Zeeman transitions in deuterium atoms induced by ultra-relativistic electrons

We present data showing hyperfine transitions in an atomic deuterium beam induced by the (476 MHz) radio-frequency field of a 704 MeV electron beam in a storage ring. A polarized deuterium beam, produced in an atomic beam source, was crossed with a stored electron beam and analyzed with a Breit--Rabi polarimeter. Electron-beam induced transitions were singled out by injecting different combinations of hyperfine states. Transition probabilities as high as 70% were measured at large currents (~ 100 mA). All possible deuterium transitions for a radio-frequency of 476 MHz were observed. In addition, a 1--6 transition resulting from the first harmonic (952 MHz) was observed. The effects of these transitions are of general importance for the polarized internal target technique applied in nuclear and particle physics experiments. The data are reasonably described by numerical estimates. The observed mechanism can be exploited to create nuclear polarized atoms when injecting electron polarized atoms with no net nuclear polarization into a storage cell. However, when nuclear polarized atoms are injected, care should be taken to avoid this mechanism, since it would result in depolarization of the atoms. The studies enabled us to choose the magnetic guide field during our spin-dependent electron--deuteron scattering experiments, such that electron-beam induced depolarizing effects were avoided. This revised version was published online in July 2006 with corrections to the Cover Date.     

Radical copolymerization of 2‐trifluoromethylacrylic monomers. II. Kinetics,monomer reactivities,and penultimate effect in their copolymerization with norbornenes and vinyl ethers

Radical copolymerizations of electron‐deficient 2‐trifluoromethylacrylic (TFMA) monomers, such as 2‐trifluoromethylacrylic acid and t‐butyl 2‐trifluoromethylacrylate (TBTFMA), with electron‐rich norbornene derivatives and vinyl ethers with 2,2′‐azobisisobutyronitrile as the initiator were investigated in detail through the analysis of the kinetics in situ with ¹H NMR and through the determination of the monomer reactivity ratios. The norbornene derivatives used in this study included bicyclo[2.2.1]hept‐2‐ene (norbornene) and 5‐(2‐trifluoromethyl‐1,1,1‐trifluoro‐2‐hydroxylpropyl)‐2‐norbornene. The vinyl ether monomers were ethyl vinyl ether, t‐butyl vinyl ether, and 3,4‐dihydro‐2‐H‐pyran. Vinylene carbonate was found to copolymerize with TBTFMA. Although none of the monomers underwent radical homopolymerization under normal conditions, they copolymerized readily, producing a copolymer containing 60–70 mol % TFMA. The copolymerization of the TFMA monomer with norbornenes and vinyl ethers deviated from the terminal model and could be described by the penultimate model. The copolymers of TFMA reported in this article were evaluated as chemical amplification resist polymers for the emerging field of 157‐nm lithography. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 1478–1505, 2004     

AFM, SEM and GIXRD studies of thin films of red polycarbazolyldiacetylenes

In this paper we report the results of a morphological and structural investigation on film properties of a soluble polydiacetylene, the poly[1,6-bis(3,6-dihexadecyl-N-carbazolyl)-2,4-hexadiyne] (polyDCHD-HS). The red films of this polymer, prepared by standard spin-coating techniques, revealed absence of linear dichroism and birefringence in contrast with the ordered mesophases detected by powder X-ray studies. In order to interpret the optical behavior of this polymer, we performed AFM and SEM studies of polyDCHD-HS films spun on hydrophylic and hydrophobic glass substrates. We found the presence of surfaces organized in rod-like particles, more regularly oriented on the hydrophylic substrate. GIXRD studies, carried out on films sufficiently thick to allow the observation of the diffraction pattern, reveled the presence of a lamellar structure with a spacing of 3.22 nm. The low intensity of the diffraction peaks and the isotropic linear optical properties of the films show that the lamellar mesophases are not extended over large areas. These findings were compared with the data obtained from AFM and SEM studies on films of two other polydiacetylenes, the poly[1-(3,6-dihexadexyl-N-carbazolyl)-6-(N-carbazolyl)-2,4-hexadyine] (polya-DCHD) and the poly[1,6-bis(3,6-dipalmitoyl-N-carbazolyl)-2,4-hexadyine] (polyDPCHD), spun on hydrophylic glass substrate. The results confirmed the presence of nodular morphologies which seem to be a general characteristic of this class of materials. The particles organization appears instead related to the chemical nature of the substituents on the carbazolyl rings.     

高能闪光照相对电子束参数的要求

对高能闪光机光源性能用Monte-Carlo方法模拟研究发现：并非击靶电子束半径越小、发射度越低, 闪光机的照相性能就会越好. 研究结果表明：为了使闪光照相图像视面上照射量分布比较均匀, 对束半径与电子束归一发射度有一个联合限制, 对于20MeV闪光机, 如果击靶电子束有效半径是0.12cm, 那么仅当束归一发射度≥550cm.mrad时,在2°内的照射量不均匀性才小于5%.     

The Nature of Electronic Charge

Advances in gauge theories and unified theories have not thrown light on the meaning of electron. The problem of the origin of electronic charge is made precise, new insights gained from Weyl space are summarized, and the origin of charge in terms of fractional spin is suggested. A new perspective on the abelian Chern-Simons theory is presented to explain charge.     

Slow positron beam study of corrosion-related defects in pure iron

Corrosion-related defects of pure iron were investigated by measuring Doppler broadening energy spectra (DBES) of positron annihilation and positron annihilation lifetime (PAL). Defect profiles of the S-parameter from DBES as a function of positron incident energy up to 30 keV (i.e. ∼1 μm depth) were analyzed. The DBES data show that S-parameter increases as a function of positron incident energy (mean depth) after corrosion, and the increase in the S-parameter is larger near the surface than in the bulk due to corrosion. Furthermore, information on defect size from PAL data as a function of positron incident energy up to 10 keV (i.e. ∼0.2 μm depth) was analyzed. In the two-state trapping model, the lifetime τ₂ = 500 ps is ascribed to annihilation of positrons in voids with a size of the order of nanometer. τ₁, which decreases with depth from the surface to the bulk, is ascribed to the annihilation of positrons in dislocations and three-dimensional vacancy clusters. The corroded samples show a significant increase in τ₁ and the intensity I₂, and near the surface the corroded iron introduces both voids and large-size three-dimensional vacancy clusters. The size of vacancy clusters decreases with depth.     

Surface reconstructions of InGaAs alloys

The surface reconstructions of In_xGa_1−xAs alloys grown by molecular beam epitaxy on the (0 0 1) surfaces of GaAs and InAs have been studied by reflection high-energy electron diffraction and scanning tunnelling microscopy. A surface phase diagram is presented for the nominally strain-free alloy as a function of substrate temperature and alloy composition, and structural models for the commonly observed 3× reconstructions are discussed. Two new, electronically stable structural models are described that account for the transition of the In_xGa_1−xAs surface alloy from a c(4 × 4) to an asymmetric 3× reconstruction and that are fully consistent with all current experimental evidence.     

An efficient calculation algorithm for focusing by plane ultrasonic transducers

In the present paper, we simulate focused wave fields generated by a system of plane transducers used in an immersion ultrasonic technique. The ultrasonic beam penetrates into the elastic medium through the fluid-solid boundary. A real-time computer algorithm is proposed to calculate stress components in the solid medium. It is shown that a good focusing wave structure can be provided by a pair of plane rectangular transducers, inclined with respect to each other and to the beam acoustic axis.     

光束偏转法自动测试激光等离子体冲击波系统的研制

根据光束偏转原理，研制了激光等离子体冲击波自动测试系统的硬件和软件。该系统使用计算机与可编程序控制器作为上下位机，采取上下位机通讯的方式控制步进电机及二维移动架的移动，以改变探测光的相对位置，并利用单模光纤和光电倍增管将探测到的光偏转信号传入数字示波器进行存储，最后计算机将示波器中采集到的光偏转信号进行分析处理。使用该系统对激光等离子冲击波的衰减过程进行了实际测试，得到了较为理想的实验结果。     

The origin of the formation of cavities in galvanized coatings

The role of water‐soluble corrosion products on galvanized wires was examined. The samples used were industrial hot‐dip galvanized wires, which were exposed to the open air under all weather conditions for a relatively short time (6 and 12 months), in an urban environment close to the sea. The samples were studied by different methods, i.e. scanning electron microscopy (SEM), transmission electron microscopy (TEM), X‐ray diffraction (XRD) and optical microscopy (OM). Several phases were detected because of the galvanization procedure and the steel substrate. Furthermore, phases which were formed as a result of the reaction of zinc with the atmosphere were also detected. These were oxides like ZnO, carbonates like ZnCO₃ and hydrated Zn and Fe sulfates. Their presence influences the corrosion resistance of the wires, which finally, strongly depends on the solubility of the wires in water. The SO₄^2? compounds especially are very soluble and consequently are easily removed from the coating surface, leading to its degradation by the formation of cavities. In any case, their presence, even after a short period of exposure, implies that the coating is highly affected by the atmosphere of the modern city. Copyright © 2006 John Wiley & Sons, Ltd.