双包层椭圆光波导解析解

解析求解了双包层椭圆光纤中的波动方程，得到了模式精确解有模式特征方程。对基模的特征方程进行了数值计算，给出了不同椭圆比下的归一化双折射和模间色散随归一化频率的变化关系曲线，并与高斯近似解的结果进行了比较。     

Spherical dye-doped silica particles

Organic dyes such as water soluble porphyrins were incorporated into monodispersed SiO₂ particles using the sol-gel technique (the Stober synthesis) and their monomeric and dimeric properties were investigated by aiming at the microcavity effect. Doping efficiencies of dyes into SiO₂ particles depended on dye's hydrophilic properties. The doping efficiency of a porphyrin, TTMAPP, decreased with increasing the nominal content in the starting solution and the doping content showed the maximum value of 1.6×10^–5 mol/g SiO₂. With increasing the TTMAPP content, spectra of doped particles were changed from dimeric to monomeric nature; the absorption peak due to dimers disappeared and halfwidth of absorption at Soret band decreased. This unusual change was caused by the decrease of particle sizes by dye doping. The TTMAPP-doped sample having monomeric spectrum showed the fluorescence life time of 8.5 nsec and photochemical hole burning at about 5 K.     

Influence of Particle Morphology and Flow Conditions on the Dispersion Behavior of Fumed Silica in Silicone Polymers

The dispersion behavior of agglomerates of several grades of fumed silica in poly(dimethyl siloxane) liquids has been studied as a function of particle morphology and applied flow conditions. The effects of primary particle size and aggregate density and structure on cohesivity were probed through tensile and shear strength tests on particle compacts. These cohesivity tests indicated that the shear strength of particle compacts was two orders of magnitude higher than the tensile strength at the same overall packing density. Experiments carried out in both steady and time‐varying simple‐shear flows indicate that dispersion occurs through tensile failure. In the steady‐shear experiments,enhanced dispersion was obtained at higher levels of applied stress and, at comparable levels of applied stress, dispersion was found to proceed faster at higher shear rates. Experiments conducted in time‐varying flows further corroborated the results obtained in tensile cohesivity tests. Experiments in which the mean and maximum stresses in the time‐varying flows were matched to the stresses produced in steady shear flows highlight the influence of flow dynamics on dispersion behavior.     

沿非线性界面传输的TM波传播常数的解析解

本文得到了沿一线性介质与非线性介质界面传输的ＴＭ波精确的色散关系和传播常数的解析计算公式，导出了计算非线性介质中传输功率流的积分公式。本文方法计算传播常数及功率流的优点是可不必先知道电场分布。     

Measurements and simulations of particle dispersion in a turbulent flow

A particle imaging technique has been used to collect droplet displacement statistics in a round turbulent jet of air. Droplets are injected on the jet axis, and a laser sheet and position-sensitive photomultiplier tube are used to track their radial displacement and time-of-flight. Dispersion statistics can be computed which are Lagrangian or Eulerian in nature. The experiments have been simulated numerically using a second-order closure scheme for the jet and a stochastic simulation for the particle trajectories. Results are presented for non-vaporizing droplets of sizes from 35 to 160 μm. The simulations have underscored the importance of initial conditions and early droplet displacement history on the droplet trajectory for droplets with large inertia relative to the turbulence. Estimates of initial conditions have been made and their effect on dispersion is quantified.     

Dispersion Characteristics of Waveguide Arrays in Optical Spectrum Analyzers

Formulas for calculating the spectral characteristics of waveguide arrays, which are incorporated into waveguide spectrum analyzers based on planar waveguides, channel waveguides, and fiber optical waveguides, are derived taking into account the contribution of both the waveguide dispersion and the material dispersion to the dispersion factor. These formulas are used to study the dependence of the dispersion factor on the waveguide-system parameters for specific models of waveguide arrays. It is shown that consideration of contributions of the waveguide dispersion and material dispersion can affect profoundly the spectral characteristics of waveguide arrays.     

光双二进制传输系统的性能研究

光双二进制信号的谱宽是传统二进制信号的一半,采用双二进制传输比二进制传输色散限制的中继距离可增加一倍.本文对采用传统光接收机的光双二进制传输系统用MATLAB进行了通信仿真.结果表明:在完全消光条件下,10 Gb/s双二进制信号在常规单模光纤上传输可达160 km,40 Gb/s双二进制信号在非零色散光纤上为30 km,均比二进制增加了一倍;详细考察了消光比对传输的影响,只有消光比大于25 dB时,双二进制相对于二进制传输的优越性才呈现出来.     

Rheological properties of polyacrylates used as synthetic road binders

Most adhesives and binders, including bitumen for asphalt mixture production, are presently produced from petrochemicals after the refining of crude oil. The fact that crude oil reserves are a finite resource means that in the future, it may become necessary to produce these materials from alternative and probably renewable sources. Suitable resources of this kind may include polysaccharides, plant oils and proteins. This paper deals with the synthesis of polymer binders from monomers that could, in future, be derived from renewable resources. These binders consist of polyethyl acrylate (PEA) of different molecular weight, polymethyl acrylate (PMA) and polybutyl acrylate (PBA), which were synthesised from ethyl acrylate, methyl acrylate and butyl acrylate, respectively, by atom transfer radical polymerisation. The rheological properties of these binders were determined by means of oscillatory testing using a dynamic shear rheometer and combinations of stress/strain, temperature and frequency sweeps. The results indicate that PEA can be produced to have rheological properties similar to that of ‘soft’ 100/150 penetration grade bitumen, PMA with similar rheological properties to that of ‘hard’ 10/20 penetration grade bitumen, while PBA, due to its highly viscous nature and low dynamic moduli, cannot be used on its own as a binder. The synthetic polymers were found to be thermo-rheologically simple, and the shift factors, used to produce the dynamic moduli master curves, were found to fit an Arrhenius function.