铬酸引发丙烯腈与苎麻纤维接枝共聚反应

棉、麻类织物通过与乙烯类单体接枝共聚可以提高染色性、皱折回复性、耐磨性、防污性等［‘j．纤维素接枝共聚物的合成始于50年代，目前研究最多的是乙烯类单体通过自由基活性中间体与纤维素进行接技共聚，但此法存在一个突出的问题是在接技共聚的同时生成大量均聚物．铬酸（下文用Cr’“表示）是公认的强氧化剂，据报道［’－‘j，它单独存在时并不能引发乙烯类单体聚合，如果用Cr‘”引发乙烯类单体与纤维素接技共聚，均聚物的生成量将会减少．本文以Cr’”为引发剂，将丙烯睛（AN）与艺麻纤维进行接技共聚，考查不同条件对接技率及均聚…     

Isolation of lysozyme from hen egg albumen using glass fiber-based cation-exchange membranes

In this study, porous glass fiber membranes were coated with monophenyl trimethoxysilane (MPh) and then sulphonated by chlorosulphonic acid to prepare the cation-exchange membranes with sulphonic acid groups. Different MPh-coating times were tested and the properties of the resulting membranes such as contact angle, FTIR spectrum, conductivity, and ion-exchange capacity were measured. It was found that the optimal MPh-coating time was 60 min and the related ion-exchange capacity was 49.5 μequiv./disc. The modified membrane under the optimal MPh-coating condition was adopted for lysozyme isolation. The results were compared with those for the commercial cation-exchange membrane with sulphonic acid groups (ICE 450 unsupported membrane). Although the prepared membrane exhibited less adsorption capacity than ICE 450 unsupported membrane in the batch lysozyme adsorption experiment, it showed lower non-specific binding ratio under higher salt concentration. In the flow process isolating lysozyme from hen egg albumen, the purification effectiveness obtained using the prepared cation-exchange membrane was superior to the ICE 450 unsupported membrane.     

The effect of fiber coating on the tensile properties of ionomer-based composites

Asbestos fibers, of the chrysotile variety, were coated with a thin polyamide film by an in situ polycondensation technique. Ionomer-based composites were prepared containing the so-modified asbestos fibers in a random in-plane orientation; results of testing the tensile properties of these asbestos/polyamide/ionomer composites are presented. Parameters investigated comprise the asbestos content in the composite and the polyamide content deposited on asbestos. A significant improvement in the tensile performance was established, especially at the intermediate polyamide content of 3.4 phr. The behavior is discussed in terms of possible interactions between the phases present in the composite material.     

活性炭纤维电极电解法处理墨绿B染料废水

将铁丝缠绕在活性炭纤维(简称ACF)上制成电极,并在阴极鼓入空气,用电解生成的Fenton试剂处理墨绿B染料模拟废水.研究了电压、pH值、温度、空气流量、支持电解质的浓度等因素对染料脱色率的影响.结果表明,pH值越低,温度越高,处理效果越好,气流量的改变对于处理效果影响不大.室温时处理浓度为50mg·L-1的活性染料墨绿B,在实验电压为11V,中性条件下,无水硫酸钠的浓度为20g·L-1,通入空气流量为60L·min-1时,处理60min,色度去除率达到95%左右.55℃时,电解30min色度去除率就达到96%,60min时达到100%.     

ZrO2纳米粉末复合羊毛纤维研究

ＺｒＯ_２纳米粉末复合羊毛纤维研究陈代荣，樊悦朋（山东大学化学系济南２５０１００）关键词ＺｒＯ_２纳米粉末，羊毛纤维，复合纤维由陶瓷粉末和天然纤维形成的复合纤维的强度、织品的保暖性、抗起球性及防缩性能等均有所提高，报道较多的是微米级陶瓷粉末（粒径０．５...     

Characterization of etched electrochemical detection for electrophoresis in micron inner diameter capillaries

An enhanced etched electrochemical (EC) detection technique has been developed for CE in micron inner diameter capillaries. The design improvements allow for better alignment between the capillary bore and the electrode. This new method involves utilizing a carbon fiber microelectrode and etching both the carbon fiber and the detection end of a micrometer-sized inner diameter capillary to limit dead volume and analyte diffusion at the amperometric EC detector. To understand the factors affecting enhanced detector efficiency, a detailed examination of the relationship between detector design and performance has been completed by exploring the effects of varying electrode diameter, tip shape, and size, in addition to the etch length of the capillary outlet. The enhanced detection provides peak efficiencies as high as 75000 theoretical plates and estimated detection limits as low as 40 nM for dopamine. This etched detection method should further facilitate volume-limited sample analysis by CE.     

Electrospinning of nylon-6,66,1010 terpolymer

Ultrafine nylon fibers were prepared by electrospinning of nylon-6,66,1010 terpolymer solution in 2,2,2-trifluoroethanol (TFE). The morphology, crystallinity and mechanical properties of the electrospun nylon-6,66,1010 fibers were investigated by scanning electron microscope (SEM), differential scanning calorimetry (DSC), wide angle X-ray diffraction (WAXD) and tensile test. The effects of electrospun process parameters such as solution concentration, voltage and tip-to-collector distance on the morphology and the average size of the electrospun fibers were also studied. The results show that the spinnable concentration of nylon-6,66,1010/TFE solution is in the range of 6-14 wt%, and higher solution concentration favors the formation of uniform fibers without beads. The diameters of the electrospun fibers increase with increasing the solution concentration and decrease slightly with increasing the voltage and needle tip-to-collector distance. But no obvious morphology changes were found with the increase of the voltage and collection distance. DSC and WAXD results suggest that the electrospun nylon-6,66,1010 membranes have lower crystallinity than those of the corresponding casting films. The electrospun nylon-6,66,1010 membrane obtained from the 14 wt% concentration exhibits the largest tensile strength and elongation at break.     

碳纤维汞膜微电极1.5次微分伏安法测定米托蒽醌的研究

米托蒽醌（ＭＸＴ）能吸附在碳纤维汞膜微电极表面，阴极溶出时，产生一个灵敏的１．５次微分溶出峰，其峰电流和米托葱酿的浓度在１．０×１０－５ｍｏｌ／Ｌ～１．３×１０－９ｍｏｌ／Ｌ范围内具有良好的线性关系，经３ｍｉｎ的富集，检出限可达１．０×１０－１０ｍｏｌ／Ｌ，据此建立了测定ＭＸＴ的灵敏的新方法，本文讨论了实验条件，并对血样中的ＭＸＴ进行了测定。     

碳纤维微电极研究(Ⅺ)——利用温度效应测定电极反应的热力学和动力学参数

研究了温度对碳纤维微电极上伏安曲线的影响及温度与电极电位的关系,测定了电极反应的热力学参数.由电流与温度的关系测定了去极剂的扩散活化能E_(al)和D_o,利用微电极具有高速传质的特性,测定了常规电极上为可逆反应的电极反应标准速率常数(?),并通过(?)与温度的关系测定了电极反应的活化能.     

Nitrogen adsorption on fluorinated activated carbon fiber

Nitrogen adsorption isotherms for fluorinated activated carbon fiber (F-ACF) and fluorinated carbon black (F-CB) were measured at 77 K. Surface structures of F-ACF and F-CB were examined by _s -plot analysis using the adsorption data on the nonporous carbon black (CB) and F-CB. The surface energy of F-ACF was lower than that of ACF. The micropore structure of ACF was preserved even after fluorination, although the limiting adsorption amount and the micropore width decreased with fluorination.