SYNTHESIS, CHARACTERIZATION, METAL-UPTAKE BEHAVIOR OF BIS（BENZIMIDAZOLE） RESIN SUPPORTED ON EPOXIDE POLYMER

The new chelate resins, abbreviated as PNBMZs and PBBMZs based on epoxide polymer, were synthesized by polycondensation of N,N-diglycidyl-4-glycidyloxyaniline or 1,4-bis（2,3-epoxypropyl）benzene with the primary amine group of 1,3-bis（benzimidazol-2yl）propylamine （BBPAH）. The ion exchangers contain 2.71-3.23 mmol of the ligand contents per gram of the resin. Batch extraction capacities were determined for the metal chloride salts in buffer solutions in the pH range from -1 to 6.0. The chelate resins were very selective for Cu^2＋, Zn^2＋, Cd^2＋ in the presence of other divalent transition metal ions. The maximum uptake capacities of PNBMZ （synthetic molar ratio = 1：1.5） under non-competitive condition were found to be 0.94 mmol/g for Cu^2＋ at pH = 2, 1.3 mmol/g for Cd^2＋ at pH = 1 and 1.75 mmol/g for Zn^2＋ at pH = -1 respectively. While in the case of PBBMZ, it was 1.39 mmol/g for Cd〉 at pH = 1. The metal-uptake behaviors for both of them showed strong pH dependence, and their extraction capacities increase with decreasing pH. The uptake of Cu^2＋ by the resin PNBMZs at pH = 1 was found to be rather fast with t1/2 = 18 min. Metal-uptake experiments under competitive conditions also confirm that the chelate resins have a high selectivity for Cu^2＋, Zn^2＋, Cd^2＋ and the contrary pH dependence.     

1,3,4,6-四-O-乙酰基-β-D-氨基葡萄糖的合成

分别用对甲氧基苯甲醛和苯甲醛保护D-氨基葡萄糖的氨基，再将羟基用乙酰基保护，以氯化氢脱去氨基上的保护基团，最后脱去氯化氢得到1，3，4，6-四-0-乙酰基-β-D-氨基葡萄糖。两种方法的总产率分别为59％和61％。道关键中间体3b未见报，其结构经^1H NMR表征。     

Application of jäntti's method to volumetric adsorption measurements

Jäntti introduced a method to calculate the adsorption equilibrium by measuring the actual adsorbed amount three times after a change to the gas pressure. By this method the experimental time for adsorption measurement can be considerably shortened. The procedure was developed for use in adsorption measurements where the adsorbed masses are directly measured with a balance. In the present paper we will demonstrate that the method is particularly useful in volumetric (manometric) measurements.     

主动冷却点阵夹层防热结构温度响应计算模型北大核心CSCD

针对点阵夹层结构主动热防护问题,建立了夹层结构面板和芯体导热与冷却剂对流耦合的非稳态传热理论模型,利用有限体积法离散控制方程并在MATLAB中进行了迭代求解.模型首次考虑了面板与夹芯杆之间的收缩热阻,并利用分离变量法得到了收缩热阻的近似解析解.基于单胞模型和周期性边界条件,模拟得到了模型所需的表面对流传热系数h_(b)和h_(fin).最后,选取多单胞计算工况进行数值模拟和理论模型对比,并讨论了收缩热阻对模型预测精度的影响.结果表明:理论模型能够准确预测夹层结构及内部流体的温度变化,理论与仿真之间的最大误差不超过1%;随着外加热流密度不断增大,忽略收缩热阻使得计算结果造成的误差不断增大;与数值模拟相比,理论模型可显著地减少计算时间并节省计算资源,尤其适用于非均匀、非稳态复杂热载荷下点阵夹层结构的温度响应计算.     

A new inorganic-organic polymer for the passivation of thin film capacitors

Inorganic-organic polymers with barrier properties against water vapor, excellent electrical data (3, 2, R _D>10¹⁶ cm, E _D up to 400 V/µm) and good adhesion to various substrate materials have been developed. Tailored modifications of these materials provide an excellent protective coating for thin film capacitors. Several mm thick, expensive, encapsulations could be replaced by thin coatings (up to 10 µm). The polymer coating allows the use of thin film chip capacitors in surface-mount technology. As a measure for the efficiency of the coating, the capacitance decrease under controlled humidity has been used. The influence of the material composition, the type of catalyst during sol-gel processing and the curing conditions have been studied. Adhesion and water vapor permeation properties of the polymers and rheological properties of the coating solutions have been investigated. A protective coating is developed, which increases the withstandness of capacitors against humid conditions (90°C, 100% rel. humidity) by a factor of about 30 (compared to uncoated capacitors) and shows no crack formation during thermal cycling.     

High-temperature TG/DSC/QMS applications in environmental protection

The decomposition reactions of polystyrene, phenolic resin and a protective undercoating material for automobiles which contains PVC were tested using a new type of thermal analysis — mass spectrometry coupling system for measurements to 1500C or 2000C, which is based on the principle of a two-step skimmer orifice system. The results will be presented, with particular emphasis on the detection sensitivity of the new system for the products of decomposition.The capability of this coupling system to detect even heavy metals such as lead and silver in the waste gases from decomposition or after evaporation at high temperatures will also be demonstrated.     

Detection of soil pollution by hydrocarbons using headspace-mass spectrometry and identification of compounds by headspace-fast gas chromatography-mass spectrometry

The direct coupling of a headspace sampler with a mass spectrometer is proposed as a screening tool for the rapid detection of soil pollution by hydrocarbons from petroleum and derivatives. The samples are subjected to the headspace generation process, with no prior treatment, and the volatiles generated are introduced directly into the mass spectrometer, thereby obtaining a fingerprint of the sample analysed. Suitable treatment of the signal by chemometric techniques allows unequivocal characterisation of the different types of sample. The use of fast gas chromatography with a mass spectrometer detector coupled to the headspace sampler allows identification of the major hydrocarbons present in the mineral and organic polluted samples, interpretation of the results obtained, and demonstrates the analytical potential of headspace-mass spectrometry coupling.     

Alkylsulfamoyl Chlorides as Key Units in the Synthesis of Novel Biologically Active Compounds for Crop Protection

Due to their bifunctional character, alkylsulfamoyl chlorides are versatile units for the synthesis of heterocycles, polar sulfamates, and sulfonamides. In the last decade, synthetic methods of general preparative use have been developed, by means of which amine hydrochlorides, isocyanates, aziridines or tertiary alcohols can be reacted with suitable sulfuric acid derivatives to give novel, variously substituted alkylsulfamoyl chlorides. These compounds can subsequently be converted either to previously unobtainable N-alkoxyalkyl-N-alkylsulfamoyl chlorides or to novel heterocycles of the type 1H-2,1,3-benzothiadiazin-4-one-2,2-dioxide, 2H-1,2,6-thiadia-zin-3-one-1,1-dioxide and 2H-1,2,4,6-thiatriazin-5-one-1,1-dioxide; these compounds are examples of interesting models which illustrate the relation between the structure and the action of the compound, and in some cases lead to highly selective, ecologically unobjectionable herbicides. On the other hand, the alkylsulfamoyl chlorides themselves can be N-acylated to give further 3- to 5-atom bifunctional synthesis units, with which novel heterocyclic syntheses can be carried out. Further uses of the alkylsulfamoyl chlorides include the preparation of biologically active sulfamates, and cycloaddition reactions of N-sulfonylamines prepared in situ.     

Sol-gel ZrO2 coatings for chemical protection of stainless steel

ZrO₂ coatings deposited on 316 L stainless steel sheets were synthesized by sol-gel method using Zr(OC₃H₇)₄ as precursor and isopropanol, glacial acetic acid, and water as solvents for application with ultrasounds. Different solutions for dip-coating were prepared with compositions varying between 0.025 and 0.9 mol/dm³ of ZrO₂. X-ray diffraction shows that the films densified at 800°C are crystalline with a tetragonal structure. The thickness of the coatings varied from 0.35–0.75 m. The influence of the ZrO₂ coatings on the corrosion behavior of stainless steel substrates in aqueous NaCl was studied through potentiodynamic polarization curves at 1 mV/s. The values of the electrochemical parameters allow for an explanation of the role of the films in the increased resistance of steel against corrosion in moderately aggressive environments.