Distribution of melamine in polyester–melamine surface coatings cured under nonisothermal conditions

The influence of experimental cure parameters on the diffusion of reactive species in polyester–melamine thermoset coatings during curing has been investigated with X‐ray photoelectron spectroscopy and attenuated total reflectance Fourier transform infrared. The diffusion of melamine plays a vital role in the curing process and, therefore, in the ultimate properties of coatings. At a low (<20%) hexamethoxymethylmelamine (HMMM) crosslinker concentration, the matrix composition is uniform, but at high HMMM concentrations, excess HMMM rapidly segregates to the air–coating interface. The rate of migration is governed by the difference in the surface free energies of polyester and HMMM and the concentration gradient of HMMM between the bulk and the surface. An increased rate of energy absorption also increases the rate of migration of HMMM to the surface. A physical model has been proposed to explain this surface segregation phenomenon in terms of cocondensation and self‐condensation reactions. It suggests that an appropriate amount of melamine can be segregated on the surface and allowed to self‐condense to form a desired thickness of a melamine topcoat through the control of the binder composition and cure conditions. This technique can be implemented to apply a melamine topcoat during cure. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 83–91, 2004     

Properties of polystyrene-poly(methylmethacrylate) random and diblock copolymers in dilute and semidilute solutions

Solution properties for random and diblock copolymers of polystyrene (PS) and poly(methyl methacrylate) (PMMA) have been measured by dynamic and total intensity light scattering in solvents of differing quality. The results are compared with the corresponding properties for PS and PMMA homopolymers of similar molecular weight, in order to determine if interactions between unlike monomers are significant. The hydrodynamic radius (R_h) and diffusion second virial coefficient (k_d) for the random copolymer are found to be larger than the corresponding values for the homopolymers in a solvent which is near-theta for the two homopolymers, whereas no such effect is observed for the block copolymer. This suggests that most intrachain interactions occur a relatively short distance along the chain backbone. In a mutual good solvent R_h and k_d of the random copolymer are comparable to the average of the values for the homopolymers, indicating that in a good solvent monomer/solvent interactions dominate over monomer/monomer interactions. For an isolated diblock copolymer in a mutual good solvent, there is no evidence that interactions between unlike monomers lead to additional expansion of the entire molecule, as measured by R_h, nor expansion of the individual blocks as probed by light scattering with one block optically masked. However, at low but finite concentration there is evidence (the coefficients of the binary interaction terms in the viscosity and the mutual diffusion coefficient, and the second and third virial coefficients) that a weak ordering effect may exist in block copolymer solutions, far from the conditions where microphase separation occurs. Finally, measurements of ternary polymer-polymer-solvent solutions show no dependence on monomer composition or monomer distribution for the tracer diffusion of probe PS-PMMA copolymers in a PMMA/toluene matrix. This indicate that the frictional interaction is largely unaffected by interactions between unlike monomers. However, there is evidence that the thermodynamic interaction is more unfavorable between a random copolymer and the homopolymer matrix than between a diblock and the matrix. © 1994 John Wiley & Sons, Inc.     

Influence of concentration on the activation energy for diffusion in polymer-solvent systems

The self-diffusion of benzene, toluene, and ethylbenzene in polystyrene have been analyzed using the Vrentas/Duda free-volume diffusion model. Diffusion coefficient predictions suggest an exponential concentration dependence of the activation energy required to overcome attractive forces, E. Without the use of any diffusion data approximating E as zero over the entire concentration range yields self-diffusion coefficient predictions which are in good agreement with experimental data. © 1992 John Wiley & Sons, Inc.     

Equation of convective diffusion of a multicomponent mixture in a capillary for an arbitrary velocity field

It is shown that the convective transport in a binary mixture in the presence of vortex convection can be described in terms of Fick’s law with an effective diffusion coefficient independent of the concentration. The form of the effective diffusion coefficient is found for arbitrary convection in the mixture. A generalization of the Stefan-Maxwell diffusion equation is proposed to include an arbitrary rotational mixture velocity field. The characteristics of convective transport are considered with reference to a three-component mixture. A solution of the equation of three-component mixture transport through a long capillary in the presence of convection homogeneous along the capillary axis is presented. It is established that for sharply different component diffusion coefficients a mixture density extremum may appear inside the capillary and then change or disappear depending on the convective flow intensity.     

离子束引起的在Al／Cr双层薄膜界面处的原子混合

用600keV的Kr~ 离子轰击Al/Cr双层薄膜样品进行界面原子反应及相互混合的研究。实验样品是在单晶硅上蒸镀约500nm厚的铝膜,相继再蒸上所需厚度的铬膜而制成的。轰击剂量为2.0×10~(15)-2.5×10~(16)Kr~ /cm~2。用2.0MeVa粒子对轰击前后的样品进行了卢瑟福背散射(RBS)分析,发现界面处有明显的原子混合存在;当轰击剂量≥1.0×10~(16)Kr~ /cm~2时,RBS谱出现有明显的坪台,经拟合计算和x射线衍射(XRD)测量证实确有化合物Al_(13)Cr_2存在;还分别得到了原子混合量及混合效率与轰击剂量的关系;最后对界面处的原子混合机制进行了讨论。     

PERSISTENCE AND GLOBAL STABILITY FOR TWO-SPECIES NONAUTONOMOUS PREDATOR-PREY SYSTEM WITH DIFFUSION AND TIME DELAY

In this paper, a non-autonomous predator-prey model with diffusion andcontinuous time delay is studied, where the prey can diffuse between two pat-ches of a heterogeneous environment with barriers between patches, but for thepredator, the diffusion does not involve a barrier between patches, further itis assumed that all the parameters are time-dependent. It is shown that thesystem can be made persistent under some appropriate conditions. Moreover,sufficient conditions that guarantee the existence of a unique periodic solutionwhich is globally asymptotic stable are derived.     

Synthesis and copolymerization of new phosphorus‐containing acrylates

Two phosphorus‐containing acrylate monomers were synthesized from the reaction of ethyl α‐chloromethyl acrylate and t‐butyl α‐bromomethyl acrylate with triethyl phosphite. The selective hydrolysis of the ethyl ester monomer with trimethylsilyl bromide (TMSBr) gave a phosphonic acid monomer. The attempted bulk polymerizations of the monomers at 57–60 °C with 2,2′‐azobisisobutyronitrile (AIBN) were unsuccessful; however, the monomers were copolymerized with methyl methacrylate (MMA) in bulk at 60 °C with AIBN. The resulting copolymers produced chars on burning, showing potential as flame‐retardant materials. Additionally, α‐(chloromethyl)acryloyl chloride (CMAC) was reacted with diethyl (hydroxymethyl)phosphonate to obtain a new monomer with identical ester and ether moieties. This monomer was hydrolyzed with TMSBr, homopolymerized, and copolymerized with MMA. The thermal stabilities of the copolymers increased with increasing amounts of the phosphonate monomer in the copolymers. A new route to highly reactive phosphorus‐containing acrylate monomers was developed. A new derivative of CMAC with mixed ester and ether groups was synthesized by substitution, first with diethyl (hydroxymethyl)phosphonate and then with sodium acetate. This monomer showed the highest reactivity and gave a crosslinked polymer. The incorporation of an ester group increased the rate of polymerization. The relative reactivities of the synthesized monomers in photopolymerizations were determined and compared with those of the other phosphorous‐containing acrylate monomers. Changing the monomer structure allowed control of the polymerization reactivity so that new phosphorus‐containing polymers with desirable properties could be obtained. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 2207–2217, 2003     

一个反应扩散方程的门槛结果

本文讨论反应扩散方程Ｃａｕｃｈｙ问题解的整体存在性，渐近性质和Ｂｌｏｗｕｐ问题．其中或者１＜ｑ＜ｐ＜＋∞，ｎ＝２．得到门槛结果．     

Domain size equilibration in sphere‐forming block copolymers

The kinetics of domain size equilibration were studied for asymmetric poly(ethylene‐alt‐propylene)‐b‐poly(dimethyl siloxane) (EPDMS) and polyisoprene‐b‐poly(dimethyl siloxane) (IDMS) block copolymers in the body‐centered cubic ordered phase. Small‐angle X‐ray scattering measurements of the principal peak position (q*) were made as a function of time after temperature jumps within the ordered state. The equilibration times were remarkably long, especially on cooling and for temperatures below 100 °C. For example, after a quench to 40 °C, q* for EPDMS had not fully equilibrated even after several weeks of annealing; IDMS required several days to equilibrate at the same temperature. In contrast, a lamella‐forming EPDMS sample was able to adjust q* within the timescale of the measurements (i.e., minutes) with both heating and cooling over the same temperature range. Measurements of tracer diffusion indicated that chain mobility was not the rate‐limiting step, although differences in mobility did account for the differences between EPDMS and IDMS. Rather, the limiting step was the required reduction in the number density of spheres on cooling; the disappearance of spheres, either by evaporation or by fusion, provided a large kinetic barrier. Lamellae, however, could adjust domain dimensions simply by local displacements of individual chains. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 715–724, 2003