考虑液面凹陷时金属熔化与蒸发的数值研究

将关于液面凹陷的Young-Laplace方程与关于金属溶池的流体力学方程组及关于金属蒸发的ＢＧＫ方程联立求解，在给定的电子枪加热条件下，获得了熔池流场和温度场图像及金属蒸气密度、速度和温度分布.数值计算结果表明，随电子枪功率增加，金属的蒸发速率增加，蒸气的密度增大、温度降低而速度升高.与假设液面为平面的情况相比，考虑液面凹陷后求得的液面温度较低，金属的蒸发速率较小，并且这种差别随电子枪功率的增加而扩大.因此对于高功率电子枪加热金属蒸发，必须考虑液面凹陷的影响才能得到符合实际的结果. 关键词： 液面凹陷 Young-Laplace方程 熔池 金属蒸发     

一种基于灰度变换的红外图像增强算法

针对红外图像，采用双门限分割法进行图像分割，然后采用分段灰度变换法进行图像增强。根据具体图像，通过人机交互的方式确定2个阈值，将图像分割为目标区、过渡区和背景区3部分；按照每一部分的特点，设计不同的灰度变换，对图像进行分段线性增强，得到感兴趣目标区的最佳视觉效果。通过对16位红外图像进行实验，得到了满意的结果。实验表明,该算法灵活便捷，在增加对比度和去除噪声的同时，还抑制了背景，达到了预期的效果。     

Morphology-controlled electrochemical sensing amaranth at nanomolar levels using alumina

Different-shaped aluminas were readily prepared via hydrothermal reaction. It was found that the morphology and the electrochemical sensing properties of alumina were heavily dependent on the reaction time. When extending the reaction time from 6 h to 24 h, the obtained alumina samples changed from amorphous bumps to regular microfibers in diameter of 200 nm, as confirmed by scanning electron microscopy. Transmission electron microscopy observation revealed that longer reaction time was beneficial for the formation of porous and uniform fiber-like structures. Electrochemical tests proved that alumina microfibers were more active for the oxidation of amaranth and exhibited much higher enhancement effect, compared with alumina bumps. On the surface of alumina microfibers, the oxidation peak currents of amaranth increased remarkably. The influences of pH value, amount of alumina microfibers, and accumulation time on the signal enhancement of amaranth were discussed. As a result, a novel electrochemical method was developed for the detection of amaranth. The linear range was from 1 to 150 nM, and the detection limit was 0.75 nM after 1-min accumulation. The analytical application in drink samples was investigated, and the results consisted with the values that obtained by high-performance liquid chromatography.     

Evaporation from Three Single‐Compound Phases in Equilibrium

The evaporation paths in a system of three single‐compound phases in equilibrium were calculated using a phase diagram approach assuming the evaporation rate proportional to the compound's vapor pressure and molecular weight. The variation with time of the weight of the individual phases was linear, while the weight fraction was not. The approach allowed a simple calculation of the fraction of remaining compounds after one of them was exhausted during the evaporation and a convenient graphical illustration of the importance of the relative vapor pressures.     

Influence of branched chains on the mesomorphic properties of symmetrical and unsymmetrical triphenylene discotic liquid crystals

A series of novel symmetrical and unsymmetrical triphenylene‐based discotic liquid crystalline materials with one or six branched peripheral alkoxy chains have been prepared. These materials have been compared with analogous known symmetrical and unsymmetrical compounds to reveal a balance between steric and space‐filling effects of the peripheral branched chains, which significantly affects intermolecular forces of attraction and packing, and hence affects melting and isotropisation temperatures of the liquid crystalline materials. The desired result of reduction of melting points and enhancement of isotropisation temperatures has been accomplished by use of branched alkoxy chains in both symmetrical and unsymmetrical materials.     

A Triazatruxene‐Based Glycocluster as a Fluorescent Sensor for Concanavalin A

A new triazatruxene‐based fluorescent glycocluster has been designed, synthesized, and fully characterized by NMR spectroscopy and mass spectrometry. Furthermore, its specific and selective binding properties with concanavalin A (Con A) have been investigated by fluorescence spectroscopy, circular dichroism (CD) spectroscopy, and turbidity assay. The obtained results showed that the multivalent mannose‐modified triazatruxene exhibited specific binding with Con A, but no binding to peanut agglutinin (PNA) lectin or bovine serum albumin (BSA), corresponding to a two‐orders‐of‐magnitude higher affinity than that of monovalent mannose ligands. Most interestingly, a fluorescence enhancement of the triazatruxene‐based glycocluster was observed upon binding with Con A because of hydrophobic interactions involving sites close to the triazatruxene moiety. Furthermore, the inhibitory ability of the triazatruxene‐based glycocluster against ORN178‐ induced haemagglutination has been investigated by haemagglutination inhibition assay. The results indicated selective binding with ORN178.     

Longitudinal Relaxation Enhancement in 1H NMR Spectroscopy of Tissue Metabolites via Spectrally Selective Excitation

Nuclear magnetic resonance spectroscopy is governed by longitudinal (T₁) relaxation. For protein and nucleic acid experiments in solutions, it is well established that apparent T₁ values can be enhanced by selective excitation of targeted resonances. The present study explores such longitudinal relaxation enhancement (LRE) effects for molecules residing in biological tissues. The longitudinal relaxation recovery of tissue resonances positioned both down‐ and upfield of the water peak were measured by spectrally selective excitation/refocusing pulses, and compared with conventional water‐suppressed, broadband‐excited counterparts at 9.4 T. Marked LRE effects with up to threefold reductions in apparent T₁ values were observed as expected for resonances in the 6–9 ppm region; remarkably, statistically significant LRE effects were also found for several non‐exchanging metabolite resonances in the 1–4 ppm region, encompassing 30–50 % decreases in apparent T₁ values. These LRE effects suggest a novel means of increasing the sensitivity of tissue‐oriented experiments, and open new vistas to investigate the nature of interactions among metabolites, water and macromolecules at a molecular level.     

Investigating the effects of side chain length on the AIE properties of water-soluble TPE derivatives

The emissive properties of fluorophores in aggregated state are important for the development of bio-sensors or bio-imaging reagents. So three water-soluble TPE derivatives with different lengths of side chains have been synthesized and we investigated the effects of side chains on aggregation-induced emission (AIE) properties in the aggregated states. The results indicate that side chains on the fluorophores play a pivotal role in their emission in aggregated state mediated by heparin or solid state, because the coplanarity of these TPE derivatives was affected by side chains. The rates of radiative decay k_f and non-radiative decay k_nr have been obtained through the quantum yields and lifetime, and a larger k_f and smaller k_nr were present for compound TPE-C4N, suggesting that the aggregated TPE-C4N should posses the most remarkable fluorescent property.     

A detailed insight into the optimization of plate and frame heat exchanger design by comparing old and new generation metaheuristics algorithms

The voluminous utilization and application of plate and frame heat exchangers (PFHE) in many industries has accelerated the consumer and designer both to optimize exchanger total cost. Over the last few years, several old and new generation algorithms were employed and exploited to optimize PFHE cost. This study explores the application and performance of three new-generation algorithms Big Bang-Big Crunch (BBBC), Grey Wolf Optimizer (GWO), and Water Evaporation Optimization (WEO) in designing optimally PFHE. Besides, this study also compares the performance of three well-established old generations algorithms namely genetic algorithm (genetics and natural selection), particle swarm optimization (animals behaviour), and differential evolution (population-based) with the above three new algorithms in the optimization of PFHE.Seven design factors are chosen for PFHE optimization: exchanger length on hot and cold sides, height and thickness of fin, length of the fin-strip, fin frequency, and the number of hot side layers. The applicability of the suggested algorithms is assessed using a case study based on published research. Though DE performs the best in this study of design optimization concerning total cost and computational time, the three new-generation meta-heuristic algorithms BBBC, GWO, and WEO also provide the novel scope of application in heat exchanger design optimization and successfully finding the cost of the heat exchanger. According to this study, capital costs increase by 19.5% for BBBC, 24% for GWO, and 7.6% for GWO, but operational costs fall by 9.5% for BBBC and GWO when compared to the best performing algorithm (DE). On the other hand, WEO shows an increase of 32.6% in operational costs. Aside from that, a full analysis of the computing time for each algorithm is also provided. The DE has the quickest run time of 0.09 ?s, while the PSO takes the longest at 33.97 ?s. The rest of the algorithms have nearly identical values. As a result, a good comparison is established in this study, offering an excellent platform for designers and customers to make selections. Additionally, the three new generations algorithms mentioned here were not used earlier for optimization of PFHE and the comparative study illustrates that each of them possesses eat potential for cost optimization and also solving other complex problems.     

A two-point calibration method for quantifying organic binary mixtures using secondary ion mass spectrometry in the presence of matrix effects

Quantification of the composition of binary mixtures in secondary ion mass spectrometry (SIMS) is required in the analyses of technological materials from organic electronics to drug delivery systems. In some instances, it is found that there is a linear dependence between the composition, expressed as a ratio of component volumes, and the secondary ion intensities, expressed as a ratio of intensities of ions from each component. However, this ideal relationship fails in the presence of matrix effects and linearity is observed only over small compositional ranges, particularly in the dilute limits. In this paper, we assess an empirical method, which introduces a power law dependence between the intensity ratio and the volume fraction ratio. A previously published physical model of the organic matrix effect is employed to test the limits of the method and a mixed system of 3,3′-bis(9-carbazolyl) biphenyl and tris(2-phenylpyridinato)iridium (III) is used to demonstrate the method. This paper introduces a two-point calibration, which determines both the exponent in the power law and the sensitivity factor for the conversion of ion intensity ratio into volume fraction ratio. We demonstrate that this provides significantly improved accuracy, compared with a one-point calibration, over a wide compositional range in SIMS quantification and with a weak dependence on matrix effects. Because the method enables the use of clearly identifiable secondary ions for quantitative purposes and mitigates commonly observed matrix effects in organic materials, the two-point calibration method could be of significant benefit to SIMS analysts.