中物院远红外自由电子激光实验研究

中国工程物理研究院基于射频直线加速器技术的远红外自由电子激光(FIR-FEL)实验取得阶段性进展,于2005年3月24晚8时30分首次出光, 并多次重复. 中心波长115μm, 谱宽1%.介绍了实验系统的主要组成部分和主要实验结果.     

介质的非均匀性对高次谐波影响的研究

讨论了气体介质的非均匀性对飞秒激光高次谐波产生过程的可能影响.计算结果表明,采用喷阀技术所提供的气体介质的密度梯度和气体原子运动速度的影响很小,不会产生实验上可观测的效果.这一结果支持了喷气靶在高次谐波产生中的广泛应用 关键词： 高次谐波 气体介质 各向异性 飞秒激光     

Mode beating in spot-size converter lasers

An anomalous modulation in the wavelength spectrum has been observed in lasers with spot-size converters. This intensity modulation is shown to be caused by beating between the fundamental lasing mode and radiation modes in the taper. This results in a periodic modulation in the net gain spectrum, which causes wavelength jumps between adjacent net gain maxima, and a drive current dependent spectral width that is expected to affect system performance. The amplitude of this spectral modulation is reduced significantly by either using an angled rear-facet which reflects the beating radiation modes away from the laser axis, or by using a nonlinear, adiabatic taper.     

抽运激光在光靶中的局域及其对X射线激光特性的影响

新型X射线靶设计为:由SiO2和TiO2组成具有12个周期的一维光子晶体,在它的中间嵌入光靶材料层作为缺陷层,SiO2,TiO2和光靶层的光学厚度分别为λ4、λ4和λ2,λ为抽运激光波长.与普通平板光靶相比,当抽运光垂直照射到这种光靶时,靶层内部的光强将提高2个数量级,所以抽运激光的阈值强度将降低2个数量级,这有利于X射线激光的小型化.在同样的抽运激光照射下,X射线激光的强度将提高4个数量级,转换效率也将提高约4个数量级.由于平均电离度随抽运激光强度的提高而提高,所以采用这种光靶有利于使X射线激光向短波长推进. 关键词： X射线激光 光子晶体 光波局域     

天光一号预放大器中的放大自发辐射效应

 在三维放大自发辐射（ASE）的模拟计算中，计入了侧壁反射效应以及KrF自发辐射的谱线形状（高斯型、洛伦兹型及平顶型）的影响，并对空间网点的影响进行了考察。经过综合分析，给出了ASE对预放大器放大特性影响的上、下限范围。当计入平顶型频谱分布，壁反射系数为 0 .2时，与不计入ASE的情形对比，天光一号预放大器的提取效率下降为35%。     

The Properties of Light Pressure Force with High Order in Laser Fields

1　Ｉｎｔｒｏｄｕｃｔｉｏｎ　　Ｉｎｒｅｃｅｎｔｙｅａｒｓ,ｂｏｔｈｔｈｅｔｈｅｏｒｅｔｉｃａｌａｎｄｅｘｐｅｒｉｍｅｎｔａｌｉｎｖｅｓｔｉｇａｔｉｏｎｓｏｎｌａｓｅｒｃｏｏｌｉｎｇａｎｄｔｒａｐｐｉｎｇｈａｖｅｂｅｃｏｍｅｏｎｅｏｆｔｈｅｍａｊｏｒｆｉｅｌｄｓｉｎａｔｏｍｉｃ,ｍｏｌｅｃｕｌａｒａｎｄｏｐｔｉｃａｌ ｐｈｙｓｉｃｓ[1～ 8] .Ｔｈｅｄｅｖｅｌｏｐｍｅｎｔｏｆｌａｓｅｒｃｏｏｌｉｎｇａｎｄｔｒａｐｐｉｎｇｔｅｃｈｎｏｌｏｇｙｉｓｉｍｐｏｒｔａｎｔｆｏｒｔｈｅａｐｐｌｉｃａｔｉｏｎｓｓｕ…     

含色散介质的一维光子晶体微腔的透射谱

研究了含色散介质的一维光子晶体微腔的透射谱,对色散介质采用Lorentz振子模型,腔模的频率设置在光子晶体带隙中心。发现当吸收可以忽略时,色散效应将导致在腔模附近有很高的态密度,与此相应地在透射谱中出现一个较宽的透射带。当吸收存在时透射带中心的透射峰消失,但带尾的透射峰依然存在。     

Ion implantation induced by Cu ablation at high laser fluence

High energy laser plasma-produced Cu ions have been implanted in silicon substrates placed at different distances and angles with respect to the normal to the surface of the ablated target. The implanted samples have been produced using the iodine high power Prague Asterix Laser System (PALS) using 438 nm wavelength irradiating in vacuum a Cu target. The high laser pulse energy (up to 230 J) and the short pulse duration (400 ps) produced a non-equilibrium plasma expanding mainly along the normal to the Cu target surface. Time-of-flight (TOF) technique was employed, through an electrostatic ion energy analyzer (IEA) placed along the target normal, in order to measure the ion energy, the ion charge state, the energy distribution and the charge state distribution. Ions had a Boltzmann energy distributions with an energy increasing with the charge state. At a laser fluence of the order of 6 × 10⁶ J/cm², the maximum ion energy was about 600 keV and the maximum charge state was about 27+.In order to investigate the implantation processes, Cu depth profiles have been performed with Rutherford backscattering spectrometry (RBS) of 1.5 MeV helium ions, Auger electron spectroscopy (AES) with 3 keV electron beam and 1 keV Ar sputtering ions in combination with scanning electron microscopy (SEM). Surface analysis results indicate that Cu ions are implanted within the first surface layers and that the ion penetration ranges are in agreement with the ion energy measured with IEA analysis.     

Pulsed laser deposition of nanostructured Ag films

Ultra-thin (0.5-5 nm) films of Ag have been prepared by pulsed laser deposition in vacuum using a 26 ns KrF excimer laser at 1 J cm⁻². The deposition was controlled using a Langmuir ion probe and a quartz crystal thickness monitor. Transmission electron microscopy showed that the films are not continuous, but are structured on nanometer size scales. Optical absorption spectra showed the expected surface plasmon resonance feature, which shifted to longer wavelength and increased in strength as the equivalent film thickness was increased. It is shown that Maxwell Garnett effective medium theory can be used to calculate the main features of optical absorption spectra.     

激光准直仪的设计性物理实验

介绍了激光准直仪的结构、工作原理及其在设计性物理实验中的应用