双光束相干控制产生多次谐波的实验验证

利用两束相干度可改变的飞秒脉冲光对产生的五次谐波的强度特性进行了研究，发现谐波信号的强度随相干程度的增大而增加，谐波信号的最大值相对于相干零点(双光束相干度最大处)是非对称的，从而证明了合成的激光脉冲波形变化对谐波信号的影响.同时对谐波的受激放大理论进行了初步的实验探索和展望. 关键词： 五次谐波 波形变化 相干 受激放大     

光强一定时饱和光电流随入射光频率的变化关系辨析

对光电效应实验中饱和光电流随入射光频率变化关系的几种谬误进行了辨析，给出了光强一定时饱和光电流随入射光频率变化的正确规律并作了解释。     

双驱动x射线激光等离子体能谱特性研究

用时间积分空间分辨的平晶千电子伏谱仪测量了钽激光等离子体发射波长范围为045— 075nm的软x射线能谱，精确测量和准确辨认出类镍、类钴和类铁离子的共振线及类镍离子 的内壳层跃迁线-对实验结果处理，获得了辐射线谱的强度-通过谱线比率的诊断推断脉冲激 光时差对等离子体状态的影响，至少也可部分解释激光上能级的粒子数及等离子体的 电离程度- 关键词： 离子谱特性 软x线能谱强度 谱线辨认     

Luminescence enhancement by hydrogenation of Si:Er,O

Erbium (Er)- and oxygen (O)-doped Cz–Si was additionally doped with hydrogen, using plasma enhanced chemical vapour deposition. Photoluminescence (PL) spectra show a large enhancement especially for samples treated with solid phase epitaxy before hydrogenation and annealing at 900°C later. Secondary ion mass spectroscopy measurements give evidence for an enhanced diffusion of O and Er at this temperature towards the surface. Etching shows that the PL does not stem from the heavily doped surface layer but from a deeper region with lower Er concentration. This conclusion is supported by the appearance of the so-called “cubic” centre with low solubility. Comparing the PL yield of the hydrogenated samples to that of samples with similar Er volume concentration but without hydrogenation still gives a large enhancement. We thus conclude that hydrogen can enhance the solubility of the cubic centre in Si:Er,O.     

FTIR measurements of CO2 line positions and intensities at high temperature in the 3700-3750 cm spectral region

Positions and intensities for 453 spectral lines in 12 rovibrational bands of ¹²C¹⁶O₂ have been determined between 3700 and 3750 cm⁻¹. At three temperatures (294, 500, and 698 K) eight spectra have been recorded at a pressure around 5 mbar and for an absorption path of about 190 cm⁻¹ using a Bomen DA3 Fourier transform spectrometer (4 × 10⁻³ cm⁻¹ resolution). Some of the measured positions and intensities can be compared with recent experimental results that validate the experimental set-up and the data analysis procedure. The results are also compared with the values listed in the HITRAN 2000 database. If the agreement is generally good, discrepancies are observed for three hot bands.     

Decay distribution of spontaneous emission from atoms in one-dimensional photonic crystal

Spontaneous emission behavior from atoms (or molecules) in one-dimensional photonic crystal with a defect is investigated. Taken all the TE and TM modes into account, the normalized spontaneous emission rate of the atom is calculated as a function of the position of the atom in the crystal. Results for both nonabsorbing dielectric structure and absorbing dielectric structure are presented. With the increase of the thickness of the defect in which the atoms are embedded, the oscillations of the spontaneous emission rate versus the position of the atom become dense and the lifetime distribution becomes narrow and sharp. The PC effect may lead to the coexistence of both accelerated and inhibited decay processes.     

原子的吸收光谱和发射光谱的演示

介绍了利用光学多道分析仪和投影仪在课堂上实时演示原子的吸收光谱和发射光谱的实验方法。     

Dislocation unpinning model of acoustic emission from alkali halide crystals

The present paper reports the dislocation unpinning model of acoustic emission (AE) from alkali halide crystals. Equations are derived for the strain dependence of the transient AE pulse rate, peak value of the AE pulse rate and the total number of AE pulse emitted. It is found that the AE pulse rate should be maximum for a particular strain of the crystals. The peak value of the AE pulse rate should depend on the volume and strain rate of the crystals, and also on the pinning time of dislocations. Since the pinning time of dislocations decreases with increasing strain rate, the AE pulse rate should be weakly dependent on the strain rate of the crystals. The total number of AE should increase linearly with deformation and then it should attain a saturation value for the large deformation. By measuring the strain dependence of the AE pulse rate at a fixed strain rate, the time constantτ _s for surface annihilation of dislocations and the pinning timeτ _p of the dislocations can be determined. A good agreement is found between the theoretical and experimental results related to the AE from alkali halide crystals.     

Simulation of Vacuum Microelectronic Triode Made of Single Carbon Nanotube

Vacuum microelectronic triode performance, based upon a unit cell with a nanotube field emitter, gate, and anode, was evaluated via computer simulation. Electron emission was calculated from the modified Fowler-Nordheim equation. The dependence of emitted current, upon geometrical factors, e.g., nanotube radius, nanotube height, and gate's hole radius, is shown. The device design parameters of trans-conductance, and cutoff frequency have been calculated, which show that this structure can be used as a microwave and millimeter wave amplifier. Electron current flux is shown for time-dependent 1–Thz sinusoidal variation frequency input.     

Evaluation of the Lazarus-Leblond constants in the asymptotic model of the interfacial wavy crack

The paper addresses the problem of a semi-infinite plane crack along the interface between two isotropic half-spaces. Two methods of solution have been considered in the past: Lazarus and Leblond [1998a. Three-dimensional crack-face weight functions for the semi-infinite interface crack-I: variation of the stress intensity factors due to some small perturbation of the crack front. J. Mech. Phys. Solids 46, 489-511, 1998b. Three-dimensional crack-face weight functions for the semi-infinite interface crack-II: integrodifferential equations on the weight functions and resolution J. Mech. Phys. Solids 46, 513-536] applied the “special” method by Bueckner [1987. Weight functions and fundamental fields for the penny-shaped and the half-plane crack in three space. Int. J. Solids Struct. 23, 57-93] and found the expression of the variation of the stress intensity factors for a wavy crack without solving the complete elasticity problem; their solution is expressed in terms of the physical variables, and it involves five constants whose analytical representation was unknown; on the other hand, the “general” solution to the problem has been recently addressed by Bercial-Velez et al. [2005. High-order asymptotics and perturbation problems for 3D interfacial cracks. J. Mech. Phys. Solids 53, 1128-1162], using a Wiener-Hopf analysis and singular asymptotics near the crack front.The main goal of the present paper is to complete the solution to the problem by providing the connection between the two methods. This is done by constructing an integral representation for Lazarus-Leblond's weight functions and by deriving the closed form representations of Lazarus-Leblond's constants.