Synthesis of Polyacrylaminothiourea Chelating Fiber and Properties of Concentration and Separation of Trace Noble Metal Ions from Samples

A novel polyacrylaminothiourea chelating fiber was synthesized simply and rapidly from nitrilon (an acrylonitrile-based synthetic fiber), which was applied to preconcentrate and separate of trace amount of Au(Ⅲ）,Pt(Ⅳ）,Pd(Ⅳ） and Ir (Ⅳ） ions from solution of samples.The analyzed ions can be quantitatively concentrated by the fiber up to a flow rate of 20.0mL/min at pH2, and can also be desorbed with 15 mL of 4mol/L HCl 3% thiourea from the fiber column with recoveries of 96.5%-100%.The chelating fiber can be reused for ten times,the recoveries of these ions are still over 92%,and hundred to thousand times of excess of Fe(Ⅲ）,Al（Ⅲ）,Ca(Ⅱ），Mg（Ⅱ）,Ni(Ⅱ）,Mn（Ⅱ),Cu(Ⅱ），Zn(Ⅱ），and Cd(Ⅱ） cause no interference on the determination of the analyzed ions by inductively-coupled plasma atomic emission spectrometry (ICP-AES).The static saturation adsorption capacities of the fiber for the analytes are in the range of 1.15-2.80mmol/g.The relative standard deviations for the determination of 20.0ng/mL each of Au(Ⅲ）,Pt(Ⅳ）,Pd(Ⅳ）and Ir(Ⅳ） are in the range of 0.7%-3.0%.The recoveries for test from standard additions to real solution samples are between 96% and 100%.The concentration of each ion in powder sample detected by the method is in good agreement with the certified value.     

共聚酯型热熔粘结纤维结晶结构及其熔融行为

采用DSC与WAXD相结合的方法研究了两个系列的无规嵌段共聚酯型热熔粘结纤维的结晶结构并探讨了系列样品的熔融行为.实验表明,以最低熔融温度为界,可将样品分为两组,每组只含一种可结晶单元的结晶.其结构与物理机械性质随该可结晶单元的加入量而有规律的变化.纤维的粘结性能则取决于非晶区结构,非晶区分子链柔性增加,会明显改善粘结效果.     

液芯光纤光度法在乙醇水溶液中测定铂(Ⅱ)、钛(Ⅳ)

采用氟塑料长光纤管，以４２％乙醇水溶液作液芯，组成液芯光纤，基于铂与氯化亚锡、钛与过氧化氢形成黄色络合物在乙醇水溶液中很稳定，拟定了测定铂、钛的液芯光纤光度法。该法灵敏度高，用 １ｍ长光纤作吸收池，铂的灵敏度为 ４． ８４５ Ａ／ｍｇ· Ｌ－１，钛的灵敏度为１．４１Ａ／ｍｇ· Ｌ－１（Ａ为吸光度），与常规法（１ｃｍ）比色皿相比灵敏度提高了 １００倍。该法测定了催化剂中铂，煤灰粉中钛，结果与推荐值相符。     

中空纤维催化膜反应器中环戊二烯的选择加氢反应

将聚乙烯吡咯烷酮（ＰＶＰ）负载钯催化剂（ＰＶＰ－Ｐｄ）镶嵌到三种醋酸纤维（ＣＡ）中空膜（ＣＡ－Ｉ，ＣＡ－Ⅱ，ＣＡ－Ⅲ）内制各中空纤维催化膜，并进一步制成催化膜反应器，在４０℃和０．１ＭＰａ的反应条件下，在催化膜反应器中进行了环戊二烯的选择加氢反应，考察了具有不同氢气渗透率的醋酸纤维丝组成的三种膜反应器对反应的转化率及选择性的影响，并在此基础上考察了各种反应参数对反应的影响，ＣＡ中空纤维催化膜对环戊     

再生碳纤维电极的新方法

本文根据火焰熔融法自制碳纤维电极的特点，提出了一种简便、易行的火焰灼烧再生电极的新方法。由此法再生电极的各种性能与原电极相当，结果令人满意。     

聚乙烯醇双胺肟螯合纤维的合成及其吸附性能

利用预辐接技法合成了聚乙烯醇双胺肟螯合纤维。研究了影响接枝率和胺肟基团含量的因素，讨论了吸附酸度、吸附时间对Ｃｕ（Ⅱ）离子吸附容量的影响。     

Photocatalytic Oxidation of Aniline in the Gas Phase Using Porous TiO2 Thin Films

The gas-phase photocatalytic oxidation of aniline on a new kind of porous nano-TiO₂ composite films is investigated. The composite film was prepared on glass fiber with the water glass as binders and dilute H₂SO₄ solution as solidifying reagent. The surface characters were observed by scanning electron microscope. The photocatalytic degradation of aniline on the composite films was carried out in a TiO₂/UV system. Some important factors affecting the photodegradation, such as the concentration of TiO₂, the initial concentration of aniline, and the existing water vapor, are also studied. The product of photocatalytic oxidation was detected by Fourier transform-Infrared. The partial intermediate products were absorbed on TiO₂ surface, which resulted in catalyst deactivation. But when it was irradiated under UV illumination or solar irradiation for some time, the catalyst could be reused without loss of catalytic activity. Translated from the Journal of Wuhan University (Natural Science Edition), 2005, 51(2) (in Chinese)     

聚四氟乙烯纤维辐照接枝制备弱酸性离子交换剂及其对Cu~(2+)的吸附

以聚四氟乙烯纤维为基体通过6 0 Co辐射引发与丙烯酸接枝制备弱酸性阳离子交换纤维 .产物功能基含量为 3 0 6mmol g,在pH =5时该纤维达到对Cu2 + 的最大动态吸附量为 10 7 4 8mg g.使用不同浓度HCl对饱和吸附铜的接枝纤维进行洗脱 ,证实该纤维对铜离子具有优异的解吸性能     

载银磷酸活化剑麻基活性炭纤维的抗菌性能研究

本文利用磷酸化方法，制备各种剑麻基活性炭纤维，并利用活性炭纤维的氧化还原特性及吸附性能，在其上负载金属银，研究并比较了这些载银活性炭纤维对大肠杆菌和金黄色葡萄球菌的杀灭作用，结果表明，磷酸浓度，活化方法，活化时间，纤维的比表面积等因素的均对材料的抗菌性能有一定的影响，磷酸活化的活性炭纤维表现出强的抗菌杀菌能力，高浓度磷酸活化后的纤维抗菌能力有所提高，并且抗菌能力随活化时间的延长而增加，抗菌前后纤维上负载的银未曾大量脱落，经5次抗菌试验后材料仍显示出很强的抗菌能力。     

Classification of cultivation area of ginseng by near infrared spectroscopy and ICP-AES

A rapid and nondestructive near infrared (NIR) method using soft independent modeling of class analogy (SIMCA) for the classification of cultivation area (Korea and China) was evaluated and confirmed. Raw, first, and second derivative NIR spectra were compared to develop a robust classification rule. The chemical properties of ginseng samples were also investigated to find out the differences between Korean samples and Chinese samples. These differences make NIR spectroscopic method viable. The average value of each Korean and Chinese ginseng sample for crude fiber, crude protein, starch, and 10 inorganic constituents were measured and compared with F-test and t-test. The inorganic constituents were also measured by induced coupled plasma-atomic emission spectroscopy (ICP-AES). It could be found that the amount of starch and ten inorganic elements for example Na, Mg, P, K, Ca, Mn, Fe, Ni, Cu and Zn in ginseng samples are considerably different based on cultivation area. SIMCA has been applied to the inorganic data to investigate the possibility of ICP-AES as classification tool. However, it was observed that the result was not equal to than NIR spectra data. The overall results showed the availability of NIR method using SIMCA would be adequate for classification of cultivation of ginseng, since NIR spectra includes useful and various information on chemical properties in spite of broad and overlapped bands.