Emitting layer analysis of blue thermally activated delayed fluorescence devices using capacitance–voltage method

In this paper, blue thermally activated delayed fluorescence (TADF) organic light-emitting diodes (OLEDs) have been elucidated, with a focus on the degradation characteristics of the emission layer (EML). The operational stability against electrical stress was investigated for two host materials and four doping concentrations, which were used as the EML. The operating stability of the devices was confirmed by comparing the peak capacitance before and after degradation. Devices using bis [2-(diphenyl-phosphino) phenyl] ether oxide (DPEPO) as a host exhibited poor degradation characteristics. However, high stability was confirmed when 3,3-di (9H-carba-zol-9-yl)-biphenyl (mCBP) was used. DPEPO host devices are most resistant against performance degradation when they are doped with 10 wt% 10,10'-(4,4′-sulfonylbis(4,1-phenylene))bis(9,9-dimethyl-9,10-dihydroacridine (DMAC-DPS). We successfully determined the electroluminescence characteristics of the device depending on the host material, as well as the doping concentration, using the capacitance–voltage method.     

基于超声分子束和普通充气的聚变等离子体密度反馈实验研究

本文介绍了全超导托卡马克装置EAST实验中等离子体密度反馈的方法和结果. EAST密度反馈采用普通充气 (gas puffing) 和超声分子束 (supersonic molecule beam injection, SMBI) 在放电过程中反馈进气, 获得稳定、预期的等离子体密度. 典型的一天放电实验中, 每次放电的充气量和壁滞留的变化可分为两个阶段: 第一阶段为初始约20次放电, 该阶段充气量非常高且呈指数趋势下降, 粒子滞留率为80%–90%, 壁滞留迅速上升. 第二阶段为随后的约50次放电, 该阶段充气量较小且保持稳定, 粒子滞留率为50%–70%, 壁滞留缓慢上升. SMBI的加料效率为15%–30%, 延迟时间小于5 ms. 因此使用SMBI 进行密度反馈效果优于gas puffing反馈, 相同条件下前者充气量较后者减少了～ 30%, 壁滞留减少了～ 40%, 再循环系数也相应减少. gas puffing反馈时, 采用脉宽调制模式效果优于脉幅调制模式. SMBI密度反馈可以作为未来EAST长脉冲高参数放电的主要手段之一. 关键词： 密度反馈 超声分子束 再循环 壁滞留     

基于EKF的水下LD通信精对准控制算法

高速激光通信中接收机与光斑中心很难处于精对准状态,导致水下光通信链路难以稳定建立.首先采用蒙特卡洛仿真统计法分析激光光子在海水中传输的接收光强分布规律,再通过实验对接收端的光斑图像进行采样分析,利用曲线拟合得到接收器位置与接收光强的关系.仿真与实验结果表明:光束经过25 m的水下传输,接收光强分布仍近似为高斯分布.采用非线性估计算法(扩展卡尔曼滤波)与基本状态控制反馈理论,根据接收光强度估计接收器当前位置与最大光强处的距离,通过反馈算法实现接收端与光斑中心的主动跟踪对准.算法仿真结果显示,接收端对准误差在2 mm以下,稳定后接收效率超过98%.     

基于器件结构提高TADF-OLED器件的发光性能

为了提高以TADF材料作为主体、天蓝色荧光材料作为客体的混合薄膜的OLED器件光电性能,我们调整了器件结构,使主体材料发挥其优势。制备了基本结构为ITO/NPB(40 nm)/DMAC-DPS∶x%BUBD-1(40 nm)/Bphen(30 nm)/LiF(0.5 nm)/Al的OLED器件。研究了主-客体材料在不同掺杂浓度下的OLED器件的光电特性。为了提高主体材料的利用率,在空穴传输层和发光层之间加入10 nm的DMAC-DPS作为间隔层;然后,在阳极和空穴传输层之间加入HAT-CN作为空穴注入层,形成HAT-CN/NPB结构的PN结,有效降低了器件的启亮电压(2.7 V)。测量了有无HAT-CN的单空穴器件的阻抗谱。结果表明,在最佳掺杂比例(2%)下,器件的外量子效率(EQE)达到4.92%,接近荧光OLED的EQE理论极限值;加入10 nm的DMAC-DPS作为间隔层,使得器件的EQE达到5.37%;HAT-CN/NPB结构的PN结有效地降低了器件的启亮电压(2.7 V),将OLED器件的EQE提高到5.76%;HAT-CN的加入提高了器件的空穴迁移率,降低了单空穴器件的阻抗...     

On singularly perturbed quasilinear systems

In this paper, the objective is to give sufficient conditions for the existence of solution of the nonlinear two-point boundary value problem(1.1). And we employ these results to consider the boundary layer phenomena of the quasilinear weakly coupled singularly perturbed system (DP)_q.     

Formulae of force at a point in the interior of a half space with shear modulus linearly varied with depth

According to a lemma and an assumption, this paper prexenis formulae of force at a point in the interior of a half space with Poisson’s ratio v = constant and shear modulus G linearly varied with depth. These formulae can be used as an approximate basic solution when the integral equation method is employed for the analysis of piles and other geotechnical engineering problems.     

Resonance frequencies and threshold gains of distributed feedback lasers with strong modulations

In this paper the calculation of resonance frequencies and threshold gains of distributed feedback (DFB) lasers with strong modulations is discussed. The theory is based on the Floquet solutions of a complex Hill differential equation. The dispersion relation of the above solutions is shown to be of importance for the behaviour of the resonances of the DFB laser.     

闪耀光栅外腔反馈压窄半导体激光器线宽技术的研究

在讨论半导体激光线宽压窄理论的基础上,利用闪耀光栅作为外部反馈元件,介绍了由中心波长为949.6nm、原始线宽为1.2THz的单管半导体激光器构成的反馈外腔,它能够很好的改善半导体激光器的性能。实验得到了中心波长稳定的、单纵模的高质量激光输出,边模抑制比大于30dB,线宽优于1.2MHz(Δλ<3.6×10-6nm)。实验证实了强反馈能够很好地改善外腔半导体激光器的动态特性。     

Separate Polarization Modes Synchronization and Synchronization Switches between Vertical-Cavity Surface-Emitting Lasers

For vertical-cavity surface-emitting lasers (VCSELs) with polarization-rotated feedback, there exist several synchronization types such as synchronizations between total powers and synchronizations between separate polarization modes. Based on the two-mode rate equations, we study and compare numerically the performances of different synchronization types. Our results show that three synchronization types exhibit good performances when their synchronization conditions are satisfied. They are the complete synchronization between total powers, complete synchronization between x-polarized modes, and generalized synchronization between x-polarized and y-polarized modes. The former two types are sensitive to the injection rate and spontaneous emission, while the third type is contrary. Synchronization type with the best performance may switch from one to another, with changing of injection rate and spontaneous emission factor.     

基于流固耦合作用的分布反馈式光纤激光水听器

为了解决流固耦合模态使水听器工作频带变窄的问题,理论分析了流体对双膜片结构的分布反馈式光纤激光水听器固有频率的影响,基于有限元软件对水听器加固封装前后在空气中和流体中的模态和频响性能进行仿真分析,加工制作了水听器原型样品并开展了水声实验研究.实验结果表明,在2 500~8 000Hz的频率范围内,未经加固封装的水听器由于在该频段内存在多个流固耦合固有频率造成响应曲线起伏较大,而采取了加固措施封装后的水听器获得了-142.77±0.8dB的平均声压灵敏度,验证了流体对水听器频响性能的影响以及改善措施的有效性,实验结果与理论及仿真结果吻合较好.