脉冲成形网络参数对轨道型电磁驱动系统效率的影响

针对分布馈电式(DES)轨道型电磁驱动系统,建立了基于PSpice的电路模型;采用最常见的电容储能方式构成脉冲成形网络(PFN);负载模型充分考虑电枢运动时的滑动摩擦,以及导轨电感、电阻等非线性因素。由仿真结果得到的电流值可以计算出电枢所承受的电磁力,从而得到电枢的加速度、速度,以及动能。分别选取不同电容器组的电容量或初始电压,脉冲成形电感器的电感量,主放电开关的闭合时间间隔,以及PFN模块参数(包括模块的数量、结构等),进行仿真分析,得出在各种参数下的系统效率,并加以比较,确定了几种可以有效提高轨道型电磁驱动系统效率的方法或者最优化的参数。仿真结果表明:在电枢质量与加速距离不变的条件下,电容器组的电容量或初始电压越高,电枢初速度越大,而系统效率随着电压的升高先增大后减小;脉冲成形电感器的电感量越大,电感器中的剩余能量越大,系统效率越低;主放电开关的闭合时间间隔越短,系统的效率越高;在初始能量一定的前提下,电源的模块数越多,电枢的出膛速度越大,系统效率也越高,可以通过采用多组小电容值的电容,来提高系统的效率;优化的PFN模块参数设计能够提高系统的效率。     

等离子体微带开关特性

 提出一种基于微放电等离子体的微带开关。它是以“时变等离子体”取代微带线射频微机电开关的“金属悬臂”,利用等离子体的导体或介质特性使电磁波沿其表面进行传输或截止,从而实现微带线上电磁波传输的动态控制。等离子体微带开关的基本结构包括用以隔断电磁波的微带间隙和产生片状等离子体的放电装置。放电产生时,电磁波因等离子体导体性通过开关,形成“开”状态;放电停止后,电磁波被微带间隙反射,形成“关”状态。利用CST软件仿真研究了等离子体开关特性,结果表明：这种开关的带宽由等离子体密度决定,隔离度由间隙决定,而工作插损与等离子体密度和电子碰撞频率有关。等离子体位形（宽度、厚度等）对于开关性能也非常重要。     

利用积分方程法的各向异性地层频率测深三维模拟

应用一种新的积分方程算法对各向异性地层频率域电磁测深三维问题进行正演模拟.利用范数小于或等于1的修正Green算子得到各向异性地层中的新积分方程,由于满足压缩映射条件,该积分方程在任意参数条件下总是迭代收敛的.提出一种应用迭代法求解新积分方程的迭代初值优化选择方法,并通过具体算例对比说明该方法可使频率域电磁测深三维模拟的计算效率得到有效提高.最后应用所述算法对层状各向异性大地轴向频率测深视电阻率响应进行三维数值模拟,考察分析地层的各向异性对视电阻率响应特征的影响,得到一些重要结论.     

Single π0electro-production in the resonance region with CLAS＊

We report the analysis status of single π0electroproduction in the resonance region to study the electromagnetic excitation of the nucleon resonances. The study is aimed at understanding of the internal structure and dynamics of the nucleon. The experiment was performed using an unpolarized cryogenic hydrogen target and 2.0 and 5.8 GeV polarized electron beam during the ele and e1-6 run periods with CLAS at Jefferson Lab. The new measurements will produce a data base with high statistics and large kinematic coverage for the hadronic invariant mass （W） up to 2.0 CeV in the momentum transfer （Q2） range of 0.3--6.0 GeV2. Preliminary results will be presented and compared with the various model calculations.     

Microwave propagation parameters in magnetic fluids

Complex dielectric permittivity and complex magnetic permeability measurements of two magnetic fluids (as microwave propagation media), in the approximate range 0.2-5GHz were performed. The two samples consisted of magnetite nanoparticles, dispersed in kerosene and in water, respectively. Based on the dielectric and magnetic measurements, the frequency (f ) dependence of the attenuation parameter, , the phase constant, , the propagation constant, , the intrinsic impedance, Z_m, the refractive index, n , the reflection coefficient, R , the wavelength, and the skin depth, , of the investigated samples were determined.     

πg9/2(⊕)vh11/2 doublet bands in A～100 mass region

Using the model with one particle and one hole coupled with a triaxial rotor, the πg(-1)(9/2)(⊕)vh11/2 doublet bands in the A ～ 100 mass region are studied, and compared with the πh11/2(⊕)vh(-1)(11/2) doublet bands.It is found that the calculated results for the configuration of πg(-1)(9/2)(⊕)vh11/2 are very similar the results for a pure h11/2 proton particle and a neutron quasiparticle with λn =ε5. After including the pair correlation, the model describes the candidate chiral doublet bands in 106Rh successfully, which supports the interpretation of chirality geometry.     

Preliminary study of a niobium quarter-wave prototype cavity for a heavy-ion superconducting linac

Superconducting quarter-wave resonators,due to their compactness and their convenient shape for tuning and coupling,are very attractive for low-β beam acceleration.In this paper,two types of cavities with different geometry have been numerically simulated the first type with larger capacitive load in the beam line and the second type of lollipop-shape for 100 MHz,β=0.06 beams then the relative electromagnetic parameters and geometric sizes have been compared.It is found that the second type,whose structural design is optimized with the conical stem and shaping drift-tube,can support the better accelerating performance.At the end of the paper,some structural deformation effects on frequency shifts and appropriate solutions have been discussed.     

斜入射脉冲X射线产生电流实验

针对斜入射脉冲X射线与金属的几种可能相互作用机制,设计了实验布局,测量了斜入射X射线在金属靶上产生的脉冲电流,建立了相应的理论模型。结果显示,当X射线入射强度低于105 W/cm2时,以光电效应为主,高于此值时,以热电效应为主导。这表明,X射线加载强度较弱时,电子表现出个体行为,而增大X射线入射强度,电子表现出弱关联集体行为。由此可以预测,超强X射线辐照下,金属表面将出现宏观尺度的电荷密度调制,在退激发过程中,这种调制状态可能以较高的效率辐射定向的微波电磁脉冲。     

The inverse electromagnetic scattering problem by a penetrable cylinder at oblique incidence

In this work, we consider the method of non-linear boundary integral equation for solving numerically the inverse scattering problem of obliquely incident electromagnetic waves by a penetrable homogeneous cylinder in three dimensions. We consider the indirect method and simple representations for the electric and the magnetic fields in order to derive a system of five integral equations, four on the boundary of the cylinder and one on the unit circle where we measure the far-field pattern of the scattered wave. We solve the system iteratively by linearizing only the far-field equation. Numerical results illustrate the feasibility of the proposed scheme.