利用压电频移法测定水中的痕量亚硝酸盐

提出了利用压电频移法测定亚硝酸盐的方法。方法以碘离子与亚硝酸根之间的氧化还原反应为依据，通过测定由反应生成的碘所引起的压电晶体频率的变化，在被萃取水相中亚硝酸盐浓度为０．００９￣２．３ｍｇ／Ｌ范围内，频移值与浓度成正比：ΔＦ＝５．８＋２．５×１０＾３Ｃ（ｍｇ／Ｌ），ｒ＝０．９９０１。方法简便，用于天然水中亚硝酸盐的测定，结果令人满意。     

Hypercoulometric effect in an electron capture detector polarized with an additional voltage

Summary This paper reports measurements of the current characteristics and of the signal corresponding to a constant concentration of Freon F-11 for an electron-capture detector, supplied with a pulse voltage with a changeable pulse duration, amplitude and repetition time. It was found that an additional voltage applied to the detector cathode increased the detector signal by about 50% and that the maximal signal was observed at 5 V. The influence of the polarized voltage on the electron caputure efficiency coefficient (p) measured with two detectors in series was demonstrated and the reliability of the sample mass calculation by means of (p) is discussed.     

Voltammetric Detector for Liquid Chromatography: Determination of Triclosan in Rabbit Urine and Serum

A flow-electrolytic cell containing a strand of carbon fibers has been designed and characterized for use in a voltammetric detector for high-performance liquid chromatography. The detector was used for determination of triclosan (2,4,4-trichloro-2-hydroxydiphenyl ether) in rabbit serum and urine. Analysis of rabbit serum and urine 1 day and 1 to 5 days, respectively, after ingestion of oral triclosan revealed that the concentration of triclosan was higher than for control serum and urine. The concentration reached maximum levels after 6 h and 34 h or 44 h in serum and urine, respectively. When triclosan was determined in rabbit samples with the method proposed the results obtained were comparable with those obtained by high-performance liquid chromatography with ultraviolet detection.     

Highly sensitive determination of haloperidol in human serum by capillary gas chromatography using a surface ionization detector

A method has been developed for highly sensitive determination of haloperidol in human serum involving a simple extraction procedure followed by gas chromatographic separation. Target components were separated from the extracting solvents with a Van den Berg type solventless sample injector before introduction Into a DB-1 capillary separation column. A surface ionization detector (SID), which has highly selective sensitivity for Substituted amines, was employed for quantitation using bromperidol as an internal standard. Chloroform proved to be the best extracting solvent, yielding a quantitative detection limit of 5 ng/ml (S/N = 2). Comparison of the response to target compounds obtained by the SID, FTD (flame thermionic detector), and FID (flame ionization detector) showed the SID to be superior.     

Light-emitting diode-induced fluorescence detection of native proteins in capillary electrophoresis

A continuous-wave 280 nm light-emitting diode (LED) was used as the excitation source for native fluorescence detection of proteins in CE. The operating current and temperature of the LED were optimized in order to achieve high luminescence power. It was found that a forward current of 30 mA and a temperature of approximately 5 degrees C gave the best S/N. By using a set of two ball lenses to focus light from the LED, we achieved a spot of approximately 200 mum with a power of 0.1-0.2 mW on the detection window. Fluorescence was collected with a ball lens at 90 degrees angle through a bandpass filter onto a photomultiplier tube. In CZE an LOD of 20 nM for conalbumin was reached. In capillary gel electrophoresis all eight proteins from a commercial standard kit were detected with high S/N. For a 10 microg/mL total protein mixture, S/N was better than 3 for all proteins in solution. Further improvement in LOD should be possible on utilization of an LED with higher luminescence power.     

Luminol chemiluminescence HPLC reaction detector for amino acids and other ligands

A detector for HPLC is based on suppression of chemiluminescence from the Cu(II)-luminol-peroxide reaction. Analytes which complex Cu(II) reduce the free Cu(II) concentration and thus the observed chemiluminescence intensity. The degree of chemiluminescence suppression is a measure of the analyte concentrations. Detection limits are in the range of 1 pmole-1 nmole for amino acids (both primary and secondary without derivatization), CN^–, amines, catecholamines, catechol, and aminoglycoside antibiotics. The detection approach is demonstrated with an ion-exchange separation of amino acids, a reverse phase separation of catecholamines, and an ion-pair separation of the three components of gentamicin C in commercial gentamicin sulfate.     

Fused silica capillary tube isotachophoresis using a multichannel photodiode array detector

Isotachophoresis carried out in a 0.25 mm i.d. fused-silica capillary tube yielded high resolution, compared with that in a fluorinated ethylene-propylene polymer tube. The use of an ultraviolet-visible multichannel spectrophotometer with photodiode array as detector together with a cross flow cell (volume 0.01 μl) was investigated. The system was successfully applied to the analysis of cationic dyes such as neutral red, bismarck brown, and basic fuchsine.     

A novel oligothiophene derivative as a hole‐transport with emitting material for OLED

A novel oligothiophene derivative containing the triphenylamine moiety with high glass transition temperature (T_g; 135 °C), 5,5′‐{bis[4‐di(4‐thiophenyl)amino]phenyl}‐2,2′‐bithiophene (TTPA‐dimer) was synthesized by the dimerization of tris[4‐(2‐thienyl)phenyl]amine (TTPA) with a palladium catalysis. Some types of electroluminescent (EL) devices that use the amorphous material for a hole‐ and an electron‐transporting with an emitting layer were fabricated. These devices emitted a bright green‐yellowish light (λ_emi; around 510 nm) with a small full width at half maximum (FWHM) rather than that of Alq₃. The single layer EL device showed a maximum luminance of 221 cd/m² at 8 V (0.06 lm/W at 100 cd/m²). On the other hand, the double layer (TTPA‐dimer/Alq₃) EL device that used Alq₃ as the electron transport material was increased up to 10830 cd/m² at 12 V (0.89 lm/W at 300 cd/m²) and with a lower turn‐on voltage (3.2 V at 0.1 cd/m²) than other types of EL devices. Copyright © 2003 John Wiley & Sons, Ltd.     

Electrochemical detector with a 20 nl volume for micro-columns liquid chromatography

Summary A flow-through two electrode wall-jet cell with a platinum measuring electrode and a cell volume of 20 nl has been designed and evaluated. It has been used to detect phenols by reversed phase liquid chromatography using short micro bore columns. The linear dynamic range between the measured current and the concentration is greater than 10³ (1.5×10^–7–5×10^–4 mol/l) and the minimum analyzable amount was found to be 10 pg for pyrocatechol. A negligible broadening in the detector permits the use of micro columns down to 0.5 mm internal diameter, packed with 5 m particles, without any substantial distortion of eluted zones.Presented at the 14th International Symposium on Chromatography London, September, 1982     

微流控芯片化学发光检测系统研究

在微流控芯片上实现了鲁米诺-过氧化氢-Co2+化学发光反应及分析应用研究。探讨了分离电压对电泳图谱的影响,发现在选定实验条件下,Co2+检出限可达到2.0×10-6mol/L;并且在微流控芯片上实现了Co2+与Cu2+的快速分离及检测。