羰基过渡金属异核原子簇(PPh3)2CuFe2Co(CO)8(μ3-S)和(PPh3)3AuFe2Co(CO)7(μ3-S)的合成与表征

本文利用高压法制备HFe₂Co(CO)₉(μ₃-S),作为原料,经脱质子化作用,再分别与(PPh₃)₂Cu(NO₃)和PPh₃AuCl反应,将Ph₃Cu-或Ph₃Au-联接到原始簇合物的中心骨架上,使簇核扩大,得到了组成为(PPh₃)₂CuFe₂Co(CO)₈(μ₃-S)和(PPh₃)₃AuFe₂Co(CO)₇(μ₃-S)的化合物.文中对此两个新化合物进行了IR,UV,¹H和³¹P NMR.元素分析、熔点测定等性质表征,并对(PPh₃)₂CuFe₂Co(CO)₇(μ₃-S)进行了单晶X-射线衍射分析.两个化合物具有类似的中心骨架,在Fe₂和Co原子三角形的上面和下面分别键联着Cu和S,或Au和S原子,构成了三角双锥结构.其中一个簇合物由二个三苯基膦和八个羰基配位,另一个则由三个三苯基膦和七个羰基配位.     

Synthesis and characterization of some carbazole-based imine polymers

Five imine polymers, all containing 3,6-disubstituted carbazole ring in the main polymer chain, were synthesized by solution polycondensation of 3,6-diformyl (N-hexyl) carbazole with hydrazine, 1,4-diaminobenzene, 4,4′-diaminobiphenyl, 1,5-diaminonaphthalene and 3,6-(N-hexyl) diaminocarbazole. The polymers were analyzed by spectroscopic methods and compared with two imine models.     

Effect of Oxygen Redistribution on the Normal and Superconducting Properties of Yttrium High‐Temperature Superconductors

An anomaly is found in the vicinity of T_max 560$ K on electric resistance versus temperature curves for yttrium hightemperature superconductors of the 123 phase. Xray phase analysis suggests a structural phase transition in the vicinity of T_max due to oxygen redistribution in the mobile sublattice of this compound. Investigation of samples with Y partially replaced by Ca has shown that the structural phase transition does not depend on carrier concentration in the conduction band.     

Liquid crystalline ionomers. II. Main chain liquid crystalline polymers with terminal sulfonate groups

Liquid crystalline ionomers containing sulfonate groups on the terminal unit of the chain were synthesized by an interfacial condensation reaction of 4,4′-dihydroxy-α,α′-dimethyl benzalazine, the monofunctional dye fast yellow (FY), and a 50/50 mixture of sebacoyl and dodecanedioyl dichlorides. The weight-average molecular weights were estimated from inherent viscosity measurements to be between 6000–11,000 and the sodium sulfonate concentrations ranged from 0–18.4 meq/100 g polymer. Elemental analyses, however, indicated much higher molecular weights, which suggested that there was a distribution of chains with one, two, or no FY endgroups. The polymers were semicrystalline and melted at ca. 140°C to form nematic mesophases that were stable over a temperature range of ca. 80°C. They were thermally stable to about 350°C. The ionomeric nature of the polymers was confirmed by the presence of intermolecular associations in nonpolar solvents, as demonstrated by dilute solution viscosity measurements.     

活泼配盐［(μ-RE)(μ-E′)Fe2(CO)6］［Et3NH］［E,E′=S,Se］的亲电反应研究——蝶状Fe2SSe及Fe2Se2簇合物的合成及表征

本文由［(μ-t-BuS)(μ-CO)Fe₂(CO)₆］［Et₃NH］和硒粉形成的［(μ-t-BuS)(μ-Se)Fe₂(CO)₆］［Et₃NH］，分别与溴化苄，二碘甲烷及邻一、间一、对一双(溴甲基)苯反应，合成了蝶状Fe₂SSe单簇物(μ-t-BuS)(μ-PhCH相似文献   

Electric parameters of photosystem II particles — electric light scattering study

Electric light scattering and microelectrophoresis were applied to investigate the electric moments (permanent dipole moment and electric polarizability and electrophoretic mobility of envelope-free chloroplasts and photosystem II (PS II particles. The effect of the removal of the extrinsic polypeptides (18, 24 and 33 kDa) on the electric moments was also studied. A significant difference was observed between the orientation behaviour of chloroplasts and PS II preparations. The data indicate that the permanent and induced dipole moments contribute to the orientation of the PS II particles, whereas chloroplasts possess induced dipole moment only.

NaCl and Tris treatments of PS II preparations influence both the transverse permanent dipole moment and the electric polarizability of PS II particles. The increase in the electrophoretic mobility of PS II particles on removal of the extrinsic proteins corresponds to an increase in the electric polarizability value, demonstrating its interfacial nature.     

表面含磷酸的介孔分子筛P-SBA-15的合成及其性能评价

采用后合成法，将磷酸固载在纯硅介孔分子筛SBA-15表面上。利用X射线衍射（XRD）、红外光谱（IR）、氮气吸附 脱咐法（BET）分析方法表征催化剂的物理性能。结果表明，催化剂P-SBA-15在高温焙烧后保持了稳定的介孔分子筛SBA-15结构，该催化剂的比表面积和孔径分别为605.45m2/g和5.576nm（磷硅摩尔比5%）。选用十一碳烯酸与异丙醇的酯化反应对催化剂P-SBA-15的催化反应性能进行评价，同时与其他几种微孔沸石分子筛催化剂催化性能相比表明，磷酸改性的介孔分子筛P SBA 15是合成十一烯酸异丙酯较为理想的固体酸催化剂，考察了催化剂的稳定性。     

W／O型微乳液活化能和导电机理研究

电导行为是微乳液的重要性质之一。自Lagourette和Lagues发现了W/O型微乳液电导渗透(Percolation)现象后,人们开始了微乳液导电机理的研究。较流行的观点认为,界面层中表面活性剂分子的阴离子在微乳颗粒碰撞时发生跃迁而使W/O型微乳液具有导电性。     

Structure and Electric Conductivity of (La,Sr)(Ga,Mg)O3-α Solid Electrolyte

Electric conductivity, Raman spectra, and thermal expansion of La_0.88Sr_0.12Ga_0.82Mg_0.18O_2.85 solid solution (LSGM1218) based on lanthanum gallate were studied at various temperatures, and Xray phase analysis was performed at room temperature. Dilatometric measurements showed that secondorder phase transitions occur at 775±10$ and 880± 20 K. The transition around 880 K is confirmed by Raman spectra and by a change in the conductivity activation energy in this temperature range. This transition is associated with a symmetry change in the oxygen sublattice.     

Effect of Enzyme Modification of Corn Grits on their Properties as an Adsorbent in a Skarstrom Pressure Swing Cycle Dryer

Corn grits have been tested as a desiccant in a pressure swing adsorption (PSA) system to produce dry air. Two sizes of unmodified corn grits were tested in the PSA system: 2.16 and 0.978 mm in diameter, which dried moist air to dew points of –42°C and –69°C, respectively. A modification technology has been developed for the corn grits that gives an increase in the operational adsorptive capacity in a pressure swing adsorption system, so that they remove as much moisture from air as molecular sieves at the same conditions. After modification, 2.16 mm corn grits dry moist air to a –56°C dew point and the 0.978 mm corn grits dry air to a –80°C dew point. The modification process creates surface modifications on the corn grits apparently making more adsorption sites easily available. The modification procedure increases the specific surface area of the grits and possibly decreases the crystallinity, which would make more hydroxyl groups available for adsorption of water. Possible applications of using corn grits in the pressure swing adsorption system include industrial gas dryers, sorptive cooling air conditioners, and recycling equipment for industrial solvents.