser diode directly end-pumped, passively Q-switched Nd:YVO₄/Cr:YAG laser is presented in this paper. With 600 mW incident pump laser, Q-switched 1064 nm laser with an average power of 138 mW, pulse width of 19.8 ns, repetition rate of 170.1 kHz and peak power of 40.96 W is obtained. When a KTP crystal was inserted into the cavity, Q-switched 532 nm laser with an average power of 56 mW, pulse width of 28.4 ns, repetition rate of 118.2 kHz and peak power of 16.7 W is obtained at last.     

透射光栅衍射效率研究

透射光栅广泛应用于 X光能谱测量 ,为获得定量的 X光能谱 ,首先在北京同步辐射源上对透射光栅的衍射效率在多个入射 X光能量点进行了实验标定 ,获得了透射光栅衍射效率的实验结果。为模拟透射光栅衍射效率实验标定结果 ,发展了一个新的透射光栅衍射效率计算模型 ,该模型不同于国外已发展的矩形栅线模型和梯形栅线截面模型 ,而是假设透射光栅栅线具有准梯形截面。模型计算结果与实验标定结果符合很好。     

Observations on the role of MgCl2 in the Weissler reaction

Aqueous solutions of Nal containing CCl₄ and MgCl₂ at various concentrations were irradiated under air with 1 MHz ultrasound and the yield of I₃⁻ was determined. The yield was not affected by MgCl₂ at concentrations up to 0.1 M. This contrasts with the finding of Lepoint and co-workers, who reported a sharp minimum in the yield at a MgCl₂ concentration of 2.5 × 10⁻³M, the yield decreased to 60% at 1 M MgCl₂, the reason being the lower solubility of CCl₄ at high MgCl₂ concentrations. In the absence of CCl₄, another dependence on the MgCl₂ concentration was observed: the yield was not affected up to 1 M, and at higher MgCl₂ concentrations the yield rapidly decreased owing to the increased viscosity of the solution. On the basis of these observations, there is no strong reason to postulate an electrical mechanism for the initiation of chemical reactions in the cavitation bubbles.     

Improving Cu2ZnSnS4 (CZTS) solar cell performance by an ultrathin ZnO intermediate layer between CZTS absorber and Mo back contact

The effects of an ultrathin ZnO intermediate layer deposited at the CZTS/Mo interface on CZTS solar cell performance have been investigated in this work. The ZnO layer inhibits the generation of MoS₂ layer and the formation of voids in the CZTS absorber. Consequently, the incorporation of this layer reduces the series resistance and increases the shunt resistance, which boosts photovoltaic conversion efficiency from 1.13% to 4.3%. (© 2014 WILEY‐VCH Verlag GmbH &Co. KGaA, Weinheim)     

Effect of boric acid on structure,morphology and luminescent properties of divalent europium doped calcium aluminate phosphors

Blue phosphors Ca_1 − xAl₂O₄: xEu²⁺ were prepared by high temperature solid-state method. Their structure, morphology and luminescent properties were investigated by X-ray diffraction (XRD), scanning electron microscope (SEM) and fluorescence spectroscopy. The effect of different amounts of fluxing agent H₃BO₃ on structure, morphology and luminescent properties of blue phosphors Ca_1 − xAl₂O₄: xEu²⁺ luminous intensity caused by different amount of H₃BO₃ was also investigated. The amount of H₃BO₃ doped Ca_1 − xAl₂O₄: xEu²⁺ in optimal luminous intensity had been determined. The results showed that both the excitation and emission spectra of samples were all broad bands, and that the peak of emission spectra was near 442 nm, which was corresponding to the 4f⁶5d → 4f⁷ transition of Eu²⁺ illuminating blue light. Ca_1 − xAl₂O₄: xEu²⁺ (x = 3.5 mol%) could be gained with good morphology and the best luminous intensity when H₃BO₃ mass ratio was 0.5 wt%.