两两序列比对的一种新方法

本文研究DNA的两两序列比时,提出了基于快速沃尔什变换的新方法。经过计算模拟分析可知,比对的时间复杂度和空间复杂度明显降低.     

40,48Ca+90,96Zr融合反应的动力学模型研究

应用改进的量子分子动力学模型,在严格挑选初始核考虑弹靶结构效应的基础上,研究了近垒和垒上融合反应^40,48Ca+^90,96Zr. 研究表明: 4个反应的理论计算截面与实验值很好符合; 丰中子反应⁴⁰Ca+⁹⁶Zr的垒下融合截面比其他3个反应有明显增强的现象.为了理解丰中子反应⁴⁰Ca+⁹⁶Zr与⁴⁰Ca+⁹⁰Zr相比垒下融合截面增强,而Ca+⁹⁶Zr垒下融合截面没有明显增强的原因, 进一步分析了484个反应的融合位垒,中子转移与融合位垒的关系、中子转移与Q值的关系,结果表明: 正反应Q值会引起核子(特别是中子)转移的增强,从而导致动力学融合位垒的下降和垒下融合截面增强.     

Asymptotic properties of constrained Markov Decision Processes

We present in this paper several asymptotic properties of constrained Markov Decision Processes (MDPs) with a countable state space. We treat both the discounted and the expected average cost, with unbounded cost. We are interested in (1) the convergence of finite horizon MDPs to the infinite horizon MDP, (2) convergence of MDPs with a truncated state space to the problem with infinite state space, (3) convergence of MDPs as the discount factor goes to a limit. In all these cases we establish the convergence of optimal values and policies. Moreover, based on the optimal policy for the limiting problem, we construct policies which are almost optimal for the other (approximating) problems. Based on the convergence of MDPs with a truncated state space to the problem with infinite state space, we show that an optimal stationary policy exists such that the number of randomisations it uses is less or equal to the number of constraints plus one. We finally apply the results to a dynamic scheduling problem.This work was partially supported by the Chateaubriand fellowship from the French embassy in Israel and by the European Grant BRA-QMIPS of CEC DG XIII     

钢卷尺刻度在线测量系

本文介绍了一种钢卷尺刻度在线测量系统 ,它采用了高速摄像及计算机数据处理技术 ,文章阐述了系统的非接触动态测量原理 ,描述了光电信号的处理方法 .     

Viscoelasticity and birefringence of polyisoprene

The complex Young's modulus, E^*(ω), and the complex strain-optical coefficient, O^*(ω), which is the ratio of the birefringence to the strain, were measured for polyisoprene (PIP) over a frequency range of 1 ～ 130 Hz and a temperature range of 22 ～ ?100°C. The imaginary part of O^*, O″, was positive at low frequencies and negative at high frequencies. The real part, O′, was always positive and showed a maximum. The complicated behavior of O^* could be understood by the assumption that E^* = E_R^* + E_G^* and O^* = C_RE_R^* + C_GE_G^*, where E_R^* and E_G^* were complex quantities and C_R and C_G were constants. The C_R value, equal to the ordinary stress-optical coefficient measured in the rubbery plateau zone, was 2.0 × 10^?9 Pa^?1. The C_G value, defined as the ratio O″/E″ in the glassy zone, was ?1.1 × 10^?11 Pa^?1. The E_G^*, which was the major component of E^* in the glassy zone, showed almost the same frequency dependence as that of polystyrene and polycarbonate. The E_R^*, which was dominant in the rubbery zone, was described well by the bead-spring theory. The temperature dependence of the E_G^* was stronger than that of the E_R^*. This difference caused the breakdown of the thermorheological simplicity for E^* and O^* around the glass-to-rubber transition zone. © 1995 John Wiley & Sons, Inc.     

Experimental investigation on large deflection response of a frame impacted by a moving body

This paper reports on the experimental investigation of the dynamic large deflection response of a portal frame impacted at its midspan by a body moving at a certain speed. Both the deflection and velocity vs. time curves of the midspan and the dynamic history of a number of desired locations were recorded during the process of response. On the basis of the test data, the momentum and kinetic energy conversion between the frame and the moving body in the impact process are realized, and the occurrence and expansion of plastic regions are described. Investigation results show that the initial collision is approximately ideally inelastic, and that the elastic deformation plays a considerable role in the response though the input energy is much larger than the maximum elastic energy capacity of the beam member; therefore, in a general impact, the energy ratio should not be regarded as a sufficient criterion for a rigid—plastic solution. The ratios of the impulse transferred to and the energy absorbed by the frame in the initial collision to that carried by the moving body before impact is only related to the ratiobetween the equivalent mass of the frame paticipating in the initial collision and the mass of the impacting body, having nothing to do with the impacting velocity to a certain extent.     

从芒果皮中提取果胶的工艺研究

果胶是一种大分子多糖类物质 ,具有良好的胶凝作用 ,用途广泛 ,在国内外市场上的销量很好。 1 990年世界上果胶总产量约 2 5 0 0 0吨 ,而我国 1 990年仅在食品工业上消耗的果胶就达 1 0 0 0吨 ,但国内市场上销售的果胶大部分为进口货[1] 。果胶在我国的生产仍处于开发阶段 ,所以发掘新的提取资源、提高果胶质量、降低果胶生产成本的意义十分重大。目前 ,已有以柑桔皮、向日葵盘、苹果皮、香蕉皮、马铃薯渣为原料提取果胶的研究报道 ,如何从芒果皮中提取果胶却未见报道。芒果在制造罐头和饮料中副产大量下脚料———芒果皮 ,未能得到充分利用…     

PHASE INVERSION AND ITS MECHANICAL MODEL STUDIES FOR THE TWO-PHASE POLYMER BLEND SYSTEMS (Ⅱ)——DYNAMIC VISCOELASTIC RESPONSE

The dynamic viscoelastic response of the two-phase polymer blend systems shows the characteristics of the thermorheologically complex materials. In this paper theoretical equations for describing the dynamic viscoelastic response of such polymer blend systems have been established by means of the mechanical modeling technique. The dynamic viscoelastic response of the blend systems at any blend composition can be predicted theoretically by using the equations established, provided that the dynamic viscoelastic response of the two pure components and the mechanical model parameters are known in advance. Thus, we provide an effective method for studying the dynamic mechanical properties and the molecular relaxation characteristics of the two-phase polymer blend systems.     

Indirect automatic atomic absorption determination of sulphate based on its precipitation with barium

A continuous precipitation flame atomization atomic absorption spectrometric method for the indirect determination of sulphate is proposed. By using a reversed flow-injection configuration for precipitation as barium sulphate, this anion was determined in the range 10–150 g/ml, with a relative standard deviation of 2.6%. The sensitivity was increased by a factor of seven by using a nitrous oxide-acetylene flame to measure barium.     

Genetic engineering to enhance the selectivity of protein separations

The ability to recover and purify natural and recombinant proteins, and the costs of doing so remain a major task in introducing the potential products of biotechnology. The bases for separation range from specific binding onto tailored reagents to solubility and partitioning behavior governed by a mixed bag of size, charge, and hydrophobicity. In most cases, a combination of methods is used in sequence, and improvements in the selectivity at an early stage can enhance the effectiveness of subsequent (and usually more costly) steps. Genetic engineering provides a means of improving the selectivity within the context of existing separation methods. By this strategy, improvements in selectivity are sought by bestowing a distinctive property on the protein of interest. The primary sequence of amino acids is altered, such that the protein can be selectively removed from other components of the multicomponent mixture in which such products are commonly found. In this article, the range of these “distinctive properties” and their pairing with various separation methods will be reviewed. Specific examples from our work, in which a distinctive charge is provided via a polypeptide “purification” fusion tail, will be discussed. Separation methods we have used with these fusion proteins are precipitation, two-phase aqueous extraction, reversed micellar extraction, and ion exchange using both resins and membranes.