Rapid assessment of the impact of microwave heating coupled with UV-C radiation on the degradation of PAHs from contaminated soil using FTIR and multivariate analysis

The presence and fate of polyaromatic hydrocarbons (PAHs) in the environment are receiving a great concern. In this study, three oil-contaminated soils (industrial area, Dukhan city, and artificial soils) were utilized to examine the effect of microwave (MW) heating and UV-C irradiation on the PAHs degradation. A rapid assessment of the impact was evaluated using Fourier transform infrared (FTIR) and multivariate analysis. The total organic matter values for the maximum PAHs reduction were evaluated based on the FTIR spectra of the contaminated soils followed with the principal component analysis (PCA). The results showed that the highest total organic carbon reduction was achieved for the industrial soil sample that required a high MW power and long MW exposure time. On the other hand, the Dukhan city soil sample, which has the lowest total organic carbon, required a high MW power and short MW exposure time followed by UV-C treatment for 20 min to reach the maximal FTIR transmittance reduction. The cluster analysis was also used to evaluate the impact of MW heating, and MW heating followed by UV-C irradiation on the degradation of PAHs. The PCA results of the industrial city sample showed that neither MW treatment (100% MW, 15 min exposure time) followed by UV-C treatment for 20 min nor 10 min is significantly different from the MW treatment (100% MW, 15 min exposure time). However, for the Dukhan sample, the UV-C treatment at 10 min after high MW power and long exposure time (100% MW, 15 min exposure time) was the most efficient treatment.     

Estimation of diffusion and permeability coefficients of CO2 in polymeric membranes by FTIR method

Infrared spectra of CO₂ sorbed in rubbery and glassy polymeric membranes were measured to examine the relationships between the spectroscopic data and the physical properties of the membranes. The two peaks observed in the spectra of CO₂ were attributed to the R branch and P branch of CO₂ sorbed in the membranes based on the consideration that both peaks were observed at a temperature above the glass transition temperature of the membranes. Apparent diffusion coefficients of CO₂ in the membranes were measured from the desorption kinetics of CO₂ detected by FTIR spectroscopy. The solubility coefficients of CO₂ were also estimated from absorbance spectra of CO₂ sorbed in the membranes using Lambert-Beer's rule. The permeability, solubility, and diffusion coefficients estimated by the FTIR method were found to correlate well with the coefficients obtained by conventional methods such as vacuum-pressure or sorption isotherm methods. © 1996 John Wiley & Sons, Inc.     

原位漫反射红外光谱法研究SO2对Ag/Al2O3选择性催化丙烯还原NOx反应的影响

 以Ag/Al2O3为催化剂,采用原位漫反射傅里叶变换红外光谱法研究了SO2对C3H6选择性还原NOx反应的影响. 结果表明, SO2在催化剂表面转化为硫酸盐,并且随着硫酸盐累积量的增加,其主要红外特征吸收峰由低波数向高波数漂移. 高浓度表面硫酸盐的存在不仅抑制了催化剂表面硝酸盐的生成,而且抑制了硝酸盐与表面烯醇式物种(RCH=CH-O-)或乙酸盐物种进一步反应,生成活泼的反应中间体异氰酸酯(-NCO), 这是导致Ag/Al2O3催化剂上C3H6选择性还原NOx活性降低的主要原因.     

具有聚集诱导发光性质的近红外荧光染料

聚集诱导发光(AIE)现象的发现为解决传统有机荧光分子在高浓度和聚集形态下存在的荧光猝灭问题提供了最佳方案,并实现了在光电器件、化学传感、生物成像和靶向治疗等众多领域的广泛应用.随着对AIE 发光机理研究的不断深入,AIE 分子体系得到了极大的扩展.其中,一类具有给体-受体结构的AIE分子能够显著降低分子能隙,使发光分...     

概率神经网络和FTIR光谱用于食道癌的辅助分析

利用正常与相应癌化食道组织的主要FTIR特征峰aυs,CH3、sυ,CH2、σCH2、aυs,po4-、υc-o、sυ,po2-及sυ,磷酸化蛋白作为概率神经网络的输入向量,对网络的主要参数(网络径向基函数分布spread(0~5))、输入向量和网络表现(m ean accurate rate of recogn ition)之间的关系进行了研究。主要结论如下:i)无论输入向量是哪种特征频率的组合,其平均识别正确率都高于71.40%;ii)当输入向量为特征频率sυ,po2、sυ,磷酸化蛋白或υc-0、sυ,po2、sυ,磷酸化蛋白时,网络表现较佳,平均识别正确率较好。当spread介于1.4~2.3时,两者均达到网络具有的最高平均识别正确率(85.71%);iii)大多数情况下,网络的平均识别正确率与spread之间呈现二个高峰的特征,即spread介于0.1~0.3和1.5~5.0之间时,网络均具有较高的平均识别正确率。研究表明,以傅里叶变换红外光谱的主要特征峰为概率神经网络的输入向量,用于食道组织样品的癌化识别分析是完全可能的,其平均识别正确率可达85.71%。     

聚乙撑二氧噻吩阳极降解的研究

研究了聚乙撑二氧噻吩(PEDOT)膜在水溶液中的阳极降解过程. 研究发现PEDOT的阳极过程可以分为p掺杂区[电位范围－0.3～0.5 V (相对于饱和甘汞电极; vs. SCE)]、过渡区[电位范围0.6～1 V (vs. SCE)]、过氧化区[电位范围1.2～1.6 V (vs. SCE)]三个电位区域. 用电化学阻抗谱法、循环伏安法、红外光谱技术、膜电阻测量以及电子自旋共振技术分别研究了PEDOT膜在这三个电位区域的行为. 结果表明: PEDOT膜在这三个电位区域的性质有明显不同. 在p掺杂区PEDOT膜的官能团、共轭结构、导电性均保持, 即在这个电位区发生可逆的掺杂/脱掺杂反应, 膜几乎不降解. 在过渡区和过氧化区, PEDOT膜均发生了降解. 与传统的导电聚合物在高电位的阳极降解的过氧化过程不同, 我们认为膜在较高电位(过渡区)发生一个驰豫过程, 该过程使得膜的官能团改变, 但是膜的共轭结构和导电性均保持; 而在更高的电位区(过氧化区)膜的降解和一般意义的过氧化降解相同, 此时膜的官能团、共轭结构、导电性均发生不可逆的破坏.     

丙交酯合成过程的理论及实验研究

采用密度泛函方法研究了丙交酯的合成过程, 优化了合成过程中可能出现的化合物的几何构型, 分析了各化合物的振动频率和偶极矩. 在B3LYP/6-31G*和B3LYP/6-311＋G*水平上进行了各化合物的能量计算, 得到了所设计的各模型反应的焓变和吉布斯自由能变. 结果表明, 所选择的各模型反应为吸热反应且近似可逆, 水的控制对丙交酯的形成很重要. 根据量化计算结果与丙交酯合成实验中不同阶段反应体系红外谱图的变化, 提出了丙交酯合成的可能机理.     

近红外快速水份检测技术的应用

近红外检测技术是目前发展最快和最具有前景的分析技术之一,简要介绍了近红外检测技术的发展、优点和原理.利用该技术设计了豆类产品的水份检测仪器.并对近红外技术在水果、蔬菜、奶制品、制药和化工等方面的应用前景做了展望.     

偏最小二乘法结合傅里叶变换红外漫反射光谱快速测定煤质

发热量、挥发分和灰分等是衡量煤质的质量指标。通常,烟煤的发热量、挥发分和灰分是按行业标准方法[1]分别进行测定的,操作过程繁琐,速度慢,且费用高。随着化学计量学多元校正方法的发展与广泛应用,董庆年采用最小二乘法结合红外光谱成功测定了灰分[2];而应用偏最小二乘法[3](P     

空间目标红外辐射特性研究

利用目标的红外光谱特性进行目标探测和识别是一种有效的方法。以空间卫星为目标,研究了其红外辐射特性形成的机理;利用所建立的数学模型,仿真了空间目标在探测面上所形成的红外光谱特性曲线;分析了模型中各参数对目标光谱特性的影响程度和卫星目标的红外光谱曲线。