Characterization of semiconductor laser frequency chirp based on signal distortion in dispersive optical fiber

In the paper, the simple method of laser chirp parameters estimation is presented. It is based on measuring time-domain distortions of chirped signal transmitted through dispersive fiber and finding laser chirp parameters by matching measured distortions to calculated ones. Experiments undertaken with 1.55 μm telecommunication grade distributed feedback (DFB) lasers and standard single-mode fiber are described, together with some practical remarks on measurement setup and main conclusions.     

Measurement of small-signal and large-signal responses of packaged laser modules at high temperature

In this paper, the pulsed injection method is extended to measure the chip temperature of various packaged laser modules, such as the DFB laser modules, the FP laser modules, and the EML laser modules. An optimal injection condition is obtained by investigating the dependence of the lasing wavelength on the width and period of the injection pulse in a relatively wide temperature range. The small-signal frequency responses and large-signal performances of packaged laser modules at different chip temperature are measured. The adiabatic small-signal modulation characteristics of packaged LD are first extracted. In the large-signal measurement, the effects of chip temperature, bias current and driving signal on the performances of the laser modules are discussed. It has been found that the large-signal performances of the EML modules depend on the different red-shift speeds of the DFB and EAM sections as chip temperature varying, and the optimal characteristics may be achieved at higher temperature.     

ECR-SFC轴向注入系统聚束器效率的研究

为了减少目前SFC轴向注入系统中聚束器杂散电场对束流轴向注入效率的影响, 提高新系统中SFC的束流俘获效率, 参考原始设计, 对目前聚束器的电极结构进行了设计改进. 两种情况下的聚束器杂散场对注入效率影响的计算表明, 改进后0B02的聚束效率较目前有较大提高. 同时计算了束流空间电荷效应对聚束效率的影响, 据此对新SFC轴向注入系统中聚束器的位置进行了重新调整.     

Fast Fourier Continuous Cyclic Voltammetry at Gold Ultramicroelectrode in Flowing Solution for Determination of Ultra Trace Amounts of Penicillin G

In this work, for the first time a fast continuous cyclic voltammetry was used as a highly sensitive detection method for Penicillin G in a flow‐injection system. A special computer‐based numerical calculation method (using Fast Fourier Transformation) is introduced here for enhancing the analyte signal and noise reduction. During the measurements, the potential waveform (consists of potential steps for cleaning, stripping and potential ramp) was continuously applied on an Au disk microelectrode (with a radius 12.5 μm in radius). The stripping time was less than 200 ms. Effects of rest potential, sweep rate, and delay time on the sensitivity of the method were investigated. The limit of detection of the method was 1.0 × 10^?11 M. The detection limit of the method is 660 times lower than the most sensitive reported method. The relative standard deviation of the method at 1.0×10^?7 M of Penicillin G was 2.7% for 10 runs.     

锥体棱镜的加工

本文简单地叙述了锥体棱镜两种加工工艺。重点介绍直接成型法加工中对角度误差~1″的控制。并提出了角度超差零件返修时的光胶方法。     

断续喷洒去溶电热雾化法在电感耦合等离子体原子发射光谱方法中的应用研究

本文所讨论的电热雾化法是采用继续喷洒去溶技术,使试样在石墨炉表面逐步积累的进样方法。文章简要介绍了实验条件的选择和控制以及石墨炉装置的结构,探讨了提高电热雾化法相对检测能力的途径。实验结果表明:谱线黑度值与试样积累时间的对数值之间具有较好的线性关系。     

流动注射-氢化物发生-原子吸收光谱法测定雪中的微量铅

建立了测定雪中微量铅的流动注射-氢化物发生-原子吸收光谱法。在优化条件下。测定铅的线性范围为0～52．0ng／mL，线性回归方程为A=0．018c 0．016，相关系数r=0．9995，检出限为0．2ng／mL。用于雪中微量铅的测定，加标回收率为94．2％～107．3％，相对标准偏差为1．47％～3．22％。该方法的测定结果与标准加入法基本一致。     

Novel flow injection-fluorometric method for the determination of trace silicate and its application to ultrapurified water analysis

A highly sensitive fluorescence quenching method for the determination of silicate based on the formation of an ion associate between molybdosilicate and Rhodamine B (RB) in nitric acid medium was developed. A flow injection system coupled with a fluorescence detector was used for the measurement of fluorescence intensity at 560 and 580 nm as excitation and emission wavelengths, respectively. The calibration graph for Si showed a linear range of 0.1–5 ng cm⁻³ with correlation coefficient of 0.9999, and the detection limit of 0.06 ng cm⁻³. The proposed method was successfully applied to the determination of silicate in ultrapurified water with satisfactory results.     

流动注入吸附溶出—催化极谱氢波分析痕量铂

本文叙述一种流动注入吸附溶出一催化极谱测定痕量铂的新技术,它集中了溶出法、催化波和流动注入的优点,达到非常高的灵敏度和分析速度。实验给出了最佳载液组成、流速、注入体积、吸附富集电位和吸附时间等因素。本方法成功地进行了多种铂络合物、矿样和生物样品分析。