The electrochemical preparation and microwave absorption properties of magnetic carbon fibers coated with Fe3O4 films

Electrodeposition was employed to fabricate magnetite (Fe₃O₄) coated carbon fibers (MCCFs). Temperature and fiber surface pretreatment had a significant influence on the composition and morphology of Fe₃O₄ films. Uniform and compact Fe₃O₄ films were fabricated at 75 °C on both nitric acid treated and untreated carbon fibers, while the films prepared at 60 °C were continuous and rough. Microwave measurements of MCCF/paraffin composites (50 wt.% of MCCFs, pretreated carbon fibers as deposition substrates) were carried out in the 2-18 GHz frequency range. MCCFs prepared at 60 °C obtained a much higher loss factor than that prepared at 75 °C. However, the calculation results of reflection loss were very abnormal that MCCFs prepared at 60 °C almost had no absorption property. While MCCFs prepared at 75 °C exhibited a good absorption property and obtained −10 dB and −20 dB refection loss in wide matching thickness ranges (1.0-6.0 mm and 1.7-6.0 mm range, respectively). A secondary attenuation peak could also be observed when the thickness of MCCF/paraffin composite exceeded 4.0 mm. The minimum reflection loss was lower.     

Efficient scheme for the preparation of symmetric Dicke states via cross-Kerr nonlinearity

A scheme is proposed for generating maximally entangled Dicke states among four modes. The scheme only uses Kerr medium and homodyne measurements on coherent light fields, which can be efficiently made in quantum optical laboratories. The scheme can be generalized to produce maximally entangled 2k-qubit states.     

Geometry effect on the magnetic ordering of geometrically frustrated rectangular and triangular magnets

We investigate the effect of geometry on the ground-state ordering of artificially frustrated magnetic rectangular and triangular lattices by Monte Carlo method. By varying the vertical lattice spacing while keeping the horizontal one fixed, we show that when the ratio of vertical to horizontal lattice spacing, labeled by η, is less than 1.82, the ground state of the rectangular lattice presents long-range antiferromagnetic order and for η?1.82 the ground state changes to long-range mixed ferromagnetic and antiferromagnetic order. For the frustrated triangular lattice, the short-range ordered state as well as two long-range ordered ground states occurs transiently at η=0.87 and 2, where the energies of the two ground states with long-range order are approximately equal. In addition, the level of frustration of both frustrated lattices is found to be largely relevant to the ratio η.     

Preparation and tomographic reconstruction of an arbitrary single-photon path qubit

We report methods for preparation and tomographic reconstruction of an arbitrary single-photon path qubit. The arbitrary single-photon path qubit is prepared losslessly by passing the heralded single-photon state from spontaneous parametric down-conversion through variable beam splitter. Quantum state tomography of the single-photon path qubit is implemented by introducing path-projection measurements based on the first-order single-photon quantum interference. Using the state preparation and path-projection measurements methods for the single-photon path qubit, we demonstrate preparation and complete tomographic reconstruction of the single-photon path qubit with arbitrary purity.     

Optimized t-expansion method for the Rabi Hamiltonian

A polemic arose recently about the applicability of the t-expansion method to the calculation of the ground state energy E₀ of the Rabi model. For specific choices of the trial function and very large number of involved connected moments, the t-expansion results are rather poor and exhibit considerable oscillations. In this Letter, we formulate the t-expansion method for trial functions containing two free parameters which capture two exactly solvable limits of the Rabi Hamiltonian. At each order of the t-series, E₀ is assumed to be stationary with respect to the free parameters. A high accuracy of E₀ estimates is achieved for small numbers (5 or 6) of involved connected moments, the relative error being smaller than ¹⁰−4 (0.01%) within the whole parameter space of the Rabi Hamiltonian. A special symmetrization of the trial function enables us to calculate also the first excited energy E₁, with the relative error smaller than ¹⁰−2 (1%).     

Remote preparation of a two-particle state using a four-qubit cluster state

We present a scheme of remote preparation of two-particle states using a particular four-qubit cluster state as the quantum channel. The probability of success regarding this preparation scheme is calculated in both general and some particular cases. Our results show that in general such remote state preparation can be realized with a probability of 1/4. But in several special cases, the probability of success can be improved to 1/2 or even 1.     

Colorless gigabit WDM-PON link using injection locking and electro-absorption transceiver

In this paper, a novel colorless wavelength division multiplexing-passive optical network (WDM-PON) system using injection locking and electro-absorption transceiver (EAT) is proposed and demonstrated experimentally. This system has advantages, high data transmission, small downlink signal effect to uplink signal and less polarization sensitivity, compared to the system using reflective semiconductor optical amplifier (RSOA). Downlink signal modulates the right side carrier of the double side band signal by using injection locking. EAT functions as both photo detector in downlink signal and modulator for uplink signal, simultaneously. A possible cross absorption modulation effect from the EAT is analyzed experimentally. Bidirectional transmission of 1.25 Gbps and 622 Mbps for downlink and uplink, respectively, were verified through 23 km standard single mode fiber (SSMF).     

Intercept-resend attacks on Chen et al.'s quantum private comparison protocol and the improvements

Recently, Chen et al. presented a novel quantum private comparison (QPC) protocol using triplet GHZ state to enable two parties to compare the equality of their information without revealing the content. The protocol is rather promising because it only requires single-photon measurement with the help of a semi-honest third party to complete the secret comparison. However, this study will point out that a weakness could occur in the eavesdropping check phase. That is, an intercept-resend attack could be launched by one of the two participants to reveal the information content of the other participant—a result that contradicts to the security requirement of a QPC. Fortunately, two solutions are possible to avoid the attack.     

Microwave absorption properties of rod-shaped Co-Ni-P shells prepared by metallizing Bacillus

The rod-shaped Co-Ni-P shells were prepared by metalling Bacillus. The microstructures and composition of the shells were characterized by scanning electron microscopy (SEM), transmission electron microscopy (TEM) and energy dispersive analysis (EDS). The electromagnetic parameters were measured by the coaxial line method in the frequency of 2-18 GHz. It was found that the Bacillus were successfully coated with Co-Ni-P, and the inner structure of the shells are hollow in structure. The shells exhibit excellent microwave absorption properties in 5-17 GHz frequency. The microwave reflection loss is above −10 dB in 5.38-16.6 GHz frequency. The maximum microwave reflection loss reaches −35.83 dB at 9.12 GHz for samples thickness 2.4 mm, and the widest bandwidth for microwave reflection loss above −10 dB is about ∼5.32 GHz for samples thickness 2.0 mm. These results confirm the feasibility of applying Bacillus as biotemplates for fabrication of the metallic shells as lightweight microwave absorption materials are very promising for applications.     

The materials science X‐ray beamline BL8 at the DELTA storage ring

The hard X‐ray beamline BL8 at the superconducting asymmetric wiggler at the 1.5 GeV Dortmund Electron Accelerator DELTA is described. This beamline is dedicated to X‐ray studies in the spectral range from ～1 keV to ～25 keV photon energy. The monochromator as well as the other optical components of the beamline are optimized accordingly. The endstation comprises a six‐axis diffractometer that is capable of carrying heavy loads related to non‐ambient sample environments such as, for example, ultrahigh‐vacuum systems, high‐pressure cells or liquid‐helium cryostats. X‐ray absorption spectra from several reference compounds illustrate the performance. Besides transmission measurements, fluorescence detection for dilute sample systems as well as surface‐sensitive reflection‐mode experiments have been performed. The results show that high‐quality EXAFS data can be obtained in the quick‐scanning EXAFS mode within a few seconds of acquisition time, enabling time‐resolved in situ experiments using standard beamline equipment that is permanently available. The performance of the new beamline, especially in terms of the photon flux and energy resolution, is competitive with other insertion‐device beamlines worldwide, and several sophisticated experiments including surface‐sensitive EXAFS experiments are feasible.