相对论二极管电子枪设计的分析解与实验的比较

本文对轴对称场二极管区电子运动所遵循的近似轨迹方程进行数值求解,以此做为设计相对论二极管电子枪的依据,与实验结果相比较,符合较好。     

Photo-induced evolution of copper sheets from cluster molecules and its application to photolithographic copper patterning

UV photoexcitation of (t-butylethynyl copper)₂₄ cluster films induces segregation of the crystals into metallic and organic phases and leads to evolve the metallic sheets sandwiched by organic polymers. The growth of the metallic crystals in the plane of the photo-electromagnetic field is attributed due to plasmon-plasmon interaction among nanoparticles embedded in dielectric polymer matrices. The surface enhanced photochemical reaction of residual cluster molecules on the photon incident direction is expected to take an important role for joining the metal particles to produce a metallic sheet. We can apply this phenomenon for photolithographic copper pattern generation on a flexible base plate.     

自由电子激光振荡器的二维数值模拟

在柱二维坐标系中,用数值计算方法求解了摇摆器内电子模拟方程组、光场方程组和无源区(不含摇摆器区)经非自适应方法变换后的无源旁轴波动方程并设计了相应的程序R_2D。用该程序计算的数值结果表明,在有源条件下二维数值模拟结果与高斯光束近似下的数值模拟结果符合较好;取完全相同的计算条件R-2D程序与洛斯阿拉莫斯实验室(LANL)的FELEX程序的计算结果符合较好;初步认为LANL实验数据的物理图象合理,数值结果基本可信;最后给出北京自由电子激光器(BFEL)的一些物理数据。     

To the problem of energy recuperation in gyrotrons

A relatively high level of the minimal electron energy at the gyrotron output even at very large spread in pitch factor is explained. An estimation of the recuperation efficiency, which can be obtained due to this effect, is given.     

AFM, SEM and GIXRD studies of thin films of red polycarbazolyldiacetylenes

In this paper we report the results of a morphological and structural investigation on film properties of a soluble polydiacetylene, the poly[1,6-bis(3,6-dihexadecyl-N-carbazolyl)-2,4-hexadiyne] (polyDCHD-HS). The red films of this polymer, prepared by standard spin-coating techniques, revealed absence of linear dichroism and birefringence in contrast with the ordered mesophases detected by powder X-ray studies. In order to interpret the optical behavior of this polymer, we performed AFM and SEM studies of polyDCHD-HS films spun on hydrophylic and hydrophobic glass substrates. We found the presence of surfaces organized in rod-like particles, more regularly oriented on the hydrophylic substrate. GIXRD studies, carried out on films sufficiently thick to allow the observation of the diffraction pattern, reveled the presence of a lamellar structure with a spacing of 3.22 nm. The low intensity of the diffraction peaks and the isotropic linear optical properties of the films show that the lamellar mesophases are not extended over large areas. These findings were compared with the data obtained from AFM and SEM studies on films of two other polydiacetylenes, the poly[1-(3,6-dihexadexyl-N-carbazolyl)-6-(N-carbazolyl)-2,4-hexadyine] (polya-DCHD) and the poly[1,6-bis(3,6-dipalmitoyl-N-carbazolyl)-2,4-hexadyine] (polyDPCHD), spun on hydrophylic glass substrate. The results confirmed the presence of nodular morphologies which seem to be a general characteristic of this class of materials. The particles organization appears instead related to the chemical nature of the substituents on the carbazolyl rings.     

BEPCII直线注入器的尾场效应

BEPCII直线注入器中的强流、短束团的尾场效应将损害束流的性能.用分析解和数值模拟计算的方法,系统地研究了尾场对纵向和径向束流动力学的影响,包括单束团的短程尾场和多束团的长程尾场对束流能量、能散、发射度、轨道和初级电子束在正电子产生靶上束斑尺寸的影响等.研究了有效抑制这些尾场效应的措施     

The lay-out of the photon collider at the international linear collider

One of the interaction regions at the linear colliders should be compatible both with e ⁺ e ⁻ and γγ, γe modes of operation. In this paper, the differences in requirements and possible design solutions are discussed.      

用紧耦合方法研究C4+和O6+与He原子碰撞

用双中心原子轨道紧耦合方法计算了C4+-He以及O6+-He碰撞的单俘获总截面,入射离子的能量范围为10～100keV/amu,所得计算结果在实验误差范围内与实验值很好符合.对满壳层入射离子,研究了单俘获截面随入射离子电荷态的变化,并讨论了原子轨道展开波函数数目对计算结果的影响.p     

On the Use of the Restitution Condition in Flexible Body Dynamics

The difference between the classical treatment offlexible body impact and the treatment of impact in flexiblemultibody dynamics is due to several fundamental reasons. Inthe classical impact theory, simple structures such as beamsand plates are used. Infinite dimensional models can bedeveloped for these simple structural elements to study theimpact dynamics and the wave propagation problem. Flexiblemultibody impact problems, on the other hand, involve bodieswith complex geometry that cannot be modeled using infinitenumber of degrees of freedom. Furthermore, the classicalimpact theory has been mainly concerned with the impactbetween a rigid mass that moves without constraints beforeit impacts a simple flexible structure. This is not amultibody simulation scenario in which the impact occursbetween kinematically constrained bodies that are subjectedto impulsive constraint forces in addition to the impactforces. These constraint forces can influence the motion ofthe two bodies immediately after impact, and as aconsequence, the simple classical theory scenario of impactdoes not apply. It is the objective of this paper to discussthe use of the restitution condition in flexible multibodyimpact problems and demonstrate that the use of thisapproach does not exclude the classical formulation.Nonetheless, the impulse momentum balance approach can serveas an effective and efficient procedure for solving theimpact problem in finite dimensional models that do not obeythe classical wave theory. Energy results of simplestructural elements are presented in order to demonstratethe consistency of using the impulse momentum balanceapproach in solving impact problems in finite dimensionalflexible body applications.     

UV protection filters by dielectric multilayer thin films on Glass BK-7 and Infrasil 301

The increasing use of Ultraviolet (UV) light in medicine, industrial environments, for cosmetic use, and even in consumer products necessitates that greater attention be paid to the potential hazards of this type of electromagnetic radiation. To avoid any adverse effects of exposure to this type of radiation, four suitable protection filters were produced to block three UV bands (UVA, UVB, and UVC). The design structure of the required dielectric multilayer filters was done by optical thin film technology using the absorbing property of UV radiation for the substrates and dielectric materials. The computer analyses of the multilayer filter formulas were prepared using Macleod Software for the production processes. The deposition technique was achieved on optical substrates (Glass BK-7 and Infrasil 301) by dielectric material combinations including Titanium dioxide (Ti₂O₃), Hafnium dioxide (HfO₂), and Lima (mixture of oxides SiO₂/Al₂O₃); deposition being achieved using an electron beam gun. The output results of the theoretical and experimental transmittance values for spectral band from 200 nm to 800 nm were discussed in four processes. To analyze the suitability for use in ‘real world’ applications, the test pieces were subjected to the durability tests (adhesion, abrasion resistance, and humidity) according to Military Standard MIL-C-675C and MIL-C-48497A.